Engineering Commons^™

Decentralized Control Of Renewable Generation Systems, Milad Shojaee

Dissertations

As the global community struggles with the escalating challenges of climate change and environmental degradation, the transition to renewable energy sources has emerged as a paramount solution. Harnessing energy from renewable sources such as solar, wind, and hydro power not only alleviates the adverse effects of conventional fossil fuel energy sources, but also establishes a foundation for a sustainable and resilient future. Microgrids have been utilized as a feasible platform to integrate renewable energy sources into the electrical power generation networks. They include one or more generation units connected to nearby users, and are able to operate in both grid-connected …

Wideband Parameter Estimation Of Overhead Transmission Lines From Terminal Measurements, Fahad J. Alqahtani

Dissertations

The accurate and efficient determination of electrical parameters of transmission lines is essential when performing computer-aided analyses of power systems, including power-flow, state estimation, short-circuit, transient stability, power quality, and electromagnetic transients.

In this dissertation, a novel technique for wideband parameter estimation of frequency-dependent single-phase, three-phase transposed, and three-phase untransposed overhead lines, is proposed. The proposed technique utilizes terminal measurements of transient voltages and currents and is based on an analytical approach to solve the frequency domain 2-port nodal model of the line for the series impedance and shunt conductance per unit length as a function of the frequency. The …

Optimizing Speed Profiles For Sustainable Train Operation With Wayside Energy Storage Systems, Leon A. Allen

Dissertations

Large hauling capability and low rolling resistance has put rail transit at the forefront of mass transportation mode sustainability in terms of congestion mitigation and energy conservation. As such, rail vehicles are one of the least energy-intensive modes of transportation and least environmentally polluting. Despite, these positives, improper driving habits and wastage of the braking energy through dissipation in braking resistors result in unnecessary consumption, extra costs to the operator and increased atmospheric greenhouse gas emissions.

This study presents an intelligent method for the optimization of the number and locations of wayside energy storage system (WESS) units that maximize the …

Experimental And Computational Studies Of Functionalized Carbon Nanotubes For Use In Energy Storage Devices And Membranes, Emine S. Karaman

Dissertations

Electrolytes with good interfacial stability are a crucial component of any electrochemical device. The development of novel gel polymer electrolytes (GEs) with good interface stability and better manufacturability is important for the development of the next generation electrochemical devices. Gel electrolytes are hybrid electrolyte materials, combining benefits of both liquid and solid systems. Compared with liquid and solid electrolytes, GEs open new design opportunities and do not require rigorous encapsulation methods. In this dissertation, studies on functionalized carbon nanotubes (fCNTs) and graphene oxide (GO) doped polyvinyl alcohol (PVA) based gel electrolytes (GEs) are reported. The ionic conductivity and mechanical strength …

Optimized Insulation Design Of Power Transformer Windings Under Fast Voltage Pulses, Juan Manuel Villanueva Ramirez

Dissertations

Power transformers are essential electrical power system devices. Using the principle of electromagnetic induction, they can transfer electric energy between two otherwise isolated circuits, as well as reduce or increase voltage levels without modifying the frequency. This allows reduction of power losses when electric energy is transferred between power plants and consumers. Because of their importance and widespread use, transformers failures can have a severe economic impact due to the temporary interruption of electric service.

The insulation design of power transformers is performed by considering the maximum values of voltage or current to which the device will be exposed during …

Controlled Reduction Of Graphene Oxide And Graphene Oxide-Carbon Nanotube Hybrids And Their Applications, Samar Azizighannad

Dissertations

Graphene and graphene derivatives are widely used in diverse research and industrial applications. Graphene production on a large scale is carried out by exfoliating graphite oxide and producing graphene oxide (GO), which comprises of graphene sheets with different oxygen-containing functional groups such as hydroxyl, carboxyl, and carbonyl. GO is reduced to reduced graphene oxide (rGO), which has properties that are closer to graphene. Properties of GO and rGO depend upon the oxygen content, and the effect of reducing oxygen content on the aqueous behavior of rGOs is not well understood.

