Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics Commons

Open Access. Powered by Scholars. Published by Universities.®

Civil and Environmental Engineering

1951

Montana Tech

Articles 1 - 5 of 5

Full-Text Articles in Physical Sciences and Mathematics

The Gallium-Indium Constitutional Diagram, Richard E. Gaffney May 1951

The Gallium-Indium Constitutional Diagram, Richard E. Gaffney

Bachelors Theses and Reports, 1928 - 1970

Because of the discrepancy as to whether there is solid solubility in the gallium-indium system, and the fact that no alloys with less than 1% indium were ever investigated; the possibility of solid solubility in either or both ends of the diagram was not overlooked. According to Hume-Rothery, two alloys with the same relative positions on the Periodic Chart should have about the same alloying habits.


Polarographic Analysis Applied To Metallurgical Solutions And Products, Donald W. Johnson May 1951

Polarographic Analysis Applied To Metallurgical Solutions And Products, Donald W. Johnson

Bachelors Theses and Reports, 1928 - 1970

The polarograph has been applied to a large number of chemical and metallurgical analyses, and is especially applicable to solution control analysis and to the deter­mination of minute quantities of ions in the presence of large amounts of other ions.


Determination Of The Activities Of Indium And Mercury And The Vapor Pressures Of Mercury Over These Amalgams From 0.00216 To 0.02494 Mole Fraction Indium At 25 C And From 0.00067 To 0.02410 Mole Fraction Indium At 70 C By Electromotive Force Measurements, Arthur H. Lutts May 1951

Determination Of The Activities Of Indium And Mercury And The Vapor Pressures Of Mercury Over These Amalgams From 0.00216 To 0.02494 Mole Fraction Indium At 25 C And From 0.00067 To 0.02410 Mole Fraction Indium At 70 C By Electromotive Force Measurements, Arthur H. Lutts

Bachelors Theses and Reports, 1928 - 1970

This work was performed to determine by experimental means the activities of both indium and mercury and the vapor pressures of mercury over these amalgams at 25 and 70 C.


A Determination Of Reflectivity Of Opaque Ore Minerals With A Weston Ii Light Meter, Louis L. Bergan May 1951

A Determination Of Reflectivity Of Opaque Ore Minerals With A Weston Ii Light Meter, Louis L. Bergan

Bachelors Theses and Reports, 1928 - 1970

Measurements of reflectivity of opaque ore minerals can be made with the common photographic light meter and a standard reflecting microscope, both of which are available to most Geology laboratories. During the course of the investigation, approximately 30 minerals were examined, of which 10 were duplicates. Comparable results, for the most part within 3% of previously determined valued, were obtained.


Resistance Of Solid Inconel To Attack By Liquid Indium, David C. Hendra May 1951

Resistance Of Solid Inconel To Attack By Liquid Indium, David C. Hendra

Bachelors Theses and Reports, 1928 - 1970

The role of liquid metals in industry is rap­idly becoming of increasing importance. The phys­ical and chemical tendencies of metals in the liq­uid condition must be ascertained before a metal in this form can be put to practical usage. In very many stages of mineral processing and recovery, in molten-metal baths for temperature control on heat treating, and in several industries where heat transfer is an important aspect, metals may be at one time or another in a liquid condition.