Engineering Commons^™

Computational Fluid Dynamics Modeling Of Air Demand For Fixed Cone Valve In Energy Dissipating Structure, Matthew S. Harames

All Graduate Theses and Dissertations, Fall 2023 to Present

Fixed cone valves are commonly installed as low-level outlet devices to discharge water from reservoirs. When discharging water, the fixed cone valves require an air vent to properly operate and maintain the valve. There is a current lack of published information regarding the accuracy of model studies to properly estimate the air demand on the full-size prototype. This research aims to help close that gap by providing data comparison between a model and prototype. Furthermore, computational fluid dynamics (CFD) simulations may be used to estimate the air demand, but the results of such have not been verified nor is information …

Field Flow Measurements For Pipe Installations With Non-Ideal Conditions, Jake Douglas

All Graduate Theses and Dissertations, Fall 2023 to Present

Accurate flow measurement data is necessary to effectively manage water resources. The purpose of this research is to investigate options to improve field flow measurement by investigating alternatives for calibrating flow meters installed in non-ideal piping. Typically, to accurately measure a flow rate using most types of flow meters, it is recommended that a straight section of pipe be installed immediately upstream and downstream of the flow meter to avoid flow fluctuations at the meter location. However, in many cases, flow disturbances upstream of the meter are unavoidable.

The performance of field flow measurements in non-ideal piping scenarios were studied …

Development, Implementation, And Optimization Of A Modern, Subsonic/Supersonic Panel Method, Cory D. Goates

All Graduate Theses and Dissertations, Fall 2023 to Present

In the early stages of aircraft design, engineers consider many different design concepts, examining the trade-offs between different component arrangements and sizes, thrust and power requirements, etc. Because so many different designs are considered, it is best in the early stages of design to use simulation tools that are fast; accuracy is secondary. A common simulation tool for early design and analysis is the panel method. Panel methods were first developed in the 1950s and 1960s with the advent of modern computers. Despite being reasonably accurate and very fast, their development was abandoned in the late 1980s in favor of …