Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Study On Electrochemical Impedance Spectroscopy Of Carbon Steel Eroded In Methyldiethanolamine Solution, Dong-Ping Wei, Rong-Zong Hu, Dan-Mei Pan, Wei-Xiong Huang, Rui Dong
Study On Electrochemical Impedance Spectroscopy Of Carbon Steel Eroded In Methyldiethanolamine Solution, Dong-Ping Wei, Rong-Zong Hu, Dan-Mei Pan, Wei-Xiong Huang, Rui Dong
Journal of Electrochemistry
Corrosion behavior of carbon steel in methyldiethanolamine(MDEA) solution was investigated by Electrochemical Impedance Spectroscopy(EIS).The results were showed that the corrosion rate of carbon steel in solution containing dissolved oxygen is higher than that in solution removed of dissolved oxygen before cathodic activation.They were reversed after cathodic activation.The corrosion rate is increased at first and then decreased when the concentration of MDEA is increased in the blank solutions.In the simulated solutions containing quantities of!heat-stable salts(HSS),the corrosion rate is decreased monotonously with increase of the MDEA concentration.As anodic polarization potential is increased,the EIS of carbon steel in HSS simulated solution showed characteristics …
Corrosion Electrochemical Behavior Of Aluminum Flake Pigmented Water-Borne Epoxy Coating On Carbon Steel In Nacl Solution, Li-Li Xue, Li-Kun Xu, Qing-Fen Li, Hong-Qing Song, Wen-Juan Zhou, Guang-Zhang Chen
Corrosion Electrochemical Behavior Of Aluminum Flake Pigmented Water-Borne Epoxy Coating On Carbon Steel In Nacl Solution, Li-Li Xue, Li-Kun Xu, Qing-Fen Li, Hong-Qing Song, Wen-Juan Zhou, Guang-Zhang Chen
Journal of Electrochemistry
The corrosion electrochemical behavior of a water-borne epoxy coating pigmented with aluminum flake on carbon steel with artificial scratch defect was studied in 3.5% NaCl solution using electrochemical impedance spectroscopy(EIS)and scanning vibrating electrode technique(SVET).The results indicated that the defect presented anodic electroactivity at the initial stage of immersion,which extended gradually with time from the scratch into the neighboring coating,lowering the coating impedance.With further immersion,however,the electroactivity of the coating/steel interface decreased significantly due to the self-repairing of the corrosion products,causing an obvious increase of the coating impedance.In the later period of immersion,more scattered electroactive areas appeared under the coating because of …