Open Access. Powered by Scholars. Published by Universities.®
Physical Sciences and Mathematics Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Physical Sciences and Mathematics
Optimizing Solid Thermal Storage In Insulated Solar Electric Cookers, Stefan Avramov
Optimizing Solid Thermal Storage In Insulated Solar Electric Cookers, Stefan Avramov
Physics
Insulated Solar Electric Cookers, more commonly known by their acronym ISECookers, are an alternative to biomass cooking. The ISECooker in its simplest form is a solar panel connected to a heating element, in contact with a cooking pot in an insulated chamber. An aluminum puck can be heated as solid thermal storage (STS) for increased power and night time cooking. Power was limited to about 500 W by the interface between the STS and cookpot. Powdered graphite and silver were separately applied to increase thermal flow. However, the powdered graphite decreased the thermal flow, while powdered silver decreased the temperature …
An Inexpensive Maximum Power Point Tracking System For An Insulated Solar Electric Cooker Using An Off-The-Shelf Buck Converter, Andrew A. Perez
An Inexpensive Maximum Power Point Tracking System For An Insulated Solar Electric Cooker Using An Off-The-Shelf Buck Converter, Andrew A. Perez
Physics
A specialized control circuit using an off-the-shelf buck converter is built for an Insulated Solar Electric Cooker (ISEC). Cost and efficient power delivery are the focus. An ISEC is synonymous to a direct load heat resistor, allowing a specific maximum power point tracking (MPPT) algorithm and fewer components. Only a microcontroller, voltage sensor, and digital-to-analog converter are used with the buck converter to maximize the power delivered by a 100W solar panel for the 3.3Ω load.
Solid Thermal Storage As An Energy Storage Device In Insulated Solar Electric Cookers: Thermal Modeling And Experiment, Michael Antonio Fernandez
Solid Thermal Storage As An Energy Storage Device In Insulated Solar Electric Cookers: Thermal Modeling And Experiment, Michael Antonio Fernandez
Physics
The use of solid thermal storage (STS) as an energy storage device in insulated solar electric cookers (ISEC) was explored using a thermal simulation before retrofitting an existing cooker without energy storage and testing it under several conditions. STS sizing, material selection, and geometry were examined from both theoretical and practical perspectives and re-examined following experimental results. Characterization of the system’s thermal interfaces and methods to improve their thermal conductivities were investigated resulting in several performance enhancements to the system.
Corrosion Prevention, Matthew Walker
Corrosion Prevention, Matthew Walker
Physics
In Insulated Solar Electric Cooking (ISEC), heating is done by passing current through a chain of diodes directly connected to a solar panel (Gius et al, 2019). It is crucially important that the wires remain conducting, but not conduct to any metal surface that might short the heating circuit. Corrosion of any wires will cause a loosening of the mechanical (twisted) wire connection and could result in a loss of electrical connection completely, or undesired increased resistance.
An Investigation Of Diode Failure, Nicholas James Adams
An Investigation Of Diode Failure, Nicholas James Adams
Physics
Solar electricity can be used to cheaply cook food and charge electronic devices. We investigate the viability of using diodes as heating elements for insulated solar electric cooking (ISEC). In addition, information on designing and constructing ISEC compatible phone chargers and rechargeable LED lighting systems is included.