Engineering Commons^™

Design Of Logan City's Stormwater Conveyance System, Kade Jacob Beck

Undergraduate Honors Capstone Projects

This report summarizes 10th West Engineers' (10WE) storm water conveyance design for Logan City. The implementation of the design mitigates flood risk due to storm water discharge , helps improve local water quality, and uses infrastructure that would otherwise be abandoned. The system collects storm water discharged along 1000 West and transports the water to the holding pond located at approximately 2400 West 2200 North, Logan, Utah (see Figure 1).

Figure 1. Aerial Photo of the Area of Interest Current Conditions

Logan City is located in northern Utah's Cache County. As development and redevelopment occur, storm water runoff quantities will …

Statistical Models Of I-15 Bridge C-846: Changes In Natural Frequencies Due To Temperature, Gilbert Nichols

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Structural Health monitoring is to determine the condition of a bridge based on instrument measurements. The C-846 Bridge in Salt Lake City has such instrumentation. The bridge is located in Salt Lake City at about 2100 South and Interstate 15. This bridge has two kinds of instruments on it: accelerometers and thermocouples. The accelerometers measure the vibrations of the bridge. The accelerometers have been recording data on the bridge since 2001. The thermocouples, which measure temperature, were added as part of this thesis in April 2016.

In light of recent research, damage may be detected from measuring the change in …

Developing A General Methodology For Evaluating Composite Action In Insulated Wall Panels, Jaiden Thomas Olsen

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Precast Concrete Sandwich Panel Walls (PCSPW’s) have been in use for over 60 years. They provide a very efficient building envelope for many buildings. Characteristic PCSPW’s comprise an outer and inner layer (or wythe) of concrete separated by an insulating material. To use all of the material as efficiently as possible, the layers are attached by connectors which penetrate through the insulating layer and are embedded in either concrete wythe. These connectors make it possible for both layers of the wall to work together when resisting loads. The connectors are made out of plastic, or FRP, to prevent heat transfer …