Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Engineering
The Effects Of A Porous Internal Lattice Design On The Articular Contact Mechanics Of Radial Head Hemiarthroplasty Implants, Jessica Benitah
The Effects Of A Porous Internal Lattice Design On The Articular Contact Mechanics Of Radial Head Hemiarthroplasty Implants, Jessica Benitah
Electronic Thesis and Dissertation Repository
Hemiarthroplasty, where one side of a joint is replaced, is a minimally invasive procedure. It allows for the preservation of native tissue, though a significant ramification is accelerated cartilage wear when articulating with high stiffness materials that do not mimic the mechanical stiffness of the native tissue. An implant that employs a lattice design can significantly lower the stiffness of a solid structure whilst maintaining strength. This study was conducted to investigate the effect of implementing a porous internal lattice structure with a thin outer shell on the articular contact mechanics, using a radial head hemiarthroplasty. It was hypothesized that …
The Influence Of Frontal And Axial Plane Deformities On Contact Mechanics During Squatting: A Finite Element Study, Yidan Xu
Electronic Thesis and Dissertation Repository
Knee Osteoarthritis (KOA) is a degenerative joint disease and a leading cause of disability worldwide. Lower limb malalignment was a risky factor leading to KOA, altering the load distributions. This study aimed to study the influence of knee deformities on knee contact mechanics and knee kinematics during squatting. A full-leg squat FE model was developed based on general open-source models and validated with in vivo studies to investigate the outputs under frontal malalignment (valgus 8° to varus 8°) and axial malalignment (miserable malalignment 30°). As a result, Varus-aligned and miserable aligned models increased medial tibiofemoral force and lateral patellar contact …
Lower Stiffness Orthopaedic Implants For Hemiarthroplasty, Carolyn Berkmortel
Lower Stiffness Orthopaedic Implants For Hemiarthroplasty, Carolyn Berkmortel
Electronic Thesis and Dissertation Repository
One of the main drawbacks of hemiarthroplasty is that it involves the articulation of a foreign material against the native cartilage, and hence the native cartilage experiences accelerated wear. It is hypothesized that lowering the stiffness of hemiarthroplasty implants will decrease contact pressure and increase contact area, thus decrease wear. Lowering the stiffness was done using finite element analysis to lower the stiffness of the implant materials, and then to change the internal structure of the implants to increase their compliance. Structural changes produced no noticeable or favourable results, whereas material produced improved results for stiffnesses below a Young’s modulus …
Influence Of Scapular Notching On Contact Mechanics And Simulator Wear Of Reverse Total Shoulder Arthroplasty Implants, Michael William Griffiths
Influence Of Scapular Notching On Contact Mechanics And Simulator Wear Of Reverse Total Shoulder Arthroplasty Implants, Michael William Griffiths
Electronic Thesis and Dissertation Repository
Scapular notching is a common complication of reverse total shoulder arthroplasty (RTSA) wherein the predominant focus of current literature has been on changes in osseous anatomy. However, the implications on RTSA performance from the damaged humeral cup is largely unknown. Therefore the present work describes the effects of the initiation and propagation of the humeral cup defect resulting from scapular notching through the use of finite element modeling and wear simulation, in order to assess changes in RTSA contact mechanics and tribological properties. A significant decrease in articular contact area and increase in maximum contact stress values was found for …