Medical Specialties Commons^™

Measured Effects Of Rapid Palatal Expansion On Nasal Cavity Volume Utilizing Cbct, Jon Neal Robinson

Loma Linda University Electronic Theses, Dissertations & Projects

The purpose of this study was to evaluate and predict the expected changes that occur in the nasal cavity volume following rapid palatal expansion. Eighteen subjects (11 female, 7 male), ages 9 to 18, requiring rapid palatal expansion in conjunction with comprehensive orthodontic treatment, were selected for the study. Rapid palatal expansion was accomplished using the standard, banded hyrax appliance. Three-dimensional cone beam computed tomograms using the NewTom 9000™ were acquired before and after expansion. Serial coronal slices of the nasal cavity were made using the QV9000™ software program. The resultant serial images were imported into 3-D Doctor™ for analysis …

The Radiopacity Of 29 Resin Restorative Materials Compared To Enamel, Peter Lubisich Iv

Loma Linda University Electronic Theses, Dissertations & Projects

The radiodensity of a composite resin can greatly influence a clinician's ability to analyze a restoration for failure. The purpose of this study was to determine the relative radiopacities of 29 resin restorative materials compared to enamel, and to verify the comparable radiopacity between shades of 23 of the restorative composite resin materials. Composite resin discs measuring >5mm in diameter and 2 mm in thickness were made and polymerized. Radiographs were taken of the composite resin discs, which included an aluminum step wedge for calibration and a densitometer was used to measure the radiodensity of the composite resin samples. The …

Quantification Of Bone Deposition In Onlay Bone Grafting, Gregory Alan Kammeyer

Loma Linda University Electronic Theses, Dissertations & Projects

The purpose of this study was to quantitatively evaluate; 1) mandibular posterior mono-cortical block onlay bone graft success rates 2) the amount of grafted bone retained after initial resorption in radiographic projections. Seven consecutive patients with 14 mandibular posterior implant sites requiring bone augmentation for implants of a standard 3.8mm x 10mm dimension were sought. Mono-cortical block bone grafts from the ipsilateral ascending ramus were placed then observed with two standardized CT scans, dividing them into two groups: Group A had the first CT at 4 weeks after graft placement and a second taken before Prosthodontic reconstruction, 36.7 weeks later. …

Assessment Of Alveolar Bone Density Using Implant Insertion Resistance Torque, Scott Sangmoo Lee

Loma Linda University Electronic Theses, Dissertations & Projects

Background: Implant stability during healing is a pre-requisite for successful osseointegration. In the case of early or immediate implant loading, it is necessary to achieve high level of stabilization during surgical placement. Fixture stabilization can be measured by resonance frequency analysis or implant insertion resistance torque measurement. The aim of this study is to correlate pre-operative radiographic bone density to implant insertion resistance torque in human cadaver jaw bone.

Materials & Methods: Sixty-four implant osteotomy sites in human cadaver jaw bones were previously examined radiographically using quantitative computed tomography (QCT) and quantitative cone-beam computed tomography (QCBCT). Forty-two implant insertion sites …