Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Wave Optics Simulation Of Optically Augmented Retroreflections For Monostatic/Bistatic Detection, John J. Tatar Iii
Wave Optics Simulation Of Optically Augmented Retroreflections For Monostatic/Bistatic Detection, John J. Tatar Iii
Theses and Dissertations
Optical devices interrogated with a laser in the appropriate band can exhibit strong, deterministic reflections of the incident beam. This characteristic could be exploited for optical target detection and identification. The distribution of reflected power is strongly dependent on the geometry of the interrogation scenario, atmospheric conditions, and the cross section of the target optical device. Previous work on laser interrogation systems in this area has focused on analytic models or testing. To the best of my knowledge, I am presenting for the first time an approach to predict reflected power for a variety of interrogation configurations, targets, and propagation …
Evaluation Of Performance Of A Maximum Likelihood Estimator For Tracking Purposes In The Presence Of Speckle Noise, Adrian Brett Monz
Evaluation Of Performance Of A Maximum Likelihood Estimator For Tracking Purposes In The Presence Of Speckle Noise, Adrian Brett Monz
Theses and Dissertations
In many cases, optical tracking systems do not have cooperative beacons avail- able. This is particularly true for the case involving tracking a laser illuminated target such as a missile seeker head, where the object of interest is an extended source. Furthermore the extended source is often observed in the presence of noise such as shot and speckle noise as well as atmospheric turbulence which further degrades the signal. This research effort presents the evaluation of an existing algorithm based on the maximum-likelihood technique for tilt estimation in the presence of extended sources and speckle noise, with particular application to …
Maximum Likelihood Estimation Of Wave Front Slopes Using A Hartmann-Type Sensor, Scott A. Sallberg
Maximum Likelihood Estimation Of Wave Front Slopes Using A Hartmann-Type Sensor, Scott A. Sallberg
Theses and Dissertations
Current methods for estimating the wave front slope at the pupil of a telescope equipped with a Hartmann-type wave front sensor (H-WFS) are based on a simple centroid calculation of the intensity distributions (spots) recorded in each subaperture of the H-WFS. The centroid method does not include any knowledge concerning correlation properties of the slopes over the subapertures or the amount of light collected by the telescope and diverted to the H-WFS for wave front reconstruction purposes. This thesis devises a maximum likelihood (ML) estimation of the spot centroids by incorporating statistical knowledge of the spot shifts. The light level …
Flow Visualization Of A Turbulent Shear Flow Using An Optical Wavefront Sensor, Daniel W. Jewell
Flow Visualization Of A Turbulent Shear Flow Using An Optical Wavefront Sensor, Daniel W. Jewell
Theses and Dissertations
The research reported here investigated the use of a shearing interferometer (SI) wavefront sensor to determine the effects of shear-layer turbulence on an optical wavefront. A collimated helium-neon laser beam was propagated through a plane shear-layer produced by mixing helium and nitrogen at different velocities. Since the gases have different indices of refraction, the optical wavefront was distorted by different amounts by each gas. The SI measured the wavefront slope across the sampled area of the wavefront. The shear-layer was viewed from two orthogonal directions. This document contains shadow graphs, interference patterns imaged by each of the SI's six cameras, …