Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Design Of A Liquid Fuel Injector For Alternative Fuel Studies In An Atmospheric Model Gas Turbine Combustor, John Stevenson
Design Of A Liquid Fuel Injector For Alternative Fuel Studies In An Atmospheric Model Gas Turbine Combustor, John Stevenson
Honors Theses
A new liquid-fuel injector was designed for use in the atmospheric-pressure, model gas turbine combustor in Bucknell University’s Combustion Research Laboratory during alternative fuel testing. The current liquid-fuel injector requires a higher-than-desired pressure drop and volumetric flow rate to provide proper atomization of liquid fuels. An air-blast atomizer type of fuel injector was chosen and an experiment utilizing water as the working fluid was performed on a variable-geometry prototype. Visualization of the spray pattern was achieved through photography and the pressure drop was measured as a function of the required operating parameters. Experimental correlations were used to estimate droplet sizes …
Investigation Of The Design Of A Bistable Micro-Chemical-Mechanical Device Utilizing Lateral Buckling, Susan Lyn Barnes
Investigation Of The Design Of A Bistable Micro-Chemical-Mechanical Device Utilizing Lateral Buckling, Susan Lyn Barnes
Honors Theses
The Gracias Laboratory at Johns Hopkins University has developed microgrippers which utilize chemically-actuated joints to be used in micro-surgery. These grippers, however, take up to thirty minutes to close fully when activated biochemicals in the human body. This is very problematic and could limit the use of the devices in surgery. It is the goal of this research to develop a gripper that uses theGracias Laboratory's existing joints in conjunction with mechanical components to decrease the closing time. The purpose of including the mechanical components is to induce a state of instability at which time a small perturbation would cause …