Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Upper Spokane River Model In Idaho: Boundary Conditions And Model Setup And Calibration For 2001 And 2004, Robert Leslie Annear, Scott A. Wells, Chris Berger
Upper Spokane River Model In Idaho: Boundary Conditions And Model Setup And Calibration For 2001 And 2004, Robert Leslie Annear, Scott A. Wells, Chris Berger
Civil and Environmental Engineering Faculty Publications and Presentations
As a result of a Total Maximum Daily Load (TMDL) study of the Spokane River in Washington, a hydrodynamic and water quality model for the Spokane River was developed by Portland State University (PSU) for the Corps of Engineers and the Washington Department of Ecology from the Washington-Idaho state line to the outlet of Long Lake.
An earlier study of the Spokane River was undertaken by Limno-Tech (2001a, 2001b) for the domain shown in Figure 3. Limno-Tech used an earlier version of CE-QUAL-W2, Version 2, for the Reservoir portion of the Spokane River from Post Falls Dam to Coeur d’Alene …
Review Of Spokane River Model For Washington Department Of Ecology, Chris Berger, Robert Leslie Annear, Scott A. Wells
Review Of Spokane River Model For Washington Department Of Ecology, Chris Berger, Robert Leslie Annear, Scott A. Wells
Civil and Environmental Engineering Faculty Publications and Presentations
This memorandum discusses changes made to the Spokane River model calibration since the original calibration of the model discussed in the following reports: Annear et al. (2001), Berger at al. (2002), Slominski et al. (2002), and Berger et al. (2003). The first group of refinements was made by the Washington Department of Ecology. Additional changes were made by Portland State University (PSU) and were discussed in this report along with the results of two alternative calibrations. The last section displays the original calibration results from Berger et al. (2003) as a basis for comparison to the changes made by Ecology …
Upper Spokane River Model In Idaho: Boundary Conditions And Model Setup For 2001, Scott A. Wells, Robert Leslie Annear, Chris Berger
Upper Spokane River Model In Idaho: Boundary Conditions And Model Setup For 2001, Scott A. Wells, Robert Leslie Annear, Chris Berger
Civil and Environmental Engineering Faculty Publications and Presentations
The Spokane River in Idaho originates in Coeur d’Alene Lake (Figure 1 and Figure 2). The section of the Spokane River from Coeur d’Alene Lake to the Washington state line is the subject of a water quality study for the US Environmental Protection Agency. The objective of this study is to create a water quality and hydrodynamic model of the Spokane River in Idaho using CE-QUAL-W2 Version 3.1 (Cole and Wells, 2002).
Since the Spokane River is water quality limited, a hydrodynamic and water quality model for the Spokane River in Washington was developed by Portland State University for the …