Physical Sciences and Mathematics Commons^™

Unmanned Aircraft Systems For Precision Meteorology: An Analysis Of Gnss Position Measurement Error And Embedded Sensor Development, Karla S. Ladino

Theses and Dissertations--Biosystems and Agricultural Engineering

The overarching objective of this research was to enhance our comprehension of the three-dimensional precision of meteorological measurements obtained using small unmanned aircraft systems (UAS). Two complimentary experiments were conducted to achieve this objective.

The first experiment entailed the development and implementation of a system to determine the global navigation satellite system (GNSS) position accuracy on a UAS platform. This system was utilized to assess the static and dynamic accuracy of L1 and L1/L2 GNSS receivers in real-time kinematic (RTK) and non-RTK fix modes. Adjusted two-sample t-tests revealed significant differences in horizontal and vertical error between RTK and non-RTK receivers …

Load Model Verification, Validation And Calibration Framework By Statistical Analysis On Field Data, Xiangqing Jiao, Yuan Liao, Thai Nguyen

Electrical and Computer Engineering Faculty Publications

Accurate load models are critical for power system analysis and operation. A large amount of research work has been done on load modeling. Most of the existing research focuses on developing load models, while little has been done on developing formal load model verification and validation (V&V) methodologies or procedures. Most of the existing load model validation is based on qualitative rather than quantitative analysis. In addition, not all aspects of model V&V problem have been addressed by the existing approaches. To complement the existing methods, this paper proposes a novel load model verification and validation framework that can systematically …

Fourth-Generation Fan Assessment Numeration System (Fans) Design And Performance Specifications, Michael P. Sama, George B. Day, Laura M. Pepple, Richard S. Gates

Biosystems and Agricultural Engineering Faculty Publications

The Fan Assessment Numeration System (FANS) is a measurement device for generating ventilation fan performance curves. Three different-sized FANS currently exist for assessing ventilation fans commonly used in poultry and livestock housing systems. All FANS consist of an array of anemometers inside an aluminum shroud that traverse the inlet or outlet of a ventilation fan. The FANS design has been updated several times since its inception and is currently in its fourth-generation (G4). The current design iteration (FANS-G4) is reported in this article with an emphasis on the hardware and software control, data acquisition systems, and operational reliability. Six FANS-G4 …

Automated Calibration Of Electrochemical Oxygen Sensors For Use In Compost Bedded Pack Barns, John T. Evans, Michael P. Sama, Joseph L. Taraba, George B. Day

Biosystems and Agricultural Engineering Faculty Publications

The objective of this study was to develop an automated calibration process for a galvanic cell type oxygen sensor. The manufacturer recommended a two-point calibration at room temperature; however, testing revealed that the response was not linear when both the temperature and oxygen concentrations varied. Thus, additional points were needed to generate a representative calibration equation and to reduce the sensor prediction interval. The calibration process needed to be capable of automatically recording sensor response (voltage) at an array of temperatures and oxygen concentrations. Calibration gases were used to precisely control the oxygen concentration inside a small manifold, and an …