Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 8 of 8
Full-Text Articles in Engineering
Hardness And Microstructural Gradients In The Heat Affected Zone Of Welded Low-Carbon Quenched And Tempered Steels, W Pang, N Ahmed, D Dunne
Hardness And Microstructural Gradients In The Heat Affected Zone Of Welded Low-Carbon Quenched And Tempered Steels, W Pang, N Ahmed, D Dunne
Faculty of Engineering and Information Sciences - Papers: Part A
This paper concentrates on the form of the hardness gradient in the heat affected zones (HAZs) produced by submerged arc welding of two low-carbon Q & T steels. The results show unequivocally that the gradient differs from that found in steels of lower carbon equivalent in that the peak HAZ hardness is displaced from the grain coarsened heat affected zone (GCHAZ) into the grain refined heat affected zone (GRHAZ). Weld thermal cycle simulation has been used to confirm the results obtained from actual welds and to clarify the cause of this unexpected phenomenon.
Simultaneous Activated Carbon Adsorption Within A Membrane Bioreactor For An Enhanced Micropollutant Removal, Xueqing Li, Faisal I. Hai, Long Nghiem
Simultaneous Activated Carbon Adsorption Within A Membrane Bioreactor For An Enhanced Micropollutant Removal, Xueqing Li, Faisal I. Hai, Long Nghiem
Faculty of Engineering - Papers (Archive)
Significant adsorption of sulfamethoxazole and carbamazepine to powdered activated carbon (PAC) was confirmed by a series of adsorption tests. In contrast, adsorption of these micropollutants to the sludge was negligible. The removal of these compounds in membrane bioreactor (MBR) was dependent on their hydrophobicity and loading as well as the PAC dosage. Sulfamethoxazole exhibited better removal rate during operation under no or low (0.1 g/L) PAC dosage. When the PAC concentration in MBR was raised to 1.0 g/L, a sustainable and significantly improved performance in the removal of both compounds was observed – the removal efficiencies of sulfamethoxazole and carbamazepine …
Australia Should Delay A Carbon Tax Until The Rest Of The World Acts, Henry Ergas
Australia Should Delay A Carbon Tax Until The Rest Of The World Acts, Henry Ergas
Faculty of Engineering and Information Sciences - Papers: Part A
The big question about the carbon tax is not whether it's a good or a bad idea in theory. The major issue is whether it makes sense for Australia to implement it at a time of great uncertainty, both in terms of economic outlook and the extent and nature of international action. To my mind a carbon tax is not desirable. Australia's prosperity is based on a resource endowment that is carbon intensive, both in terms of our mineral and our agricultural sector. Moreover, much of that carbon intensity is not amenable to technological quick-fixes. For instance, there is little …
Effect Of The Carbon Nanotube Surface Characteristics On The Conductivity And Dielectric Constant Of Carbon Nanotube/Poly(Vinylidene Fluoride) Composites, S A. Carabineiro, Manuel F. Pereira, J Nunes-Pereira, Cristina Caparrós, Vitor Sencadas, Senentxu Lanceros-Méndez
Effect Of The Carbon Nanotube Surface Characteristics On The Conductivity And Dielectric Constant Of Carbon Nanotube/Poly(Vinylidene Fluoride) Composites, S A. Carabineiro, Manuel F. Pereira, J Nunes-Pereira, Cristina Caparrós, Vitor Sencadas, Senentxu Lanceros-Méndez
Faculty of Engineering and Information Sciences - Papers: Part A
Commercial multi-walled carbon nanotubes (CNT) were functionalized by oxidation with HNO3, to introduce oxygen-containing surface groups, and by thermal treatments at different temperatures for their selective removal. The obtained samples were characterized by adsorption of N2 at -196°C, temperature-programmed desorption and determination of pH at the point of zero charge. CNT/poly(vinylidene fluoride) composites were prepared using the above CNT samples, with different filler fractions up to 1 wt%. It was found that oxidation reduced composite conductivity for a given concentration, shifted the percolation threshold to higher concentrations, and had no significant effect in the dielectric response.
