Engineering Commons^™

Experimental Studies Of The Heat Transfer Characteristics Of Silica Nanoparticle Water-Based Dispersion In Pool Boiling Using Nichrome Flat Ribbons And Wires, Diane Marie Vazquez

Electronic Theses and Dissertations

This work deals with a study of enhanced critical heat flux (CHF) and burnout heat flux (BHF) in pool boiling of water with suspended silica nanoparticles using ribbon-type and wire heaters. Previously our group and other researchers have reported three-digit percentage increase in critical heat flux in silica nanofluids. This study investigates the effect of various heater surface dimensions and cross-sectional shapes on pool boiling heat transfer characteristics of water and water-based nanofluids. CHF and BHF were analyzed for circular and rectangular cross-section nichrome wires and ribbons of increasing sizes in the range of 0.32mm to 2.38mm width, approaching a …

Designing Of Energy Efficient Indoor Environments Using A Localized Radial Basis Function Meshless Method, Victor Huayamave

Electronic Theses and Dissertations

Around the world, the energy over consumption issue has been one of the key socio-economic and political challenges, which has drastically worsened over the last few years. Over the years engineers and environmentalists have proposed several approaches to improve energy efficiency. One is to reduce energy demand by improving consumption habits and a second approach is to introduce the use of a "greener" concept by using biomaterials in a diverse and more efficient manner in engineering construction to create energy efficient environments. This work will investigate the effects of using "green" stabilized earth materials to provide and enhance thermal regulation …

Vaporization Characteristics Of Pure And Blended Biofuel Droplet Injected Into Hot Stream Of Air, Abhishek Saha

Electronic Theses and Dissertations

The combustion dynamics and stability are dependent on the quality of mixing and vaporization of the liquid fuel in the pre-mixer. The vaporization characteristics of different blends of biofuel droplets injected into the air stream in the pre-mixer are modeled in this current study. The focus of this work is on the blended alternate fuels which are lately being considered for commercial use. Two major alternate fuels analyzed are ethanol and Rapeseed Methyl Esters (RME). Ethanol is being used as a substitute for gasoline, while RME is an alternative for diesel. In the current work, the vaporization characteristics of a …

High Heat Flux Spray Cooling With Ammonia On Enhanced Surfaces, Huseyin Bostanci

Electronic Theses and Dissertations

Many critical applications today, in electronics, optics and aerospace fields, among others, demand advanced thermal management solutions for the acquisition of high heat loads they generate in order to operate reliably and efficiently. Current competing technologies for this challenging task include several single and two phase cooling options. When these cooling schemes are compared based on the high heat flux removal (100-1000 W/cm2) and isothermal operation (within several oC across the cooled device) aspects, as well as system mass, volume and power consumption, spray cooling appears to be the best choice. The current study focused on high heat flux spray …

Combustion Dynamics And Fluid Mechanics In Acoustically Perturbed Non-Premixed Swirl-Stabilized Flames., Uyi Idahosa

Electronic Theses and Dissertations

The prevalence of gas turbines operating in primarily lean premixed modes is predicated on the need for lower emissions and increased efficiency. An enhancement in the mixing process through the introduction of swirl in the combustion reactants is also necessary for flame stabilization. The resulting lean swirling flames are often characterized by a susceptibility to feedback between velocity, pressure and heat release perturbations with a potential for unstable self-amplifying dynamics. The existing literature on combustion dynamics is predominantly dedicated to premixed flame configurations motivated by power generation and propulsive gas turbine applications. In the present research effort, an investigation into …

Experimental Analysis On The Effects Of Superficial Liquid And Gas Velocities In The Removal Of Hydrogen Sulfide From A Brine/Oil Mixture, Joshua Lee

Electronic Theses and Dissertations

Hydrogen Sulfide (H2S) is a harmful gas produced during petroleum extraction that leads to corrosion of drilling tools and pipelines. However, a H2S-scavenging liquid compound, when added to pipelines, interacts with liquids that absorbed H2S to create a non-corrosive bi-product. The interaction is associated with the mixing of gases and liquids. This thesis is a study on the effect of superficial gas and liquid velocities on the scavenger's efficiency. This study employs two experimental setups designed to simulate the mixing of gases and liquids within pipelines. A high pressure closed loop was designed and fabricated to determine the influence of …

Parameter Estimation In Heat Transfer And Elasticity Using Trained Pod-Rbf Network Inverse Methods, Craig Rogers

Electronic Theses and Dissertations

In applied mechanics it is always necessary to understand the fundamental properties of a system in order to generate an accurate numerical model or to predict future operating conditions. These fundamental properties include, but are not limited to, the material parameters of a specimen, the boundary conditions inside of a system, or essential dimensional characteristics that define the system or body. However in certain instances there may be little to no knowledge about the systems conditions or properties; as a result the problem cannot be modeled accurately using standard numerical methods. Consequently, it is critical to define an approach that …

Experimental And Cfd Investigations Of Lifted Tribrachial Flames, Zhiliang Li

Electronic Theses and Dissertations

Experimental measurements of the lift-off velocity and lift-off height, and numerical simulations were conducted on the liftoff and stabilization phenomena of laminar jet diffusion flames of inert-diluted C3H8 and CH4 fuels. Both non-reacting and reacting jets were investigated, including effects of multi-component diffusivities and heat release (buoyancy and gas expansion). The role of Schmidt number for non-reacting jets was investigated, with no conclusive Schmidt number criterion for liftoff previously known in similarity solutions. The cold-flow simulation for He-diluted CH4 fuel does not predict flame liftoff; however, adding heat release reaction leads to the prediction of liftoff, which is consistent with …

