Prosthodontics and Prosthodontology Commons^™

Endodontic Access Through Zirconia Crowns: A Comparative Evaluation Of 3d Guided Versus Free-Handed Techniques, Maryam Alrughaib

Theses and Dissertations

Objective:

Accessing canals through full-coverage zirconia crowns is challenging and may increase the risk of misdirection, excessive dentin removal, and prolonged chair time. Guided endodontic access has been proposed to improve efficiency and precision. This study compared the accuracy and time efficiency of guided versus free-hand endodontic access through zirconia restorations. The hypothesis was that guided access would enhance canal localization precision and significantly reduce access time.

Methods:

Thirty-two extracted maxillary premolars were restored with 1-mm–reduced monolithic zirconia crowns (3Y-TZP, Katana HTML, Kuraray, Japan) and mounted in Modupro models. Teeth were assigned to two groups (n = 16 each): guided …

Clinical Outcomes Of Primary Anterior Esthetic Crowns In Pediatric Dentistry, Jenan Alahmad

Theses and Dissertations

Clinical Outcomes of Primary Anterior Esthetic Crowns in Pediatric Dentistry - A Prospective Cohort Study

By: Jenan Alahmad, BDS

A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University.

Virginia Commonwealth University, 2024

Thesis Advisor: Parthasarathy Madurantakam, DDS, MDS, PhD

Department of Pediatric Dentistry

BODY

Purpose: This prospective cohort study aimed to compare the effectiveness of restoring maxillary anterior teeth in children (aged 3-6 years) with three different materials: Zirconia Crowns (ZC), Resin Composite Crowns (RC), and Pre-veneered Stainless-Steel Crowns (PVSSC). The study aims to assess the Oral …

Peri-Implantitis Incidence And Effect Of Supportive Periodontal Therapy On Outcomes: Retrospective Cohort Study, Michael Ha

Theses and Dissertations

Purpose: Management of peri-implantitis is becoming an increasing component of dental practice. Dental implants can develop peri-implantitis lesions which occur in a non‐linear and accelerating pattern compared to a gradual periodontitis lesion. It is crucial to diagnose and treat this disease early, or ideally prevent it. Contemporary implants have a rough surface texture which is difficult to properly decontaminate as a crucial component for treatment prognosis. Evidence on the long-term effects of Periodontal implant maintenance therapy (PIMT) on implants is limited. This study aims to investigate the effect of periodontal maintenance on peri-implant tissue health.

Methods: A retrospective chart review …

Exploring The Use Of Pulsed Erbium Lasers To Retrieve A Zirconia Crown From A Zirconia Implant Abutment, Ahmed Elkharashi

Theses and Dissertations

Removal of zirconia crowns, commonly used as cement-retained implant fixed restorations, can be challenging. Conventional methods of crown removal are time consuming and often leave irreparable damage to the crown, which can be costly to patients and practitioners. This research explored the use of two different types of pulsed erbium lasers, erbium-doped yttrium aluminum garnet laser (Er:YAG) and erbium, chromium-doped yttrium, scandium, gallium and garnet (Er,Cr:YSGG), as non-invasive tools to retrieve cemented zirconia crowns from zirconia implant abutments. Times needed to remove the crowns were recorded and analyzed using ANOVA (��=0.05). No statistical differences between the debond times of each …

Restorative Characteristics Of Intrapulpally Cracked Teeth, Charles M. Beavers

Theses and Dissertations

Cracked teeth have long presented a diagnostic challenge. Previous investigators have considered possible predictive factors, many of which revolve around the tooth’s restorative characteristics. Few have investigated the restorative status of teeth with cracks extending into the pulp chamber. The purpose of this investigation was to determine the prevalence of the different types of restorations present in intrapulpally cracked teeth and determine any other restorative factors that may aid in predicting the presence or extent of an intrapulpal crack. Intrapulpally cracked molars requiring endodontic therapy at the VCU Graduate Endodontic Practice were included in this study. For each tooth, the …

Comparative Tensile Strengths Of Preceramic And Postceramic Solder Connectors Using High-Palladium Alloy, Abdul-Hadi Shehab

