Engineering Commons^™

A Comparison Of Common Structural Materials, Molly Green

Williams Honors College, Honors Research Projects

This report will compare structural steel, concrete, and lumber through the lenses of mechanical properties, design process, cost, and environmental impact. Steel is a versatile, strong, and lightweight material that comes at a premium price – both financially and environmentally. It is the most expensive material of the three included in this report. This is largely due to its complex manufacturing process that is also responsible for a significant amount of the world’s carbon dioxide emissions. Concrete is significantly less expensive than steel, but the carbon dioxide emissions from manufacturing are approximately equal. Concrete also only performs well in compression …

Incorporation Of Contaminated Sediment Into Environmentally Safe Concrete, Andrew Needs

Williams Honors College, Honors Research Projects

The research performed through this project provided some interesting results on how the different properties of the contaminated sediment can impact the strength of the new concrete.

Average three, seven, and fourteen-day strengths increased when comparing to the baseline mix developed for the experiment. Increases in strengths were notices in the ten and twenty-five percent soil replacement mixes. The largest increase was approximately thirty-three percent greater than the baseline average.

The results from the forty percent replacement test showed a significant decrease in strengths when comparing against the baseline mix. A loss of about thirty percent was observed between the …

Analysis Of Standardized Concrete Mixes, Riley Graybeal

Williams Honors College, Honors Research Projects

Concrete is one of the most common materials used in construction. It is mass produced throughout the country, with numerous different designs for concrete mixes. A common practice among concrete manufacturers is to use a standardized concrete mix design. These standardized mix designs are pre-tested and are not usually altered frequently. The hypothesis of this research project is that manufacturers do not constantly investigate new ways to save on their mixes, and simply use the same standardized mix designs.

In this research, investigations into what alterations may reduce the cost of standardized mixes began with a baseline mix design provided …