Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Effect Of Class C And Class F Fly Ash On Early-Age And Mature-Age Properties Of Calcium Sulfoaluminate Cement Paste, Sukanta K. Mondal, Carrie Clinton, Hongyan Ma, Aditya Kumar, Monday Uchenna Okoronkwo
Effect Of Class C And Class F Fly Ash On Early-Age And Mature-Age Properties Of Calcium Sulfoaluminate Cement Paste, Sukanta K. Mondal, Carrie Clinton, Hongyan Ma, Aditya Kumar, Monday Uchenna Okoronkwo
Civil, Architectural and Environmental Engineering Faculty Research & Creative Works
To Promote the Sustainable Development of Eco-Efficient Calcium Sulfoaluminate (CSA) Cements through the Partial Replacement of the CSA Clinker with Supplementary Cementitious Waste Products, the Effects of Coal Fly Ashes on the Early-Age and Mature-Age Properties of a Calcium Sulfoaluminate (CSA)-Based Cement Paste Were Investigated. the Impacts of Both Class C and Class F Fly Ashes on the Rheological Properties, Hydration Kinetics, and Compressive Strength Development of CSA Cement Paste Were Studied. Rheology-Based Workability Parameters, Representing the Rate of Loss of Flowability, the Rate of Hardening, and the Placement Limit, Were Characterized for the Pastes Prepared with Fixed Water-To-Cement (W/c) …
Measurement Of Volumetric Deformation, Strain Localization, And Shear Band Characterization During Triaxial Testing Using A Photogrammetry-Based Method, Sara Fayek, Xiong Zhang, Xiaolong Xia, Qingqing Fu, Jeffrey D. Cawlfield
Measurement Of Volumetric Deformation, Strain Localization, And Shear Band Characterization During Triaxial Testing Using A Photogrammetry-Based Method, Sara Fayek, Xiong Zhang, Xiaolong Xia, Qingqing Fu, Jeffrey D. Cawlfield
Civil, Architectural and Environmental Engineering Faculty Research & Creative Works
Triaxial Testing Has Been Routinely Used as a Standard Laboratory Test that Allows Correct Determination of Soil Characteristics. Previously the Volumetric Strain of the Triaxial Specimen Was Considered to Be Uniformly Distributed Along with the Specimen during the Isotropic and Deviatoric Loading. Although This Assumption Might Hold True under Isotropic Loading, the Effects of Restrained Ends and Disturbance during the Procedures of Specimen Installation and Testing Can Cause Nonuniform Strains throughout the Whole Specimen. This Paper Investigates the Effects of Specimen Preparation and Misalignment on the Strain Uniformity Along with the Soil Specimen during Triaxial Testing. a Series of Consolidated …
Point Density For Soil Specimen Volume Measurements In Image-Based Methods During Triaxial Testing, Sara Fayek, Xiong Zhang, Javad Galinmoghadam, Jeffrey D. Cawlfield
Point Density For Soil Specimen Volume Measurements In Image-Based Methods During Triaxial Testing, Sara Fayek, Xiong Zhang, Javad Galinmoghadam, Jeffrey D. Cawlfield
Civil, Architectural and Environmental Engineering Faculty Research & Creative Works
Discrete Measurement Targets Were Frequently Utilized in Image-Based Methods on the Specimen's Surface to Monitor the Soil Specimen during Triaxial Testing. However, the Required Density of Measurement Targets that Should Be Used in Triaxial Testing to Achieve Highly Accurate Volume Measurement Has Not Been Investigated. to overcome This Limitation, This Paper Presents a Parametric Study to Determine the Optimum Target/point Densities to Be Utilized on the Triaxial Soil Specimen Surface to Achieve the Desired Level of Volume Measurement Accuracy in Image-Based Methods. LiDAR Scanning Was Applied to Establish the "Ground Truth" Volume of the Specimen. the Effects of Deformation and …