Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Keyword
- Publication
- Publication Type
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Trampoline And Bungee Fatigue-Test Machine, Andy Brock, Christopher D'Elia, Ryan Murphy
Trampoline And Bungee Fatigue-Test Machine, Andy Brock, Christopher D'Elia, Ryan Murphy
Mechanical Engineering
JumpSport, a Saratoga based recreational and fitness trampoline company, sponsored this senior project team towards the development of a fatigue-testing machine. The goal of this project was to iterate the previous machine JumpSport used for bungee cord, spring, and trampoline fatigue testing. Since minimal study had been conducted on these specific bungee cords, the fixture was designed to confirm the theoretical correlations for rubber and perform the final tests according to a strict protocol. Operating with a specific test protocol in mind will allow the data from multiple tests to be combined and analyzed statistically. With a design concept in …
Experimental And Theoretical Investigations Of Lube Oil Performance And Engine Friction, William Fredrick Rohr
Experimental And Theoretical Investigations Of Lube Oil Performance And Engine Friction, William Fredrick Rohr
Doctoral Dissertations
The feasibility of using a motored small, single-cylinder 517 cc Hatz 1D50 diesel engine to evaluate lube oil performance and engine friction at conditions typical for a fired engine is investigated in the present study. In addition a commercial engine modeling software, AVL Excite Power Unit, is used to predict the effects of lube oil formulations on the engine friction of the same engine. The motored engine can be operated with and without compression and with and without the engine oil pump. Lube oil performance is evaluated for 19 different lube oils by using either instantaneous motoring torque (motoring torque …
Enhanced Tribological Properties Of Surfaces Patterned With Su8/Dlc Microstructures, Luke Osborn
Enhanced Tribological Properties Of Surfaces Patterned With Su8/Dlc Microstructures, Luke Osborn
Inquiry: The University of Arkansas Undergraduate Research Journal
In tribology (the study of friction, wear, and lubrication), it is known that micro-textured surfaces can reduce friction due to decreased contact area between two surfaces. The problem with many micro-textures, however, is their inability to withstand significant amounts of wear, thus limiting their potential uses and overall effectiveness. In this study, connected and isolated microstructures of SU8, a negative tone photoresist, coated with and without diamond-like carbon (DLC), were designed to investigate the effects of these microstructures and DLC coating on the tribological performance of a surface. Friction and wear studies were conducted using a tribometer; surface topography and …