Physical Sciences and Mathematics Commons^™

Sporomorphs And Palynological Interpretations Of Lower Oligocene Strata From The Eastern Gulf Coast, U.S.A., Lisa M. Reeves

Opportunities for Undergraduate Research Experience Program (OURE)

The Vicksburg Group in the eastern Gulf Coast of the United States belongs to one of the most complete and continuous Paleogene strata in the world. Previous studies in this region have neglected the rich palynomorph assemblages of the Lower Oligocene units of the Vicksburg Group. Four samples from Wayne County Mississippi were analyzed for palynological information on the Vicksburg Group. The initial objective of the study was to understand the principles of palynology and the basis for sporomorph identification. A minimum of 300 specimens were counted per slide to determine the distribution of sporomorphs in the sediments. Two hundred …

Performance Analysis For The Ccn Collection Apparatus, Deborah K. Bircher

Opportunities for Undergraduate Research Experience Program (OURE)

This paper concerns the performance testing of a system to collect and chemically analyze cloud condensation nuclei (CCN). These are the atmospheric particles which nucleate cloud drops.

The air is humidified by passage through the "haze chamber", consisting of parallel vertical plates that are covered with cotton cloth and are kept wet by water supplied at the top edge. The plates are adiabatic , and should equilibrate in temperature at the wet bulb temperature of the incoming air. Measurements of the plate temperature with eighty thermocouples indicate behavior consistent with theory.

Another part of the system is called the CFD …

Motorized Throttle Plate, John D. Crawford

Opportunities for Undergraduate Research Experience Program (OURE)

The objective of this project was to develop a throttle plate mechanism that can be used to simulate transient engine operation. This throttle plate was designed so as to regulate the quantity of air flow entering a Port Fuel Injected (PFI) spark ignition engine prior to the combustion of the fuel-air mixture. The throttle plate is linked to a data acquisition system in order to study the port fuel injection characteristics of the fuel-air mixture. This data acquisition system links the throttle plate angular position information to data obtained using a nonintrusive laser based diagnostic technique, therefore enabling the study …

Active Buckling Control Of Composite Plates, Bradley Wayne Gentelin

Opportunities for Undergraduate Research Experience Program (OURE)

The objective of the research project is to investigate the feasibility of using the rapidly growing technology of smart materials in actively controlling the buckling of laminated composite plates. Advanced composite structures are susceptible to structural instabilities under compression loadings, and the proper control of such instabilities is essential to the effective performance of the structures. The focus of the research activity is to perform an experimental study of using embedded piezoelectric materials for enhancing the critical buckling loads of laminated composite plates. The forces induced by the piezoelectric actuators under the applied voltage fields will be used to counterbalance …

Two Methods For Attenuation Of Vibration In Structures, Kevin Mark Mcclendon

Opportunities for Undergraduate Research Experience Program (OURE)

The purpose of this report is to discuss methods of suppressing vibration in space trusses. The discussion is centered on the approach, structural attributes, and effectiveness of each method. One approach uses structural active members which are actuated to produce “anti-vibration” to cancel vibrations in the truss. The other method is to implement passive and active damping devices at the base of the space truss, where it will absorb vibrations by fluctuating the stiffness of the structures foundation.

Catalysis Of Charcoal Emissions, James M. Horak

Opportunities for Undergraduate Research Experience Program (OURE)

This paper is about the development of a system to reduce the emissions of charcoal kilns with the catalyst from automotive catalytic converters. This device, called the charcoal kiln emissions oxidizer (CKEO), was designed and fabricated to meet the goal of a cost effective means to reduce the carbon monoxide and hydrocarbon emissions from charcoal kilns. Testing of the CKEO was never carried out as a test site could not be secured by this writing. The need for the CKEO, the theory behind it, and a procedure to test it are presented.

Damage Assessment Of Composite Structures With Embedded Optical Fibers, Peter E. Hackett

Opportunities for Undergraduate Research Experience Program (OURE)

One of the important features of smart composite structures is their capability to observe their own performance for proper functioning and self-diagnostic purposes. The low velocity impact damage of composite structures (matrix cracking, fiber breakage, delamination, etc.) is often difficult to detect visually and can significantly reduce the strength of the structure. The objective of this research is to develop a technique for fabricating composite laminates that will facilitate the embedment of optical fibers. Composite test specimens will be fabricated in the composite material laboratory. The fabrication of composite laminates with a health monitoring and damage assessment system capable of …

Model Calculational Approach To The Conformation Of Adsorbed Polypeptide Fragments, Timothy J. Mckeon

Opportunities for Undergraduate Research Experience Program (OURE)

The focus of the paper is to examine possible conformational changes of peptides when placed in the presence of a poly-synthetic material. A major concern in the pharmaceutical industry is the loss of potency of polypeptide drug products during processing, packaging and storage. An example of this is polymer syringes being used in place of glass ones. The effect is that some protien-derived products experience structural changes due to contact with the polymer. This is otherwise known as surface denaturation. In order to understand the energetics of interfacial polypeptide systems, a calculational approach was used via the program Alchemy. The …

Computer Visualization Of Irrotational Flow Over Bluff And Streamlined Bodies, Nora Okong' O

Opportunities for Undergraduate Research Experience Program (OURE)

Computer programs were developed to visualize irrotational flow over bluff bodies (circular cylinders and half-bodies) and streamlined bodies (elliptical cylinders and airfoils). The method of superposition of flows was used, with stream functions or complex velocity potentials for fundamental flows being added to obtain the flows over the bodies. For the flow over the circular cylinders, half-bodies and elliptical cylinders, the stream function was calculated directly. The flow over the airfoil was obtained by Joukowski mapping of the imaginary part of the complex velocity potential for flow over a circular cylinder.

The programs developed will be valuable learning tools for …

Fourier Transform Infrared (Ftir) Spectroscopy Analysis Of Combustion Aerosol, Gary Jacquin

Opportunities for Undergraduate Research Experience Program (OURE)

In conjunction with my co-op program at McDonnell-Douglas, my current OURE project is the analysis of combustion aerosols using Fourier Transform Infrared (FTIR) Spectroscopy. Aerosol science is a very important field as it is concerned with atmospheric chemistry, atmospheric physics, climate, public health, and environmental issues.

In the Cloud and Aerosol Sciences Laboratory (CASL) at UMR, combustion aerosols are generated by an in-house designed torch or burner. The fuels, JP4 and JP5, are provided by McDonnell-Douglas. Some other commercial fuels are also used. The primary objective of my OURE project was to generate and collect combustion aerosols for chemical analysis. …

A Computer Graphics Program For Displaying Water Molecules On A Dn3500 Apollo Workstation, Michael A. Stuller

Opportunities for Undergraduate Research Experience Program (OURE)

A computer graphics program is developed for displaying water molecule configurations on the screen of a DN3500 Apollo workstation. The motivation was to generate a fast display of output from molecular dynamics or Monte Carlo computer simulations. Input to the program consists of a listing of the Cartesian coordinates of the atomic constituents of the molecules. Options in the program include: 1) number of molecules; 2) plot size; 3) atomic radii; 4) superposition of substrate atomic positions; 5) viewing angle; and 6) color-coded and/or numbered atoms. The program is written in Fortran.