Engineering Commons^™

Analytical And Experimental Study Of Investment Casting With Laser Stereolithography Models, Wen-Long Yao

Dissertations

This dissertation presents an analytical and experimental investigation of ceramic shell cracking during the burnout process in investment casting with internally webbed laser stereolithography (SLA) patterns. Included in the consideration are the cracking temperature of the ceramic shell, the web link buckling temperature, and the glass transition temperature of the epoxy resin. The hypothesis is that shell cracking will occur when the cracking temperature is lower than the glass transition temperature and the web buckling temperature.

An analytical and experimental study has been conducted, with the cross-sectional area, the span length of the web structure, and the shell thickness being …

A Study To Analyze And Improve Mechanical And Electro-Mechanical Designs Using Design For Quality Manufacturability (Dfqm) Technique, Bhavani P. Veerapaneni

Theses

The competitive nature of modern manufacturing demands that an innovative approach be used to build advanced and robust designs. Shortening the product development time, which is the period from initial design to full production, is a priority to most manufacturers today. Design for Quality Manufacturability (DFQM) is a methodology to address manufacturing / assembly quality issues during product design. As a consequence DFQM helps shorten the product development time.

The DFQM methodology addresses the issue of quality manufacturability (QM) - the likely hood that defects will occur during the manufacture of a product in a standard plant. The DFQM architecture …

Parameter Optimization For Curl Distortion In Building Parts Using 3-D Laser Stereolithography, Laurel A. Hanesian

Theses

The curl distortions in rapid prototyping using 3-D laser stereo lithography occur as the top layers shrink after being drawn and attaching to the bottom layers. The amount of curl is dependent upon the how much shrinkage the layer has finished prior to adhesion. It is also dependent on how deep the cure of the top layer amounts to as it adheres into the bottom layer. This thesis investigated the effect of build parameters on the distortions associated with the diagnostic 'Letter-H' shaped test part. The same parameters were also considered in a time optimization study, using calculated, predicted results …