Engineering Commons^™

Development And Testing Of A 1:70 Scale Model Wind Turbine Of The Iea Reference 15 Mw Floating Offshore System, Amber Parker

Electronic Theses and Dissertations

This thesis presents the development of a 1/70th scale performance-matched wind turbine intended for wind and wave basin model testing of commercially viable floating wind turbine structures based off of the International Energy Agency (IEA) Wind 15 MW design. The focus of this demonstration is to test active blade pitch response controls and to provide an experimental dataset for use by modelers and industry for future turbine improvements. Future research is planned to test the turbine in conjunction with an actively damping hull to test the interactions between the two control systems.

Outlined in this thesis are the methods of …

Numerical Investigation Of Coalescence-Induced Self-Propelled Behavior Of Droplets On Non-Wetting Surfaces And Wedged Surfaces., Yan Chen

Electronic Theses and Dissertations

When small drops coalesce on a superhydrophobic surface, the merged drop can jump away from the surface due to the surface energy released during the coalescence. This self-propelled behavior has been observed on various superhydrophobic surfaces and has potential applications in areas related to the heat and mass transfer, such as heat exchangers, anti-icing and anti-frost devices, thermal management and water harvesting. The jumping velocity model was obtained based on published experimental data and the balance of various energy terms described in previous studies. However, the self-propelled mechanism is still not fully understood. In this study, the self-propelled droplet phenomenon …

Study Of Film Cooling Effectiveness: Conical, Trenched And Asymmetrical Shaped Holes, Humberto Zuniga

Electronic Theses and Dissertations

Film cooling is a technique whereby air from the compressor stage of a gas turbine engine is diverted for cooling purposes to parts, such as the turbine stage, that operate at very high temperatures. Cooling arrangements include impingement jets, finned, ribbed and turbulated channels, and rows of film cooling holes, all of which over the years have become progressively more complex. This costly, but necessary complexity is a result of the industry's push to run engines at increasingly higher turbine inlet temperatures. Higher temperatures mean higher efficiency, but they also mean that the turbine first stage operates hundreds of degrees …