Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Matrix Acidizing In Carbonate Formations, Ofelia Gomez Chacon, Maysam Pournik Jan 2022

Matrix Acidizing In Carbonate Formations, Ofelia Gomez Chacon, Maysam Pournik

Mechanical Engineering Faculty Publications and Presentations

Matrix acidizing in carbonate reservoirs is a process that has been long used to increase productivity in oil and gas producing formations. The main goal is to create wormholes that bypass the damage in the formation. Hydrochloric acid (HCl) is the main acid used for this; however, it has several disadvantages that affect the success of these treatments. Its high reaction rate, inability to divert, and corrosive nature are a few of the reasons why research in this area has focused on finding alternative fluids. This paper discusses studies on successful alternatives to HCl. It has been observed that emulsified …


Synergistic Effect Of Nanocoatings For Corrosion And Wear Protection Of Steel Surfaces, Jaime Taha-Tijerina, Laura Peña Parás, Antonio Sánchez Fernández, Demófilo Maldonado Cortés, Pablo Sarmiento Barbosa, Jesús Rolando Adán López Dec 2019

Synergistic Effect Of Nanocoatings For Corrosion And Wear Protection Of Steel Surfaces, Jaime Taha-Tijerina, Laura Peña Parás, Antonio Sánchez Fernández, Demófilo Maldonado Cortés, Pablo Sarmiento Barbosa, Jesús Rolando Adán López

Informatics and Engineering Systems Faculty Publications and Presentations

The purpose of this paper is to evaluate the corrosion and wear protection of a steel substrate by epoxy vinyl ester nanocomposite coatings with Zn and TiO2 nanoparticle fillers. Steel substrates were coated with epoxy vinyl ester nanocomposites, varying Zn and TiO2 nanofiller concentrations and combinations of both nanoparticles. Corrosion resistance was evaluated by salt spray fog test during 480 h, according to ASTM B-117. The degree of damage was obtained quantitatively by measuring the enhancement in corroded area compared to the scribe mark. Tribological evaluation was performed with a ball-on-disk tribotester, according to ASTM G-99. Results showed that the …