Engineering Commons^™

Soil Moduli Obtained From A Back Pressure Constant Rate Of Strain Bender Element Consolidation Apparatus, Yi Zhao

Graduate Theses and Dissertations

A back-pressure saturated, constant-rate-of-strain consolidation device was modified to incorporate bender elements (BP-CRS-BE) and thus allowed for shear wave measurements during consolidation tests. This newly fabricated system has many advantages over other previous or current devices: 1) it can be utilized not only for laboratory prepared soil samples but also for field sampled soils such as Shelby tube samples, and 2) continuous compression curves, and continuous values of vertical hydraulic conductivity and coefficient of consolidation can be acquired with a significant reduction in testing time. Soil modulus values such as shear modulus and constrained modulus are also able to be …

A Novel Composite Material-Based Computational Model For Left Ventricle Biomechanics Simulation, Seyyed Mohammad Hassan Haddad

Electronic Thesis and Dissertation Repository

To model cardiac mechanics effectively, various mechanical characteristics of cardiac muscle tissue including anisotropy, hyperelasticity, and tissue active contraction characteristics must be considered. Some of these features cannot be implemented using commercial finite element (FE) solvers unless additional custom-developed computer codes/subroutines are appended. Such codes/subroutines are unavailable for the research community. Accordingly, the overarching objective of this research is to develop a novel LV mechanics model which is implementable in commercial FE solvers and can be used effectively within inverse FE frameworks towards cardiac disease diagnosis and therapy. This was broken down into a number of objectives. The first objective …

Wake Character In The Wind Turbine Array: (Dis-)Organization, Spatial And Dynamic Evolution And Low-Dimensional Modeling, Nicholas Michael Hamilton

Dissertations and Theses

To maximize the effectiveness of the rapidly increasing capacity of installed wind energy resources, new models must be developed that are capable of more nuanced control of each wind turbine so that each device is more responsive to inflow events. Models used to plan wind turbine arrays and control behavior of devices within the farm currently make questionable estimates of the incoming atmospheric flow and update turbine configurations infrequently. As a result, wind turbines often operate at diminished capacities, especially in arrays where wind turbine wakes interact and inflow conditions are far from ideal. New turbine control and wake prediction …

The Anisotropy Of Hexagonal Close-Packed And Liquid Interface Free Energy Using Molecular Dynamics Simulations Based On Modified Embedded-Atom Method, Ebrahim Asadi, Mohsen Asle Zaeem

Materials Science and Engineering Faculty Research & Creative Works

This work aims to comprehensively study the anisotropy of the hexagonal close-packed (HCP)-liquid interface free energy using molecular dynamics (MD) simulations based on the modified-embedded atom method (MEAM). As a case study, all the simulations are performed for Magnesium (Mg). The solid-liquid coexisting approach is used to accurately calculate the melting point and melting properties. Then, the capillary fluctuation method (CFM) is used to determine the HCP-liquid interface free energy (γ) and anisotropy parameters. In CFM, a continuous order parameter is employed to accurately locate the HCP-liquid interface location, and the HCP symmetry-adapted spherical harmonics are used to expand γ …

Biaxial Creep Test Study On The Influence Of Structural Anisotropy On Rheological Behaviour Of Hard Rock, Chuangzhou Wu, Qingsheng Chen, Sudip Basack, Riqing Xu, Zhenming Shi

Faculty of Engineering and Information Sciences - Papers: Part A

Rheological characteristics are one of most important properties needed to be considered for the designing and construction for the long term stability and serviceability of underground structures in the rock mass. Up to date, although extensive studies on the rheological properties of rocks are available in the literature, most of existing studies reported the strain-time data for the axial deformation through compression rheological method and did not mention the lateral deformation, and mainly focused on the soft rocks at shallow depth. Thus, very limited attention has been paid to the rheological properties of deep and hard rock, neglecting the effects …

Numerical Calculation Of Spatially Variant Anisotropic Metamaterial, Asad Ullah Hil Gulib

Open Access Theses & Dissertations

3D printing, or additive manufacturing, is rapidly evolving into a mainstream manufacturing technology that is creating new opportunities for electromagnetics and circuits. 3D printing permits circuits to fully utilize the third dimension allowing more functions in the same amount of space and allows the devices to have arbitrary form factors. 3D printing is letting us discover new physics that is not possible in standard 2D circuits and devices. However, evolving electromagnetics and circuits into three dimensions introduces some serious problems like thermal management, interference, and mutual coupling between the components which degrades performance and hurts signal integrity.

Metamaterials are engineered …

Effect Of Twisted Fiber Anisotropy In Cardiac Tissue On Ablation With Pulsed Electric Fields, Fei Xie, Christian W. Zemlin

Bioelectrics Publications

Background: Ablation of cardiac tissue with pulsed electric fields is a promising alternative to current thermal ablation methods, and it critically depends on the electric field distribution in the heart.

Methods: We developed a model that incorporates the twisted anisotropy of cardiac tissue and computed the electric field distribution in the tissue. We also performed experiments in rabbit ventricles to validate our model. We find that the model agrees well with the experimentally determined ablation volume if we assume that all tissue that is exposed to a field greater than 3 kV/cm is ablated. In our numerical analysis, we considered …