Physical Sciences and Mathematics Commons^™

P3ht:Pcpdtbt:Pcbm Multi- Polymer Single Layer Solar Cells, Ted Andreas

Physics

OPV efficiencies are limited by their narrow absorption; rather than using tandem architecture to overcome this obstacle, our group combined P3HT and PCPDTBT into a single layer BHJ solar cell that achieved 2.0% PCE. This is 33% higher than the pure P3HT control from this group, proving that multi-polymer solar cells have the potential to outperform their single-polymer components.

Electric Currents Due To Stress-Activated Positive Hole Charge Carriers In Ice, Cary T. Keller P.E., Friedemann T. Freund, Dale P. Cruikshank

STAR Program Research Presentations

Jupiter’s satellite Europa, whose surface is composed of ice with a possible water ocean beneath, could conceivably serve as an abode for extraterrestrial life. This and other icy celestial bodies may contain organic macromolecular solid material that is produced when surface ices are exposed to ultraviolet radiation and/or electrical energy. Tidal and tectonic stresses or meteorite impacts in icy crusts may produce electrical discharges, which would provide the energy for in-situ synthesis of the organic solids. This electrical energy can be provided by positive hole charge carrier activation. Positive holes exhibit properties such as the ability to flow out of …

Investigation Of Spillover Effect To Enhance Hydrogen Storage, Sarah C. Corrigan, Lin Simpson, Thomas Gennett

STAR Program Research Presentations

Hydrogen is an attractive energy option because of its low
environmental impact, but a critical problem is its low energy
density, which makes it difficult to store. For example, the US
Department of Energy (DOE) hydrogen plan for fuel cell powered
vehicles requires a gravimetric density of 6.5 wt%. There are several
existing hydrogen storage methods, including compressed gas,
liquefaction, metal hydrides, and physisorption, but at present, none
of these technologies comes close to achieving the targets set by the
DOE. Although chemical storage methods have been claimed to be the
most promising hydrogen storage technology, and activated carbons the …

Telescope Assembly Alignment Simulator Performance Optimization, Joshua G. Thompson, Brian Eney, Zaheer Ali, Bob Thompson

STAR Program Research Presentations

The Telescope Assembly Alignment Simulator (TAAS) calibrates scientific instruments (SI’s) that are installed on the Stratospheric Observatory For Infrared Astronomy (SOFIA). An SI’s accuracy is directly dependent on the consistent performance of the TAAS, which has never been fully characterized. After designing various thermal and optical experiments to identify the current unknowns of TAAS, we now have a far better grasp on how the equipment behaves.

Commissioning Of The Asta Laser Lab With Uv Pulse Length Characterization, Daniel Kelley, Jeff Corbett

STAR Program Research Presentations

The Linac Coherent Light Source (LCLS) at SLAC depends on a photocathode electron gun to provide the linear accelerator with the raw material – electrons – used for making X-ray laser pulses. The photocathode used in the LCLS Injector is a clean copper plate in high vacuum. When the cathode is struck with high energy UV light, electrons are liberated from its surface and then accelerated down the linac with radio-frequency electric fields. These fast-moving bunches of electrons are directed through an undulator magnet to radiate X-ray light.

Although scientists have been using photocathode techniques at SLAC for 25 years, …

The Double Pendulum: Construction And Exploration, Benjamin J. Knudson

Physics

The exploration of a nonlinear mechanical system, the Double Pendulum, a physical pendulum on the end of a physical pendulum, using analytic and experimental approaches. Also included discussion of the design and construction of the Double Pendulum apparatus to work with Vernier LabPro and LoggerPro. The apparatus outputs live data of the angles to a LoggerPro which collects and produces time evolution graphs as well as a corresponding animation lending itself to comparison with theoretical models. Normal mode frequencies are found both analytically and experimentally for the the general (real) double pendulum. Examples of both simple (periodic) and complex (chaotic) …

Beaglebone Webcam Server, Alexander Corcoran

Computer Engineering

The Beaglebone Webcam Server is a Linux based IP webcam, based on an inexpensive ARM development board, which hosts its own web server to display the webcam feed. The server has the ability to either connect to a wired router, or to act as a wireless access point in order for users to connect and control its functions via any Wi-Fi enabled device.

Wireless Sensor Network For Wine Fermentation, Kerry Scharfglass, Andrew Lehmer

Computer Engineering

This project implements an automated temperature monitoring system for wine fermentation which is affordable, easy to use, and scalable to typical small winery setups. To realize these requirements, we implemented the system as a wireless sensor network utilizing commercial off-the-shelf hardware. Temperature and system diagnostic information is communicated wirelessly in a peer-to-peer network topology such that all information flows toward an aggregating server. The server makes the temperature information available over the Internet via a web application and alerts the winemaker by email when the temperature has left acceptable bounds that the winemaker may configure. This project also involved materials …

Development Of A Pyrotechnic Shock Simulation Apparatus For Spacecraft Applications, Joseph Binder, Matthew Mccarty, Chris Rasmussen

Aerospace Engineering

This report details the research, design, construction, and testing of a pyrotechnic shock simulation apparatus for spacecraft applications. The apparatus was developed to be used in the Space Environments Lab at California Polytechnic State University. It will be used for testing spacecraft components with dimensions up to 24”x12”x12” as well as CubeSats. Additionally, it may be used as an instructional or demonstrational tool in the Aerospace Department’s space environments course. The apparatus functions by way of mechanical impact of an approximately 20 lb stainless steel swinging hammer. Tests were performed to verify the simulator’s functionality. Suggestions for improvement and further …

