Open Access. Powered by Scholars. Published by Universities.®
Physical Sciences and Mathematics Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 6 of 6
Full-Text Articles in Physical Sciences and Mathematics
Rhenium Catalyzed Hydrogenation Of Maleic Anhydride And Crotonaldehyde, William Russel Dixon
Rhenium Catalyzed Hydrogenation Of Maleic Anhydride And Crotonaldehyde, William Russel Dixon
Theses and Dissertations
The preparation of a number of supported rhenium catalysts is reported. The determination of their activity and selectivity and of optimal reaction parameters for the reduction of maleic anhydride and crotonaldehyde is reported. Optimal time of hydrogenation was chosen as one hour and pressures were chosen as 2000 psig for crotonaldehyde and 3000 psig for maleic anhydride. Quantitative reduction of maleic anhydride to tetrahydrofuran occurred at 275° with charcoal supported rhenium catalysts. Lower temperatures (ca. 200°) produce quantitative amounts of butyrolactone. Unsupported catalysts at low temperatures (100°) selectively reduce crotonaldehyde to crotyl alcohol, but at very low conversion rates. Temperatures …
The Catalytic Hydrogenation Of Benzodiazines.|Ni.|Pphthlazine.|Nii.|Pquinazoline, Danny Lee Elder
The Catalytic Hydrogenation Of Benzodiazines.|Ni.|Pphthlazine.|Nii.|Pquinazoline, Danny Lee Elder
Theses and Dissertations
Quinazoline and phthalazine were hydrogenated at low pressure and temperature (60 psi, room temperature) and high pressure and temperature (2000 psi, 100°C, 150°C} in neutral and acidic solvents over 5% Pd/C, 5% Ru/C, 5% Rh/Al2O3 , 5% Rh/C, and 5% Pt/C. Chromatographic methods for determining the qualitative and quantitative composition of hydrogenation mixtures were developed. The compositions of quinazoline and phthalazine-hydrogenation mixtures were determined. Eight phthalazine-hydrogenation products were detected and isolated: (1) 1,2-dihydrophthalazine, (2) 1,2,3,4-tetrahydrophthalazine, (3) a,a'-diamino-o-xylene, (4) o-methylbenzylamine, (5) 1,3-dihydroisoindole, (6) o-xylene, (7 and 8) cis- and trans- 1,2-dimethylcyclohexane. These products were identified by isolating them from reaction mixtures …
Syntheses Via Modifications Of The Knorr-Paal Procedure :|Ba. Derivatives Of 2,6-Dioxa-10-Azatricyclo[5.2.1.0[Superscript 4,10]]Decane ; B. Highly Sterically Crowded 1,2,5-Trialkylpyrroles And Pyrrolidines, Weldron Severin Burnham
Syntheses Via Modifications Of The Knorr-Paal Procedure :|Ba. Derivatives Of 2,6-Dioxa-10-Azatricyclo[5.2.1.0[Superscript 4,10]]Decane ; B. Highly Sterically Crowded 1,2,5-Trialkylpyrroles And Pyrrolidines, Weldron Severin Burnham
Theses and Dissertations
Earlier work in these laboratories on the heterotricyclic system 2,6-dioxa-10-azatricyclo[5.2.1.04,10]-decane, formed from 1,4-diketones and 2-amino-1,3-propanediols by a product-water-azeotroping procedure, was extended with the synthesis of analogous compounds, e.g., the 1,4,7-triethyl-, 1,7-dimethyl-4-isopropyl-1,7-diethyl-4-isopropyl-, 1,7-dimethyl-3- and 4-phenyl- compounds. The 1,7-dimethyl heterotricycle, the kinetically-controlled product, was accompanied by the thermodynamically-controlled product, 2-(2,5-dimethyl-1-pyrryl)-1,3-propanediol. The 1,7-diethyl heterotricycle was also accompanied by the isomeric pyrrole as were the 1,7-dimethyl-3- and 4-phenyl compounds. A scheme postulating a common intermediate is presented. The interesting analogous compounds, 1,7-dimethyl-2-oxa-6-thia-10-azatricyclo[5.2.1.04,10]decane, 1,4,7-trimethyl-2,6-dioxa-11-azatricyclo[5.3.1.04,11]undecane and 11-hydroxymethyl- and 11-methyl-9,13-dioxa-14- azatetracyclo[6.5.1.02,7 011,14]tetradeca-2,4,6-triene were also prepared. The syntheses in good yields of a considerable number of moderately to …
A Study Of Reaction Parameters In The Hydrogenation Of Acetic Acid By Rhenium Heptoxide Catalyst, Victor L. Mylroie
A Study Of Reaction Parameters In The Hydrogenation Of Acetic Acid By Rhenium Heptoxide Catalyst, Victor L. Mylroie
Theses and Dissertations
Rhenium oxides as well as other rhenium compounds are known to display a broad spectrum of catalytic activity,^25 being resistant to attack by acids under nonoxidizing conditions, and showing a remarkable ability to resist poisoning which is a serious limiting factor in many commonly used catalysts. Rhenium catalysts are cheaper than the platinum metals with the exception of palladium. One of the most remarkable properties of the rhenium catalyst is the ability to catalyze the hydrogenation of carboxylic acids and amides to the corresponding alcohols and amines respectively. The carboxyl group (-COOH) is notoriously difficult to reduce catalytically and most …
An Investigation Of Metallic Rhenium, Rhenium Dioxide And Rhenium Chlorides As Catalysts In The Hydrogenation Of Certain Organic Substrates, Walter William Brown
An Investigation Of Metallic Rhenium, Rhenium Dioxide And Rhenium Chlorides As Catalysts In The Hydrogenation Of Certain Organic Substrates, Walter William Brown
Theses and Dissertations
The purpose of the present investigation was to examine the various analytical methods to ascertain the suitability of the methods for our use in determining the amount of rhenium used in our catalysts, and, if necessary devise a new method. Also, several catalysts were to be prepared and used in hydrogenation or organic compounds. Evaluation of the catalytic activity of each catalyst was to be made by using them with various selected organic substrates.
Rhenium Catalysis I. Hydrogenation And Hydroformylation Using Rhenium Carbonyl Compounds ; Ii. Hydrogenation Using Catalysts Obtained From The Reduction Of Perrhenates With Metals In Aqueous Solution, Terry G. Selin
Theses and Dissertations
The purpose of this work was to investigate the catalytic activity in both hydrogenation and hydroformylation reactions of rhenium preparations which have not been previously characterized. Rhenium pentacarbonyl was prepared in good yield from rhenium heptoxide and carbon monoxide. The optimum conditions for preparation were 25 hours per gram of dry rhenium heptoxide at 250° under 3000 psig. (initial) of carbon monoxide. Rhenium chloropentacarbonyl was prepared in 62% yield from potassium chlororhenite and carbon monoxide at high temperatures and pressures. The iodopentacarbonyl was prepared in 29% yield from potassium perrhenate, methyl iodide, and carbon monoxide. The preparation of rhenium hydrocarbonyl …