In an effort to understand how properties of rGO change …

The Influence Of The Electric Supply Industry On Economic Growth In Less Developed Countries, Edward Richard Bee

Dissertations

This study measures the impact that electrical outages have on manufacturing production in 135 less developed countries using stochastic frontier analysis and data from World Bank’s Investment Climate surveys. Outages of electricity, for firms with and without backup power sources, are the most frequently cited constraint on manufacturing growth in these surveys.

Outages are shown to reduce output below the production frontier by almost five percent in Africa and by a lower percentage in South Asia, Southeast Asia and the Middle East and North Africa. Production response to outages is quadratic in form. Outages also increase labor cost, reduce exports …

Synchrophasor Assisted Efficient Fault Location Techniques In An Active Distribution Network, Anil Khanal

Dissertations

Reliability of an electrical system can be improved by an efficient fault location identification for the fast repair and remedial actions. This scenario changes when there are large penetrations of distributed generation (DG) which makes the distribution system an active distribution system. An efficient use of synchrophasors in the distribution network is studied with bidirectional power flow, harmonics and low angle difference consideration which are not prevalent in a transmission network. A synchrophasor estimation algorithm for the P class PMU is developed and applied to identify efficient fault location. A fault location technique using two ended synchronized measurement is derived …

An Adaptive Kalman Filter For Voltage Sag Detection In Power Systems, Hisham Odeh Alrawashdeh

Dissertations

The exact values of the noise covariance matrix of the Kalman filter state vector Q and the measured signal noise covariance matrix R must be obtained in order to achieve the optimal performance of the Kalman filter. There have been many techniques and assumptions made to evaluate and compute Q and R. The effects of Q and R are investigated in detail in this dissertation. Based on these investigations, the Kalman filter has been modeled to detect the fundamental signal amplitude variations of power system signals. This technique helps in evaluating voltage sags in power systems.

Two algorithms are …

Intelligent Approaches For Modeling And Optimizing Hvac Systems, Iii Raymond Tesiero

Dissertations

Advanced energy management control systems (EMCS), or building automation systems (BAS), offer an excellent means of reducing energy consumption in heating, ventilating, and air conditioning (HVAC) systems while maintaining and improving indoor environmental conditions. This can be achieved through the use of computational intelligence and optimization. This research will evaluate model-based optimization processes (OP) for HVAC systems utilizing MATLAB, genetic algorithms and self-learning or self-tuning models (STM), which minimizes the error between measured and predicted performance data. The OP can be integrated into the EMCS to perform several intelligent functions achieving optimal system performance. The development of several self-learning HVAC …

Energy Optimization Of A Free-Piston Enhanced Hybrid Vehicle, Kenneth Jarod Jones

Dissertations

The world’s heavy dependence on vehicles which utilize hydrocarbon fuels as a primary power source has renewed the interest in electric and hybrid vehicles for industrial, commercial, and public use. The primary objective of this movement is centered on increased efficiency in energy usage for transportation. Hybrid vehicles which utilize an internal combustion engine as a linear generator, converting energy stored in hydrocarbon fuels into electrical power, could serve as a transitioning technology. The free-piston enhanced hybrid vehicle (FPHV) could potentially fill this role. The present work contains a theoretical and numerical approach to analyzing and optimizing the usage of …

Design And Implementation Of An X-Band Passive Rfid Tag, Praharshin Melaka Senadeera

Dissertations

This research presents a novel fully integrated energy harvester, matching network, matching network,matching network, matching network,matching network, matching network, matching network, multi-stage RF-DC rectifier, mode selector, RC oscillator, LC oscillator, and X-band power amplifier implemented in IBM 0.18-µm RF CMOS technology. We investigated different matching schemes, antennas, and rectifiers with focus on the interaction between building blocks. Currently the power amplifier gives the maximum output power of 5.23 dBm at 9.1GHz. The entire RFID tag circuit was designed to operate in low power consumption. Voltage sensor circuit which generates the enable signal was designed to operate in very low current. …