Tio2(B)@Carbon Composite Nanowires As Anode For Lithium Ion Batteries With Enhanced Reversible Capacity And Cyclic Performance, Zunxian Yang, Guodong Du, Zaiping Guo, Xuebin Yu, Zhixin Chen, Tailiang Guo, Hua-Kun Liu
Tio2(B)@Carbon Composite Nanowires As Anode For Lithium Ion Batteries With Enhanced Reversible Capacity And Cyclic Performance, Zunxian Yang, Guodong Du, Zaiping Guo, Xuebin Yu, Zhixin Chen, Tailiang Guo, Hua-Kun Liu
Faculty of Engineering - Papers (Archive)
Novel TiO2(B)@carbon composite nanowires were simply prepared by a two-step hydrothermal process with subsequent heat treatment in argon. The nanostructures exhibit the unique feature of having TiO2(B) encapsulated inside and an amorphous carbon layer coating the outside. The unique core/shell structure and chemical composition is likely to lead to perfect performance in many applications. In this paper, the results of Li-ion battery testing are presented to demonstrate the superior cyclic performance and rate capability of the TiO2(B)@carbon nanowires. The composite nanowires exhibit a high reversible capacity of 560 mAh g−1 after 100 cycles …
The Behaviour Of Carbon Fibre Reinforced Polymer Confined Concrete Cylinders Under High Temperature Exposure, Butje Alfonsius Louk Fanggi, Muhammad N. S Hadi
The Behaviour Of Carbon Fibre Reinforced Polymer Confined Concrete Cylinders Under High Temperature Exposure, Butje Alfonsius Louk Fanggi, Muhammad N. S Hadi
Faculty of Engineering - Papers (Archive)
This study investigates the effect of temperature on the behaviour of concrete cylinders wrapped with Carbon Fibre Reinforced Polymer (CFRP). The study used nine concrete cylinders in three groups; the first group was exposed to room temperature of approximately 20ºC, the second group was exposed to a cyclic temperature with a temperature range of 20ºC to 70ºC, and the third group was exposed to a prolonged temperature of 70ºC. All cylinders were then tested to failure. The study indicated that ultimate strength of cylinders wrapped with one and two layers of CFRP are significantly unchanged after being exposed to 20ºC …
Compact-Designed Supercapacitors Using Free-Standing Single-Walled Carbon Nanotube Films, Zhiqiang Niu, Weiya Zhou, Jun Chen, Guoxing Feng, Hong Li, Wenjun Ma, Jinzhu Li, Haibo Dong, Yan Ren, Duan Zhao, Sishen Xie
Compact-Designed Supercapacitors Using Free-Standing Single-Walled Carbon Nanotube Films, Zhiqiang Niu, Weiya Zhou, Jun Chen, Guoxing Feng, Hong Li, Wenjun Ma, Jinzhu Li, Haibo Dong, Yan Ren, Duan Zhao, Sishen Xie
Australian Institute for Innovative Materials - Papers
We reported the realization of assembling compact-designed supercapacitors using large-scaled freestanding and flexible single-walled carbon nanotube (SWCNT) films as both anode and cathode. A prototype of the processing procedures was developed to obtain the uniform spreading of the SWCNT films onto the separators serving as both electrodes and charge collectors without metallic current collectors, leading to a simplified and lightweight architecture. The area of SWCNT film on a separator can be scaled up and its thickness can be extended. High energy and power densities (43.7 Wh kg-1 and 197.3 kW kg-1, respectively) were achieved from the prepared …
Show Us Your (Carbon Nanotube Artificial) Muscles!, Geoffrey M. Spinks
Show Us Your (Carbon Nanotube Artificial) Muscles!, Geoffrey M. Spinks
Australian Institute for Innovative Materials - Papers
The idea of doctors deploying miniscule robots in your body to diagnose and treat medical conditions is closer to reality today with the development of artificial muscles small and strong enough to push such tiny "nano-bots" along.