Endodontic Access Through Zirconia Crowns: A Comparative Evaluation Of 3d Guided Versus Free-Handed Techniques, Maryam Alrughaib

Theses and Dissertations

Objective:

Accessing canals through full-coverage zirconia crowns is challenging and may increase the risk of misdirection, excessive dentin removal, and prolonged chair time. Guided endodontic access has been proposed to improve efficiency and precision. This study compared the accuracy and time efficiency of guided versus free-hand endodontic access through zirconia restorations. The hypothesis was that guided access would enhance canal localization precision and significantly reduce access time.

Methods:

Thirty-two extracted maxillary premolars were restored with 1-mm–reduced monolithic zirconia crowns (3Y-TZP, Katana HTML, Kuraray, Japan) and mounted in Modupro models. Teeth were assigned to two groups (n = 16 each): guided …

Clinical Outcomes Of Primary Anterior Esthetic Crowns In Pediatric Dentistry, Jenan Alahmad

Theses and Dissertations

Clinical Outcomes of Primary Anterior Esthetic Crowns in Pediatric Dentistry - A Prospective Cohort Study

By: Jenan Alahmad, BDS

A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University.

Virginia Commonwealth University, 2024

Thesis Advisor: Parthasarathy Madurantakam, DDS, MDS, PhD

Department of Pediatric Dentistry

BODY

Purpose: This prospective cohort study aimed to compare the effectiveness of restoring maxillary anterior teeth in children (aged 3-6 years) with three different materials: Zirconia Crowns (ZC), Resin Composite Crowns (RC), and Pre-veneered Stainless-Steel Crowns (PVSSC). The study aims to assess the Oral …

A Preliminary Report Of A Randomized Controlled Clinical Trial Comparing Ferric Sulfate With Zin Oxide Eugenol And Non-Eugenol Based Material For Pulpotomy In Primary Molar Teeth, Sarah Balal

Theses and Dissertations

Purpose: This study aimed to evaluate the effect of eugenol and non-eugenol-based Zinc Oxide Eugenol (ZOE) cements on primary tooth pulpotomies where Ferric Sulfate (FS) is used as a medicament.

Methods: Children aged 3-7 years with dental caries in their primary molars that have clinical and radiographic diagnosis of reversible pulpitis and undergoing dental treatment under Oral Conscious Sedation (OCS) or General Anesthesia (GA) were recruited. Children were randomly assigned to receive either FS and ZOE (IRM) or FS and non-eugenol based (CAVIT). The outcomes were assessed based on failure rates of the materials separately for clinical or radiographic evidence …

The Effect Of Crowding On The Accuracy Of 3d Printed Aligners, Tonya Spangler

Theses and Dissertations

Purpose: To evaluate the accuracy of three-dimensionally (3D) printed aligners compared to conventional vacuum-formed thermoplastic aligners with varying levels of dental crowding.

Methods: Digital intraoral scans of 10 different cases were assigned to their respective groups (n=10, each, 30 total) as follows: no crowding (control), moderate crowding, and severe crowding. Using 3Shape software, digital aligner samples were created in standard tessellation language (STL) file format and randomly 3D printed. The same STL files of each case were also sent to a dental laboratory for the fabrication of vacuum-formed samples, which is the current technology used for manufacturing aligners. The intaglio …

Exploring The Use Of Pulsed Erbium Lasers To Retrieve A Zirconia Crown From A Zirconia Implant Abutment, Ahmed Elkharashi

Theses and Dissertations

Removal of zirconia crowns, commonly used as cement-retained implant fixed restorations, can be challenging. Conventional methods of crown removal are time consuming and often leave irreparable damage to the crown, which can be costly to patients and practitioners. This research explored the use of two different types of pulsed erbium lasers, erbium-doped yttrium aluminum garnet laser (Er:YAG) and erbium, chromium-doped yttrium, scandium, gallium and garnet (Er,Cr:YSGG), as non-invasive tools to retrieve cemented zirconia crowns from zirconia implant abutments. Times needed to remove the crowns were recorded and analyzed using ANOVA (��=0.05). No statistical differences between the debond times of each …