Theses and Dissertations

Purpose: To evaluate the tensile strength properties of Rx Naturelle Plus and Option (high-palladium) alloys on soldered connectors under simulated preceramic and postceramic soldering conditions. Materials and methods: Eighty cylindrical castings were fabricated (40 using Rx Naturelle Plus alloy and 40 using Option alloy). The 40 castings for each alloy were subdivided into 2 groups of 20 each. In the first group, castings for each alloy were randomly paired and soldered with SMG2 solder to produce 10 preceramic test connector specimens for each alloy. In the second group, castings were similarly paired and soldered with 490 fine solder to produce …

Influence Of A 3-Step Disinfection Procedure On Dentin Bond Strength, Maria Pappas

Theses and Dissertations

Statement of problem. Clinicians have used disinfection materials to remove surface contaminants during cavity preparation. It has been postulated that disinfection materials may negatively affect shear bond strength of restorative materials. If so, large numbers of restorations may be predestined for early failure with the use of a disinfection protocol.Purpose. To determine whether there is a difference in the bond strength between dentin and composite resin with a 3-step disinfection technique compared to a conventional bonding technique without the additional disinfection protocol.Material and Methods. Sixty human molar teeth were sectioned parallel to the occlusal surface to expose mid-coronal dentin and …

Evaluation Of Shear Bond Strength Of Two Resin-Modified Glass-Ionomer Cements, Emily Y. Ro

Theses and Dissertations

Purpose: To compare the in-vitro shear bond strengths of a new paste-paste formulation of resin-modified glass-ionomer cement (Rm-GIC) to an exising powder-liquid formulation. The study will test the hypothesis that the new paste-paste formulation of Rm-GIC (Fuji-Cem ™, GC Corp, Tokyo, Japan) has the same bond strength as an existing popular powder-liquid formulation of Rm-GIC (Rely-X ™ Luting Cement, 3M, St. Paul, MN)Materials and Methods: A total of 33 human molars were sectioned parallel to the occlusal surface to expose mid-coronal dentin and mounted parallel to the bond shearing device on the universal testing machine (Instron). For Group I samples …

The Bond Strength Of Adhesive Resin Cement: Time Differential Between Cementation And Finishing Of Cast Dowel-Cores, Purnima Joan Shahani

Theses and Dissertations

THE BOND STREGTH OF ADHESIVE RESIN CEMENT: TIME DIFFERENTIAL BETWEEN CEMENTATION AND FINISHING OF CAST DOWEL-CORES By Purnima Joan Shahani, D.D.S., M.S.A Thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University.Virginia Commonwealth University, 2003Major Director: Peter C. Moon, M.S., PhDDirector of VCU Dental Biomaterials LaboratoryThis study compared the retention of cast dowel-cores cemented with Panavia® 21 subjected to immediate versus delayed high-speed finishing. Conventionally, finishing is delayed for 24 hours to one week to allow for optimal setting and ultimate strength of the cement. Forty-five recently extracted human …

An In-Vitro Comparison Of The Retention Of Prefabricated Parallel-Sided Vented Titanium Posts Cemented With Three Different Dual-Polymerizable Resin Cements, Maha Mamdouh Mostafa El-Sayed

Theses and Dissertations

AbstractAN IN-VITRO COMPARISON OF THE RETENTION OF PREFABRICATED PARALLEL-SIDED VENTED TITANIUM POSTS CEMENTED WITH THREE DIFFERENT DUAL-POLYMERIZABLE RESIN CEMENTSBy Maha M. El-Sayed, B.D.S., D.M.D.A Thesis submitted in partial fulfillment of the requirements for the degree of Master of Science at Virginia Commonwealth University.Virginia Commonwealth University, 2003Thesis Director: David R. Burns, D.M.D. Associate Professor and Program DirectorGraduate ProsthodonticsDepartment of ProsthodonticsPurpose: The purpose of this in-vitro study was to compare the retentive strength of an autopolymerizing resin cement to three dual-polymerizable resin cements when used to cement paraposts without light activation and to relate diametral tensile stress and hardness as a measure …