Physical Sciences and Mathematics Commons^™

Peer-To-Peer Energy Trading In Smart Residential Environment With User Behavioral Modeling, Ashutosh Timilsina

Theses and Dissertations--Computer Science

Electric power systems are transforming from a centralized unidirectional market to a decentralized open market. With this shift, the end-users have the possibility to actively participate in local energy exchanges, with or without the involvement of the main grid. Rapidly reducing prices for Renewable Energy Technologies (RETs), supported by their ease of installation and operation, with the facilitation of Electric Vehicles (EV) and Smart Grid (SG) technologies to make bidirectional flow of energy possible, has contributed to this changing landscape in the distribution side of the traditional power grid.

Trading energy among users in a decentralized fashion has been referred …

Mathematical Modeling For Platform-Based Product Configuration Considering Total Life-Cycle Sustainability, Tian Lan

Theses and Dissertations--Mechanical Engineering

Many companies are using platform-based product designs to fulfill the requirements of customers while maintaining low cost. However, research that integrates sustainability into platform-based product design is still limited. Considering sustainability during platform-based design process is a challenge because the total life-cycle from pre-manufacturing, manufacturing and use to post-use stages as well as economic, environmental and societal performance in these stages must be considered. In this research, an approach for quantifying sustainability is introduced and a mathematical model is developed for identifying a more sustainable platform. Data from life-cycle assessment is used to quantify environmental factors; criteria from the Product …

Process Control Of Activated Sludge Treatment, Phase Ii, Richard I. Kermode, Robert W. J. Brett, Joseph D. Pault Jr.

KWRRI Research Reports

Material balances on substrate and microorganisms were derived in conjunction with various mixing configurations thought to accurately describe the activated sludge process. These models include the completely mixed with bypass, plug flow, and plug flow with bypass. Two sets of kinetic mechanisms for substrate utilization and bacterial growth were employed.

A feed forward controller was designed from linear approximations of the material balances derived in the completely mixed with bypass mixing model. Utilizing frequency response methods, the controller was found essentially identical to a completely mixed modeled controller developed in a prior investigation.

Through computer simulation the controller's effectiveness was …

Minimum Cost Design Of Water Distribution Systems, Don J. Wood, C. O. Charles

KWRRI Research Reports

The objective of this study was to develop the analytical tools and procedures for minimum cost design of water distribution systems. Both analog and digital means of carrying out pressure and flow calculations were developed. As a result of this effort, digital programs for pressure and flow calculations in water distribution systems were written and have been widely distributed to practicing engineers. One procedure is based on a direct solution of the basic system equations using a linearization scheme and has several advantages over conventional techniques such as the Hardy Cross method. These include avoiding the need to initially balance …

Process Control Of Activated Sludge Treatment, Richard I. Kermode, Robert W. J. Brett, Kenneth A. Debelak, John J. Davis

KWRRI Research Reports

General feed forward controllers, conforming to standard control modes, have been derived for an activated sludge process. The analysis indicated that the appropriate controllers are proportional control with measurement of substrate flow rate, and derivative control with measurement of inlet substrate concentration, and manipulation of the rate of return sludge by both controllers.

The performance of these controllers was tested by computer simulation of five dynamic aerator models with and without sludge storage, and with two settling basin models. In all cases significant reduction of the maximum exit substrate concentration was achieved. Additional improvement resulted from the use of sludge …