Open Access. Powered by Scholars. Published by Universities.®
Physical Sciences and Mathematics Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Institution
Articles 1 - 3 of 3
Full-Text Articles in Physical Sciences and Mathematics
Targeting Macrophytes: Increased Water Quality Through Optimized Vegetation Considerations For Constructed Wetlands, Austin Mcbrady
Targeting Macrophytes: Increased Water Quality Through Optimized Vegetation Considerations For Constructed Wetlands, Austin Mcbrady
Masters Theses
This study of constructed wetland design investigated relationships between macrophyte species selection and planting density for water quality improvement. A lab-scale wetland was compared against a pilot-scale wetland in San Antonio, Texas at Mitchell Lake to measure differences in effluent water quality improvement using three native macrophyte species. Using a novel, two-phase method, a targeting macrophyte was identified from among other species based on its marked capability for improving water quality factors, then was planted in varied majority densities to compare differences in treatment effectiveness. The results of this study showed that this complimentary approach to wetland design displayed significant …
Heat Flow In The Southern Margin Of Salar De Atacama: Deep Groundwater Temperature Distributions And The Implications For Subsurface Flow And Land Surface Energy Budgets, Graham Thomas
Masters Theses
Salar de Atacama (SdA) located in Northern Chile is home to one of the planet’s largest salar systems and lithium resources. Managing groundwater resources in salars is not obvious due to the lack of scientific understanding on the connectivity between the freshwater and brine systems. Using heat as a tracer in SdA provides a cost-effective method to further investigate groundwater flow in salars. This study employs 372 temperature-depth profiles from 90 boreholes between 2013-18 to understand the distinct thermal zones and flow between them in SdA. Three thermal zones exist within the southern margin of SdA’s thermal regime, at higher …
Wast3d Potential, Andrew Larsen
Wast3d Potential, Andrew Larsen
Masters Theses
Waste is obsolete. Standard building industry practices are harmful to the environment. Non-traditional construction methods were examined as alternatives. Circular design logic was the guiding principle in material choice. Additive manufacturing is a proven modern method for building construction. Research on 3D printing case studies revealed that recycled plastic is a proven material and readily available. Removing plastic waste from the environment and sequestering it in architectural components gives the material a new purpose. The component of focus was a building block for a wall assembly. Inspiration was taken from the hexagonal Basalt rock formations found near volcanic fault lines. …