Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons™

Open Access. Powered by Scholars. Published by Universities.®

Materials Science and Engineering

Old Dominion University

Series

2018

Articles 1 - 9 of 9

Full-Text Articles in Engineering

Improved Gas Sensing Performance Of Ald Azo 3-D Coated Zno Nanorods, P. Lin, X. Chen, K. Zhang, H. Baumgart Dec 2018

Improved Gas Sensing Performance Of Ald Azo 3-D Coated Zno Nanorods, P. Lin, X. Chen, K. Zhang, H. Baumgart

Electrical & Computer Engineering Faculty Publications

This paper reports an enhancement on the sensing performance of ZnO nanorod ethanol sensors with a new approach by utilizing nested coatings of Aluminum doped ZnO (AZO) thin films by Atomic Layer Deposition (ALD) technology. ZnO nanorods were grown by the hydrothermal method with the ZnO seed layer synthesized on Silicon wafers by ALD. To enhance the sensing performance of ZnO nanorod ethanol sensors, multiple coated AZO thin film 3-D coatings were deposited on the surface of the intrinsic ZnO nanorods by ALD.To investigate the sensing performance of the ZnO nanorods sensor for the detection of ethanol vapor, a gas …

Go to article

No2- And No3- Enhance Cold Atmospheric Plasma Induced Cancer Cell Death By Generation Of Onoo-, Dehui Xu, Qingjie Cui, Yujing Xu, Zhijie Liu, Zeyu Chen, Wenjie Xia, Hao Zhang, Dingxin Liu, Hailan Chen, Michael G. Kong Oct 2018

No2- And No3- Enhance Cold Atmospheric Plasma Induced Cancer Cell Death By Generation Of Onoo-, Dehui Xu, Qingjie Cui, Yujing Xu, Zhijie Liu, Zeyu Chen, Wenjie Xia, Hao Zhang, Dingxin Liu, Hailan Chen, Michael G. Kong

Bioelectrics Publications

Cold atmospheric plasma (CAP) is a rapidly developed technology that has been widely applied in biomedicine especially in cancer treatment. Due to the generation of various active species in plasma, CAP could induce various tumor cells death and showed a promising potential in cancer therapy. To enhance the biological effects of gas plasma, changing the discharging parameters is the most commonly used method, yet increasing discharging power will lead to a higher possibility of simultaneously damage surrounding tissues. In this study, by adding nontoxic concentration of additional nitrite and nitrate in the medium, we found that anti-tumor effect of CAP …

Go to article

Pneumatospinning Of Collagen Microfibers From Benign Solvents, Seth Polk, Nardos Sori, Nick Thayer, Yas Maghdouri-White, Anna A. Bulysheva, Michael P. Francis Oct 2018

Pneumatospinning Of Collagen Microfibers From Benign Solvents, Seth Polk, Nardos Sori, Nick Thayer, Yas Maghdouri-White, Anna A. Bulysheva, Michael P. Francis

School of Medical Diagnostics & Translational Sciences Faculty Publications

Introduction. Current collagen fiber manufacturing methods for biomedical applications, such as electrospinning and extrusion, have had limited success in clinical translation, partially due to scalability, cost, and complexity challenges. Here we explore an alternative, simplified and scalable collagen fiber formation method, termed 'pneumatospinning,' to generate submicron collagen fibers from benign solvents. Methods and results. Clinical grade type I atelocollagen from calf corium was electrospun or pneumatospun as sheets of aligned and isotropic fibrous scaffolds. Following crosslinking with genipin, the collagen scaffolds were stable in media for over a month. Pneumatospun collagen samples were characterized using Fourier-transform infrared spectroscopy, circular dichroism, …

Go to article

Current-Driven Production Of Vortex-Antivortex Pairs In Planar Josephson Junction Arrays And Phase Cracks In Long-Range Order, Francisco Estellés-Duart, Miguel Ortuño, Andrés M. Somoza, Valerii M. Vinokur, Alex Gurevich Oct 2018

Current-Driven Production Of Vortex-Antivortex Pairs In Planar Josephson Junction Arrays And Phase Cracks In Long-Range Order, Francisco Estellés-Duart, Miguel Ortuño, Andrés M. Somoza, Valerii M. Vinokur, Alex Gurevich

Physics Faculty Publications

Proliferation of topological defects like vortices and dislocations plays a key role in the physics of systems with long-range order, particularly, superconductivity and superfluidity in thin films, plasticity of solids, and melting of atomic monolayers. Topological defects are characterized by their topological charge reflecting fundamental symmetries and conservation laws of the system. Conservation of topological charge manifests itself in extreme stability of static topological defects because destruction of a single defect requires overcoming a huge energy barrier proportional to the system size. However, the stability of driven topological defects remains largely unexplored. Here we address this issue and investigate numerically …

Go to article

Characterization And Analysis Of Ultrathin Cigs Films And Solar Cells Deposited By 3-Stage Process, Grace Rajan, Krishna Aryal, Shankar Karki, Puruswottam Aryal, Robert W. Collins, Sylvain Marsillac May 2018

