Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Other Engineering

California Polytechnic State University, San Luis Obispo

2020

Design Fire

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Elewexe – Building 172b, California Polytechnic State University – San Luis Obispo, Anna M. Santoro Jun 2020

Elewexe – Building 172b, California Polytechnic State University – San Luis Obispo, Anna M. Santoro

Fire Protection Engineering: Culminating Experience Project Reports

California Polytechnic State University at San Luis Obispo recently finished constructing a new multimillion student housing project on campus. One of the six buildings, elewexe or 172B, from this housing complex was selected for a full evaluation of the fire and life safety systems using both prescriptive and performance based approaches. The building is a Type II-B four story dormitory with an R-2 occupancy classification.

For the prescriptive approach, the building was evaluated against the most current editions of the IBC and relevant NFPA code editions for building requirements, sprinkler design and fire alarm and detection. When looking at the …


Fire Protection Analysis: Engineering Iv, Building 192, Cal Poly State University, San Luis Obispo, Paul Jenkins Jun 2020

Fire Protection Analysis: Engineering Iv, Building 192, Cal Poly State University, San Luis Obispo, Paul Jenkins

Fire Protection Engineering: Culminating Experience Project Reports

This report is an analysis of the fire protection capabilities of Engineering IV (Building 192) at Cal Poly University in San Luis Obispo, CA. The overall objective of this report was to assess whether the building and its fire protection systems supported the evacuation of occupants from the building in a safe manner before conditions became untenable during a fire event. The assessment was accomplished by performing a prescriptive and performance analysis.

The purpose of the prescriptive analysis was to determine whether the building egress components and fire protections systems were designed, built, and installed in compliance with all the …