Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Emi Associated With Inter-Board Connection For Module-On-Backplane And Stacked-Card Configurations, Xiaoning Ye, Jim Nadolny, James L. Drewniak, Todd H. Hubing, Thomas Van Doren, Richard E. Dubroff
Emi Associated With Inter-Board Connection For Module-On-Backplane And Stacked-Card Configurations, Xiaoning Ye, Jim Nadolny, James L. Drewniak, Todd H. Hubing, Thomas Van Doren, Richard E. Dubroff
Electrical and Computer Engineering Faculty Research & Creative Works
EMI associated with inter-board connection was studied through common-mode current measurements and FDTD modeling for stacked-card and module-on-backplane configurations. Three types of connections were investigated experimentally including an open pin field connection, an "ideal" semi-rigid coaxial cable connection, and a production connector. Both microstrip and stripline signal routing on the PCB were investigated. The results indicated signal routing on the PCBs or the inter-board connection can dominate the EMI process. Several cases of connector geometries were studied using FDTD modeling and good agreement was achieved between the measured and FDTD results.
Signal Induced Emi In Fibre Channel Cable-Connector Assemblies, Minjia Xu, S. Radu, James L. Knighten, James L. Drewniak, Todd H. Hubing, L. O. Hoeft, J. T. Dibene Ii
Signal Induced Emi In Fibre Channel Cable-Connector Assemblies, Minjia Xu, S. Radu, James L. Knighten, James L. Drewniak, Todd H. Hubing, L. O. Hoeft, J. T. Dibene Ii
Electrical and Computer Engineering Faculty Research & Creative Works
The EMI performance of cable-connector assemblies designed for FC-0 transmission has been studied. Two types of cable and two connector styles were evaluated. Experimental results show that the dominant radiation mechanism for short cable lengths is the common-mode current caused by source and PCB skew that leaks to the exterior of the shield via the transfer impedance of the connector. However, the cable imbalance becomes a more significant source of common-mode current than the source skew when the cable assembly is tens of meters long.