Characterization And Analysis Of Ultrathin Cigs Films And Solar Cells Deposited By 3-Stage Process, Grace Rajan, Krishna Aryal, Shankar Karki, Puruswottam Aryal, Robert W. Collins, Sylvain Marsillac

Electrical & Computer Engineering Faculty Publications

In view of the large-scale utilization of Cu(In,Ga)Se2 (CIGS) solar cells for photovoltaic application, it is of interest not only to enhance the conversion efficiency but also to reduce the thickness of the CIGS absorber layer in order to reduce the cost and improve the solar cell manufacturing throughput. In situ and real-time spectroscopic ellipsometry (RTSE) has been used conjointly with ex situ characterizations to understand the properties of ultrathin CIGS films. This enables monitoring the growth process, analyzing the optical properties of the CIGS films during deposition, and extracting composition, film thickness, grain size, and surface roughness which …

Go to article

Direct Strength Approach To Predict The Flexural Strength Of Cold-Formed Z-Section Purlins On Sloped Roofs, Ali Parva, Michael W. Seek Jan 2018

Direct Strength Approach To Predict The Flexural Strength Of Cold-Formed Z-Section Purlins On Sloped Roofs, Ali Parva, Michael W. Seek

Engineering Technology Faculty Publications

In this study, the strength of cold-formed Z-section purlins is predicted considering the effects of roof slope in real roof systems. The study applies to simple span purlins with torsion restraints at support locations and at paired locations along the length of the member. A previously developed method has shown through comparisons to base tests that when the biaxial bending and torsion stresses are incorporated into the analysis, the Direct Strength Method can accurately predict the strength of a purlin. These stress distributions can deviate substantially from the constrained bending approximation typically assumed in analysis and therefore impacts the local …

Go to article

Effects Of Protein-Coated Nanofibers On Conformation Of Gingival Fibroblast Spheroids: Potential Utility For Connective Tissue Regeneration, Gili Kaufman, Ryan A. Whitescarver, Laiz Nunes, Xavier-Lewis Palmer, Drago Skrtic, Wojtek Tutak Jan 2018

Effects Of Protein-Coated Nanofibers On Conformation Of Gingival Fibroblast Spheroids: Potential Utility For Connective Tissue Regeneration, Gili Kaufman, Ryan A. Whitescarver, Laiz Nunes, Xavier-Lewis Palmer, Drago Skrtic, Wojtek Tutak

Engineering Technology Faculty Publications

Deep wounds in the gingiva caused bytrauma or surgery require a rapid and robust healing of connective tissues. Wepropose utilizing gas-brushed nanofibers coated with collagen and fibrin for that purpose. Our hypotheses are that protein-coated nanofibers will: (i) attract and mobilize cells in various spatial orientations, and (ii) regulate the expression levels ofspecific extracellular matrix (ECM)-associated proteins, determining the initial conformational nature ofdense and soft connective tissues. Gingival fibroblast monolayers and3D spheroids were cultured onECMsubstrate and covered with gas-blown poly-(DL-lactide-co-glycolide)(PLGA) nanofibers (uncoated/coated with collagen and fibrin). Cell attraction and rearrangement was followed byF-actin staining and confocal microscopy. Thicknesses ofthe cell …

Go to article

Effect Of Curing Rate On The Microstructure And Macroscopic Properties Of Epoxy Fiberglass Composites, Ammar Patel, Olesksandr Kravchenko, Ica Manas-Zloczower Jan 2018

Effect Of Curing Rate On The Microstructure And Macroscopic Properties Of Epoxy Fiberglass Composites, Ammar Patel, Olesksandr Kravchenko, Ica Manas-Zloczower

Mechanical & Aerospace Engineering Faculty Publications

Curing rates of an epoxy amine system were varied via different curing cycles, and glass-fiber epoxy composites were prepared using the same protocol, with the aim of investigating the correlation between microstructure and composite properties. It was found that the fast curing cycle resulted in a non-homogenous network, with a larger percentage of a softer phase. Homogenized composite properties, namely storage modulus and quasi-static intra-laminar shear strength, remained unaffected by the change in resin microstructure. However, fatigue tests revealed a significant reduction in fatigue life for composites cured at fast curing rates, while composites with curing cycles that allowed a …

Go to article

Novel Contact Materials For Improved Performance Cdte Solar Cells, Angus Rocket, Robert Collins, Sylvain Marsillac Jan 2018

Novel Contact Materials For Improved Performance Cdte Solar Cells, Angus Rocket, Robert Collins, Sylvain Marsillac

Electrical & Computer Engineering Faculty Publications

This program has explored a number of novel materials for contacts to CdTe solar cells in order to reduce the back contact Schottky barrier to zero and produce an ohmic contact. The project tested a wide range of potential contact materials including TiN, ZrN, CuInSe2:N, a-Si:H and alloys with C, and FeS2. Improved contacts were achieved with FeS2. As part of understanding the operation of the devices and controlling the deposition processes, a number of other important results were obtained. In the process of this project and following its conclusion it led to research …

Go to article