Engineering Commons^™

Forensic Investigation Of Building Failure – The Harbour Cay Condominium Disaster, John Airis

Publications and Research

When a building suffers collapse, the U.S. Occupational Safety and Health Administration (OSHA) is tasked with conducting an investigation into the cause. Often OSHA will request technical assistance from the National Institute for Standards and Technology to assist in the forensic technical aspects determining a most probable cause. This forensic effort entails many actions. The Harbour Cay Condominium disaster occurred on March 28, 1981 in Cocoa Beach, Florida. It was a total collapse of a five story reinforced concrete structure during the last stage of roof construction, resulting in 11 deaths and 24 injuries. The investigation report revealed structural design …

Static Analysis Of Structural Members, Amani Calderon, Alexis Villalona, Farhad Alinaghizadeh

Publications and Research

This research is devoted to statics analysis of structural members under mechanical loads. Static analysis of beams under uniform transverse mechanical loads is presented. The beams are supported by simply supported boundary condition at both sides. The equilibrium equation of the beams is obtained and solved using analytical method and numerical method. The numerical method employed in this work is generalized differential quadrature (GDQ) method. The type of differential quadrature method used for numerical solution is the polynomial-based GDQ method. The differential equation is discretized into algebraic equations based on the GDQ technique. The algebraic equations are then solved to …

Static Analysis Of Circular Plates Under Mechanical Loads, Harpreet Lalia

Publications and Research

In this research statics analysis of circular plates is performed using SolidWorks.

Circular plates with different material properties, thickness to radius ratios, and boundary conditions under mechanical loads are modeled and analyzed in SolidWorks.

The results are obtained for deflections of circular plates under uniform and point loads.

A three-dimensional (3D) model of circular plates is first created in SolidWorks. Then the material properties, mechanical loads and boundary conditions are defined for the plate.

It is found deflection of plates is depended on magnitude of mechanical loads, geometrical parameters, boundary conditions and material properties. Responses of SolidWorks for deflections of …

Development Of Electromagnetic Friction Dampers For Improving Seismic Performance Of Civil Structures, Mohsen Amjadian

Dissertations and Theses

Energy dissipation is critical to limiting damage to civil structures subjected to extreme natural events such as earthquakes. Friction is one of the most reliable mechanisms of energy dissipation that has been utilized extensively in friction dampers to improve seismic performance of civil structures. Friction dampers are well-known for having a highly nonlinear hysteretic behavior caused by stick-slip motion at low velocities, a phenomenon that is inherent in friction and increases the acceleration response of the structure under control unfavorably, in spite of the fact that the displacement is generally reduced because of the energy dissipation. This increase in acceleration …