Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 8 of 8

Full-Text Articles in Physical Sciences and Mathematics

Examining The Effects Of Amino And Thiolate Ligands On The Reactivity And Selectivity Of Palladium On Carbon In Hydrogenation Reactions, Eric Liu, Christina Li Aug 2018

Examining The Effects Of Amino And Thiolate Ligands On The Reactivity And Selectivity Of Palladium On Carbon In Hydrogenation Reactions, Eric Liu, Christina Li

The Summer Undergraduate Research Fellowship (SURF) Symposium

Heterogeneous catalysts are used widely by chemical and energy industries because they show high reactivity but often suffer from lack of selectivity. On the other hand, ligands are commonly used in homogeneous catalysts to control the reactivity and selectivity; however, the effects of the ligands on the steric and electronic properties of heterogeneous catalysts are less understood. We examine the effects of four different ligands: 1-adamantanethiol, 1-adamantylamine, 1-dodecanethiol, and 1-dodecylamine, for the commercial hydrogenation catalyst palladium on carbon. Hydrogenation reactions are used as a screening tool to see the behavior that the different catalysts exhibit in the presence of unsaturated …


The Effect Of Semiconductor Materials On Solar Cell Efficiency, Shivam Vohra Jun 2018

The Effect Of Semiconductor Materials On Solar Cell Efficiency, Shivam Vohra

The International Student Science Fair 2018

The purpose of this project was to increase the efficiency of solar cells through the use of quantum dots and nanoparticles. These substances would increase the efficiency of the semiconductor. The research hypothesis stated that if lead iodide was applied to the semiconductor, then the average voltage, amperage, power, and efficiency of the solar cells would increase. The procedure for this project involved creating a lead iodide and titanium dioxide mixture with dimethylformamide, ethanol, acetylacetone, and Triton X-100 in an autoclave. Then, two milliliters of each solution were applied to cadmium selenide quantum dots to make four different solutions. Each …


Feco2o4 As An Anode Material For Lithium Ion Batteries, Chelsea Wong Jun 2018

Feco2o4 As An Anode Material For Lithium Ion Batteries, Chelsea Wong

The International Student Science Fair 2018

Lithium ion batteries (LIBs) are commonly found in many portable electronic appliances due to their ability to be rechargeable. Currently, commercial anodes in Li-ion batteries (graphite) have a theoretical capacity of around 372 mAh/g, while FeCo2O4 that will be investigated as the anode material has a theoretical capacity of 901.985mAh/g, more than double of the current commercial anode’s capacity. Earlier work done by Sharma et al also showed that FeCo2O4 has a very promising initial capacity of 827mAh/g. As such, the engineering goal is to produce a battery that will have a higher capacity than the current commercial Li-ion batteries …


An Entirely New Molecular Glue For Mof Using Unusual Structural Transformation Of A Coordination Polymer, Sukwoo Jung, Hangyeol Kim, Junseok Ahn Jun 2018

An Entirely New Molecular Glue For Mof Using Unusual Structural Transformation Of A Coordination Polymer, Sukwoo Jung, Hangyeol Kim, Junseok Ahn

The International Student Science Fair 2018

In this research, an entirely new molecular glue is reported. This ‘coordination polymer glue’ is synthesized from zinc metal and BDC-NPE(2,5-bis{4-[1-(4-nitrophenyl)ethylamino]butoxy}terephthalic acid). Molecular glue transforms from 1D coordination polymer to a 3D cross-linked framework, resulting in a phase change of solution to solid. The carboxylate group of this glue makes the preformed MOF bind to its framework. Therefore, when the solution of molecular glue is mixed with preformed MOF powder and heated, homogeneous and thin MOF film – MOF/ZnNPE film – is fabricated. The film is irrelevant to the kind of its substrate, and its thermal stability was enhanced in …


Feco2o4 As An Anode Material For Lithium Ion Batteries, Chelsea Wong Jun 2018

Feco2o4 As An Anode Material For Lithium Ion Batteries, Chelsea Wong

The International Student Science Fair 2018

Lithium ion batteries (LIBs) are commonly found in many portable electronic appliances due to their ability to be rechargeable. Currently, commercial anodes in Li-ion batteries (graphite) have a theoretical capacity of around 372 mAh/g, while FeCo2O4 that will be investigated as the anode material has a theoretical capacity of 901.985mAh/g, more than double of the current commercial anode’s capacity. Earlier work done by Sharma et al also showed that FeCo2O4 has a very promising initial capacity of 827mAh/g. As such, the engineering goal is to produce a battery that will have a higher capacity than the current commercial Li-ion batteries …


An Entirely New Molecular Glue For Mof Using Unusual Structural Transformation Of A Coordination Polymer, Sukwoo Jung, Hangyeol Kim, Junseok Ahn Jun 2018

An Entirely New Molecular Glue For Mof Using Unusual Structural Transformation Of A Coordination Polymer, Sukwoo Jung, Hangyeol Kim, Junseok Ahn

The International Student Science Fair 2018

In this research, an entirely new molecular glue is reported. This ‘coordination polymer glue’ is synthesized from zinc metal and BDC-NPE(2,5-bis{4-[1-(4-nitrophenyl)ethylamino]butoxy}terephthalic acid). Molecular glue transforms from 1D coordination polymer to a 3D cross-linked framework, resulting in a phase change of solution to solid. The carboxylate group of this glue makes the preformed MOF bind to its framework. Therefore, when the solution of molecular glue is mixed with preformed MOF powder and heated, homogeneous and thin MOF film – MOF/ZnNPE film – is fabricated. The film is irrelevant to the kind of its substrate, and its thermal stability was enhanced in …


The Effect Of Semiconductor Materials On Solar Cell Efficiency, Shivam Vohra Jun 2018

The Effect Of Semiconductor Materials On Solar Cell Efficiency, Shivam Vohra

The International Student Science Fair 2018

The purpose of this project was to increase the efficiency of solar cells through the use of quantum dots and nanoparticles. These substances would increase the efficiency of the semiconductor. The research hypothesis stated that if lead iodide was applied to the semiconductor, then the average voltage, amperage, power, and efficiency of the solar cells would increase. The procedure for this project involved creating a lead iodide and titanium dioxide mixture with dimethylformamide, ethanol, acetylacetone, and Triton X-100 in an autoclave. Then, two milliliters of each solution were applied to cadmium selenide quantum dots to make four different solutions. Each …


Variable Temperature Thermochromic Switching Under Varying Illumination, Alexis Corbett, Danielle Hall, John E. Sinko Apr 2018

Variable Temperature Thermochromic Switching Under Varying Illumination, Alexis Corbett, Danielle Hall, John E. Sinko

Huskies Showcase

Award for "Runner-Up Poster Presentation".

Abstract

Minnesota is home to some of the greatest temperature ranges in the United States, with lows reaching below -40º Celsius and highs reaching nearly 40ºC. This results in higher than average spending on the heating and cooling of buildings. We have been investigating into responsive building materials to help address this. In particular, we have been studying a thermochromic paint that can capture solar energy and transfer it into the building as heat at low temperatures and reflect the energy at higher temperatures to keep the building cooler.