Engineering Commons^™

Laser Doppler Velocimetry Research Of The Blowby Gas Characteristics In An Internal Combustion Engine, Mark Kevin Coffill

Masters Theses

The project was designed to measure a reciprocating engine fluid flow (blowby gases past the piston rings) using a laser doppler velocimeter (LDV). Blowby gases were obtained by introducing compressed air into an engine cylinder (piston held at TDC) to simulate engine combustion pressures. Beginning the proposed research included starting an LDV/reciprocating engine laboratory at Western Michigan University and determining the limits of the measurement devices (LDV system in particular).

The limitations which were found in the LDV system only allowed for limited results of in cylinder optical measurements. The results obtained were for cylinder pressures below 0.6 kPa gauge …

The Indentation Of Foam Pattern Surfaces By Coordinate Measuring Machine Probes, Sanjay Nenawati

Masters Theses

When coordinate measuring machines are used to measure the complex shapes of foam patterns, the spherical probe tips indent into the soft surface of the pattern. Such indentation represents a measurement error since the indicated dimension will not be the same as the actual dimension. To determine the magnitude of error, the depth of probe tip indentation into PMMA and EPS foam surface (i.e., elastic indentation) was measured as a function of time, applied load, and foam density. The residual indentation after the removal of the load (i.e., plastic indentation) was also studied.

The depth of elastic indentation increased with …

Computational Simulation Of Flow Through Elbows In The Approach Piping Systems To A Headbox, Kasinathan Ramanathan

Masters Theses

The successful operation of the wet end in a paper machine is highly dependent on the approach piping system. Sheet basis weight stability and ease of making wet end adjustments are greatly impaired by improperly designed approach piping systems. Most problems in headbox approach piping occur when the flow splits, combines, and passes through elbows.

Elbows create cross flows, flow separation, and eddies, and play an important role in the uniform and stable delivery of the pulp into the headbox. The effect due to an elbow lasts for a considerable distance downstream of the elbow and is severe when two …

Particle Size And Velocity Measurements In Two Phase Flows Using Laser Doppler Velocimetry, Joseph Parker

Honors Theses

Laser Doppler Velocimetry is used in fluid mechanics to measure the velocity of particles in fluid flows. A small particle exhibits motion closely corresponding to the fluid behavior because of its ability to follow high frequency flow fluctuations. Large particles do not follow the flow field precisely but represent a second phase. This project used LDV to measure the size and velocity of particles in two phase flows by computer analysis of the Doppler signal.