The Effect Of Polarization And Ingan Quantum Well Shape In Multiple Quantum Well Light Emitting Diode Heterostructures, Patrick M. Mcbride

Master's Theses

Previous research in InGaN/GaN light emitting diodes (LEDs) employing semi-classical drift-diffusion models has used reduced polarization constants without much physical explanantion. This paper investigates possible physical explanations for this effective polarization reduction in InGaN LEDs through the use of the simulation software SiLENSe. One major problem of current LED simulations is the assumption of perfectly discrete transitions between the quantum well (QW) and blocking layers when experiments have shown this to not be the case. The In concentration profile within InGaN multiple quantum well (MQW) devices shows much smoother and delayed transitions indicative of indium diffusion and drift during …

Blunt Impact Performance Evaluation Of Helmet Lining Systems For Military And Recreational Use, Jaclyn Siniora, Ryan Taylor, Darren Suey

Industrial Technology and Packaging

With the increasing problem in collegiate athletes experiencing injuries to the brain, different helmet liners where put to the test to see which liner provided athletes the greatest protection under specific conditions.

This senior project evaluates five different liners in football helmets. Each of the helmet liners were tested at three different temperatures: hot, cold, and ambient. Each helmet had seven different impact locations which were put to the test. The project was designed to be used to test ACH military combat liners as well. Due to shipping bottle necks the ACH combat liners have been left to future Cal …

Day/Night Band Imager For A Cubesat, Eric Stanton

Electrical Engineering

Day/Night Band (DNB) earth sensing and meteorological systems like the Defense Meteorological Satellite Program (DMSP) Operational Linescan System (OLS) provide visible wavelength imagery 24 hours a day that is used primarily for cloud imaging in support of weather forecasting. This paper describes a compact push-broom imager that meets low light imaging requirements for DMSP OLS and the NOAA/NASA Joint Polar Satellite System (JPSS) as documented in the Integrated Operational Requirements Document [1] (IORD) including the imager design, system level concepts of operation for data collection, radiometric and spatial calibration, and data transmission to Earth. This small, lightweight imager complies with …

Cuda Web Api Remote Execution Of Cuda Kernels Using Web Services, Massimo J. Becker

Master's Theses

Massively parallel programming is an increasingly growing field with the recent introduction of general purpose GPU computing. Modern graphics processors from NVIDIA and AMD have massively parallel architectures that can be used for such applications as 3D rendering, financial analysis, physics simulations, and biomedical analysis. These massively parallel systems are exposed to programmers through in- terfaces such as NVIDIAs CUDA, OpenCL, and Microsofts C++ AMP. These frame- works expose functionality using primarily either C or C++. In order to use these massively parallel frameworks, programs being implemented must be run on machines equipped with massively parallel hardware. These requirements limit …

Inductive Metal Identification, Paul Maggi

Electrical Engineering

This project focuses on creating a device to differentiate between various types of metals via magnetic induction. Magnetic induction is used because it is both non-optical and non-contact. It achieves this by generating a varying magnetic field, which induces eddy currents in the metal. These eddy currents produce small disturbances in the surrounding magnetic field, which can be sensed with Hall Effect Sensors (HES). The primary challenge in this project was generating a sufficiently strong magnetic field to detectable disturbances. In order to achieve better results, a stronger magnetic field must be used as well as more sensitive Hall Effect …

Multipolymer Interactions In Bulk Heterojunction Photovoltaic Devices, Grant Olson

Physics

Multipolymer photovoltaics, single layer devices made up of multiple photoactive polymers, can create organic photovoltaics (OPVs) with a wider spectral response than single polymer systems without the difficult fabrication of a tandem. Our group has successfully created multipolymer solar devices with 2% power conversion efficiency. We have analyzed the optical and electrical properties of these devices, and found that it may be possible for polymers to assist each other with charge extraction, though combining polymers disrupts single polymer crystallinity.

Improvement Of Statistical Process Control At St. Jude Medical's Cardiac Manufacturing Facility, Christopher Lance Edwards

Master's Theses

Sig sigma is a methodology where companies strive to reproduce results ending up having a 99.9996% chance their product will be void of defects. In order for companies to reach six sigma, statistical process control (SPC) needs to be introduced. SPC has many different tools associated with it, control charts being one of them. Control charts play a vital role in managing how a process is behaving. Control charts allow users to identify special causes, or shifts, and can therefore change the process to keep producing good products, free of defects.

There are many factories and manufacturing facilities having implemented …

Check Image Processing: Webp Conversion And Micr Scan Android Application, Trevor Bliss

Computer Engineering

As more users favor smartphones over computers for simple tasks, small businesses are constantly exploring mobile options to present to their customers. This write-up documents an Android application designed for a small company, which allows users to send pictures of checks to the company’s servers for processing. The picture is taken with the devices built-in camera and is converted to Google’s new image format, WebP. The company’s server processes the check and returns the check’s MICR code as a response. This application leverages the Android NDK and JNI to use Google’s open source image conversion libraries as well as socket …

Optical Mode Pattern Study Of Gan Based Leds With And Without Nanoscale Top Grating, Gregory Chavoor

Electrical Engineering

This study analyzes optical confinement factor and light emitting mode order for three different GaN LEDs: a conventional LED, thin Film LED, and thin Film LED with a photonic crystal (PhC) grating. For the first structure, we increase the thickness of Al_xGa_1-xN from 0 to 600nm, alter the x composition in Al_xGa_1-xN from 0.05 to 0.2 in steps of 0.05, and adjust the p-GaN and n-GaN thicknesses each from 0 to 200nm. For the second structure, we alter the n-GaN substrate thickness from 300-1000nm in steps of 100nm and 1000-4000nm in steps …