Designing Biomimetic Implant Surfaces To Promote Osseointegration Under Osteoporotic Conditions By Revitalizing Mechanisms Coupling Bone Resorption To Formation, Ethan M. Lotz

Theses and Dissertations

In cases of compromised bone remodeling like osteoporosis, insufficient osseointegration occurs and results in implant failure. Implant retention relies on proper secondary fixation, which is developed during bone remodeling. This process is disrupted in metastatic bone diseases like osteoporosis. Osteoporosis is characterized low bone mass and bone strength resulting from either accelerated osteoclast-mediated bone resorption or impaired osteoblast-mediated bone formation. These two processes are not independent phenomena. In fact, osteoporosis can be viewed as a breakdown of the cellular communication connecting bone resorption to bone formation. Because bone remodeling occurs at temporally generated specific anatomical sites and at different times, …

The Efficacy Of A Fluoride-Containing Orthodontic Primer In Preventing Demineralization, Alyssa G. Ricci

Theses and Dissertations

Purpose: To evaluate the efficacy of a fluoride-containing orthodontic primer in preventing demineralization adjacent to brackets and compare the quality of enamel on tooth surfaces that received interproximal reduction (IPR).

Methods: Patients at the VCU Orthodontic clinic who consented to orthodontic treatment involving extraction of at least 2 premolars were recruited to this pilot clinical study. Brackets were bonded to premolars using one of two primers, fluoride-containing experimental or control. IPR was also performed, and the experimental primer was applied to randomly selected teeth. Extracted teeth were analyzed visually for the presence of white spot lesions (WSLs). Micro-CT analyses were …

A Comparison Of The Antimicrobial Efficacy Of Silver Diamine Fluoride And Silver Nitrate: An In Vitro Study, Nicholas L. Luke

Theses and Dissertations

A COMPARISON OF THE ANTIMICROBIAL EFFICACY OF SILVER DIAMINE FLUORIDE AND SILVER NITRATE: AN IN VITRO STUDY

By: Nicholas L Luke, D.D.S.

A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University.

Virginia Commonwealth University, May 2018

Thesis Advisor: William O. Dahlke Jr., D.M.D.

Pediatric Dentistry, Department Chair

Purpose: To determine the antimicrobial efficacy of SDF and SN/NaF.

Methods: Three bacterial species were combined to create an in vitro biofilm. Treatment was completed with SN, SN/NaF, SDF, SDF½ or untreated (control).

Results: The untreated group demonstrated significantly higher …

Evaluation Of Fit For 3d Printed Retainers As Compared To Thermoform Retainers, David J. Cole

Theses and Dissertations

ABSTRACT

EVALUATION OF FIT FOR 3D PRINTED RETAINERS AS COMPARED TO THERMOFORM RETAINERS

By David Cole, D.M.D.

A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University

Thesis Directors: Eser Tüfekçi, D.D.S., M.S., Ph.D., M.S.H.A.

Professor, Department of Orthodontics

Sompop Bencharit, D.D.S., M.S., Ph.D.

Associate Professor and Director of Digital Dentistry, Department of General Practice

Introduction: Despite recent advances in three-dimensional (3D) printing, little information is available on 3D printed retainers

Methods: Three reference models were used to fabricate traditional vacuum formed, commercially-available vacuum formed, and 3D printed …

An Investigation Of Surface Characteristics Of Enamel Treated With Infiltrative Resin: A Scanning Electron Microscopy Study, Danielle E. Easterly

Theses and Dissertations

AN INVESTIGATION OF SURFACE CHARACTERISTICS OF ENAMEL TREATED WITH INFILTRATIVE RESIN: A SCANNING ELECTRON MICROSCOPY STUDY

Danielle E. Easterly, Doctorate of Dental Surgery.

A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University.

Virginia Commonwealth University. 2017.

Director: Dr. Eser Tüfekçi

D.D.S., M.S., Ph.D., M.S.H.A.

Objective: To evaluate the microstructural changes of a resin infiltrant (ICON®, DMG America LLC, Englewood, NJ) after six months of simulated toothbrushing.

Materials and Methods: Ten extracted third molars (n=10) were collected. Artificial white spot lesions were created and resin applied. Environmental SEM …