Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Predicting Bite Force In Mammals: Two-Dimensional Versus Three-Dimensional Lever Models, Jl Davis, Se Santana, Er Dumont, Ir Grosse
Predicting Bite Force In Mammals: Two-Dimensional Versus Three-Dimensional Lever Models, Jl Davis, Se Santana, Er Dumont, Ir Grosse
Jeffrey M. Davis
Bite force is a measure of whole-organism performance that is often used to investigate the relationships between performance, morphology and fitness. When in vivo measurements of bite force are unavailable, researchers often turn to lever models to predict bite forces. This study demonstrates that bite force predictions based on two-dimensional (2-D) lever models can be improved by including three-dimensional (3-D) geometry and realistic physiological cross-sectional areas derived from dissections. Widely used, the 2-D method does a reasonable job of predicting bite force. However, it does so by over predicting physiological cross-sectional areas for the masseter and pterygoid muscles and under …
Stabilization Of Thin Liquid Films Flowing Over Locally Heated Surfaces Via Substrate Topography, N Tiwari, Jm Davis
Stabilization Of Thin Liquid Films Flowing Over Locally Heated Surfaces Via Substrate Topography, N Tiwari, Jm Davis
Jeffrey M. Davis
A long-wave lubrication analysis is used to study the influence of topographical features on the linear stability of noninertial coating flows over a locally heated surface. Thin liquid films flowing over surfaces with localized heating develop a pronounced ridge at the upstream edge of the heater. This ridge becomes unstable to transverse perturbations above a critical Marangoni number and evolves into an array of rivulets even in the limit of noninertial flow. Similar fluid ridges form near topographical variations on isothermal surfaces, but these ridges are stable to perturbations. The influence of basic topographical features on the stability of the …