Fundamental Study Of Mechanical And Chemical Degradation Mechanisms Of Pem Fuel Cell Membranes, Wonseok Yoon

Electronic Theses and Dissertations

One of the important factors determining the lifetime of polymer electrolyte membrane fuel cells (PEMFCs) is membrane degradation and failure. The lack of effective mitigation methods is largely due to the currently very limited understanding of the underlying mechanisms for mechanical and chemical degradations of fuel cell membranes. In order to understand degradation of membranes in fuel cells, two different experimental approaches were developed; one is fuel cell testing under open circuit voltage (OCV) with bi-layer configuration of the membrane electrode assemblies (MEAs) and the other is a modified gas phase Fenton's test. Accelerated degradation tests for polymer electrolyte membrane …

Numerical Modeling Of The Shock Tube Flow Fields Before Andduring Ignition Delay Time Experiments At Practical Conditions, Mouna Lamnaouer

Electronic Theses and Dissertations

An axi-symmetric shock-tube model has been developed to simulate the shock-wave propagation and reflection in both non-reactive and reactive flows. Simulations were performed for the full shock-tube geometry of the high-pressure shock tube facility at Texas A&M University. Computations were carried out in the CFD solver FLUENT based on the finite volume approach and the AUSM+ flux differencing scheme. Adaptive mesh refinement (AMR) algorithm was applied to the time-dependent flow fields to accurately capture and resolve the shock and contact discontinuities as well as the very fine scales associated with the viscous and reactive effects. A conjugate heat transfer model …

Computational Fluid Dynamic Optimization And Design For The Airborne Laser System, Matthew James Opgenorth

Electronic Theses and Dissertations

The Airborne Laser (ABL) was designed to destroy any ballistic missile shortly after launch that could be a threat to the United States and its allies. The ABL uses several lasers to accomplish the destruction of the ballistic missile, most notably the high powered Chemical Oxygen Iodine Laser (COIL). The COIL is a complex device that could be improved upon in several areas that will result in overall weight reduction, refinement of beam quality, and increased magazine capacity.

This dissertation presents novel design and optimization techniques coupled with fluid dynamics to improve the performance of the COIL system. The focus …

Multiscale Investigation Of Random Heterogenous Media In Materials And Earth Sciences, Andrew J. Goupee

Electronic Theses and Dissertations

This dissertation is concerned with three major areas pertaining to the characterization and analysis of heterogeneous materials. The first is focused on the modeling of heterogeneous materials with random microstructure and understanding their thermomechanical properties as well as developing a methodology for the multiscale thermoelastic analysis of random heterogeneous materials. Realistic random microstructures are generated for computational analyses using random morphology description functions. The simulated microstructures closely resemble actual micrographs of random heterogeneous materials. The simulated random microstructures are characterized using statistical techniques and their homogenized material properties computed using the asymptotic expansion homogenization method. The failure response of random …

Experimental Studies Of Liquefaction And Densification Of Liquid Oxygen, Jonathan Koert Partridge

Electronic Theses and Dissertations

Rocketry employs cryogenic refrigeration to increase the density of propellants, such as oxygen, and stores the propellant as a liquid. In addition to propellant liquefaction, cryogenic refrigeration can also conserve propellant and provide propellant subcooling and densification. Previous studies analyzed vapor conditioning of a cryogenic propellant, which occurred by either a heat exchanger positioned in the vapor or by using the vapor as the working fluid in a refrigeration cycle. This study analyzes the refrigeration effects of a heat exchanger located beneath the vapor-liquid interface of liquid oxygen. This study predicts the mass liquefaction rate and heat transfer coefficient for …

A Model Integrated Meshless Solver (Mims) For Fluid Flow And Heat Transfer, Salvadore Gerace

Electronic Theses and Dissertations

Numerical methods for solving partial differential equations are commonplace in the engineering community and their popularity can be attributed to the rapid performance improvement of modern workstations and desktop computers. The ubiquity of computer technology has allowed all areas of engineering to have access to detailed thermal, stress, and fluid flow analysis packages capable of performing complex studies of current and future designs. The rapid pace of computer development, however, has begun to outstrip efforts to reduce analysis overhead. As such, most commercially available software packages are now limited by the human effort required to prepare, develop, and initialize the …

Heat Transfer Augmentation In A Narrow Rectangular Duct With Dimples Applied To A Single Wall, Carson Slabaugh

Electronic Theses and Dissertations

Establishing a clean and renewable energy supply is the preeminent engineering challenge of our time. Turbines, in some form, are responsible for more than 98 percent of all electricity generated in the United State and 100 percent of commercial and military air transport. The operation of these engines is clearly responsible for significant consumption of hydrocarbon fuels and, in turn, emission of green house gases into the atmosphere. With such wide-scale implementation, it is understood that even the smallest increase in the operating efficiency of these machines can lead to enormous improvements over the current energy situation. These effects can …

Processing, Optimization And Characterization Of Fire Retardant Polymer Nanocomposites, Jinfeng Zhuge

Electronic Theses and Dissertations

Fiber reinforced polymeric composites (FRPC) have superior physical and mechanical properties, such as high specific strength, light weight, and good fatigue and corrosion resistance. They have become competitive engineering materials to replace conventional metallic materials in many important sectors of industry such as aircraft, naval constructions, ships, buildings, transportation, electrical and electronics components, and offshore structures. However, since FRPC contain polymer matrix, the polymer composites and their structures are combustible. FRPC will degrade, decompose, and sometimes yield toxic gases at high temperature or subject to fire conditions. The objective of this study is to design and optimize fire retardant nanopaper …