Engineering Commons^™

Design Of An Improved Post For Use In A Non-Proprietary High-Tension Cable Median Barrier, Robert W. Bielenberg, Ronald K. Faller, Karla A. Lechtenberg, Tyler L. Schmidt, Scott K. Rosenbaugh, John D. Reid, Dean L. Sicking

Nebraska Department of Transportation: Research Reports

The objective of this research study was to develop a revised post section for the non-proprietary high-tension cable median barrier that improved the safety and function of the post by lowering strong-axis forces. A total of twenty dynamic component tests were performed, along with one cable pull test – ten tests with the 7-gauge C-section post, eight with the 10-gauge C-Section posts, and three with the Midwest Weak Post (MWP). The tests were conducted with the posts installed in either a compacted, crushed limestone soil or a rigid sleeve in order to determine the force vs. deflection and energy vs. …

Conceptual Development Of An Impact-Attenuation System For Intersecting Roadways, Joseph G. Putjenter

Department of Mechanical and Materials Engineering: Dissertations, Theses, and Student Research

Longitudinal barriers are commonly used to shield hazards, including stiff bridge rail ends and slopes. In some locations, a secondary roadway intersects the primary roadway within the guardrail’s length-of-need (LON). Some intersections have as little as 15 ft (4.6 m) between the intersection and beginning of the bridge railing, which require short-radius guardrail systems. No short-radius systems have been tested and approved to current impact safety standards for shielding hazards with these conditions.

Site conditions provided by the Nebraska Department of Roads were used to determine the constraints for a new safety treatment for intersecting roadways and include intersection radii, …