Engineering Commons^™

Analysis And Control Of Vsc Based Hvdc System Under Single-Line-To-Ground Fault Conditions, Xiaojie Shi

Doctoral Dissertations

To take full advantage of multilevel modular converter (MMC) and extend its application in high voltage direct current (HVDC) transmission systems, the ability to deal with severe unbalanced conditions, especially under single-line-to-ground (SLG) fault, is a key requirement.

This dissertation deals with the development of a fault handling strategy, which helps HVDC systems achieve continuous energy supply and desired operation performance under temporary SLG fault conditions while ensuring a smooth and fast black start for MMC-HVDC particularly if the system has to shut down when a permanent SLG fault occurs. Several related research topics will be discussed in this dissertation. …

Wide-Area Synchrophasor Measurement Applications And Power System Dynamic Modeling, Yin Lei

Doctoral Dissertations

The use of synchrophasor measurements system-wide has been providing significant assistance for grid dynamic monitoring, situation awareness and reliability improvement. Frequency Monitoring Network (FNET), as an academia-run synchrophasor measurement system, utilizes a large number of Internet-connected low-cost Frequency Disturbance Recorders (FDRs) installed at the distribution level to measure power system dynamics and provide both online and off-line applications, such as event detection, oscillation modes estimation, event replay, etc. This work aims to further explore applications of the FNET measurements and utilize measurement-based method in dynamic modeling.

Measurement-based dynamic reduction is an important application of synchrophasor measurement, especially considering the fact …

Versatile Three-Phase Power Electronics Converter Based Real-Time Load Emulators, Jing Wang

Doctoral Dissertations

This dissertation includes the methodology, implementation, validation, as well as real-time modeling of a load emulator for a reconfigurable grid emulation platform of hardware test-bed (HTB). This test-bed was proposed by Center of Ultra-wide-area Resilient Electric Energy Transmission Network (CURENT) at the University of Tennessee, at Knoxville in 2011, to address the transmission level system challenges posed by contemporary fast changing energy technologies.

Detailed HTB introduction, including design concept, fundamental units and hardware construction, is elaborated. In the development, current controlled three-phase power electronics converter based emulator unit is adopted to create desired power system loading conditions.

In the application, …

A Low-Power Bfsk/Ook Transmitter For Wireless Sensors, Mohammed Shahriar Jahan

Doctoral Dissertations

In recent years, significant improvements in semiconductor technology have allowed consistent development of wireless chipsets in terms of functionality and form factor. This has opened up a broad range of applications for implantable wireless sensors and telemetry devices in multiple categories, such as military, industrial, and medical uses. The nature of these applications often requires the wireless sensors to be low-weight and energy-efficient to achieve long battery life. Among the various functions of these sensors, the communication block, used to transmit the gathered data, is typically the most power-hungry block. In typical wireless sensor networks, transmission range is below 10 …

A Ghz-Range, High-Resolution Multi-Modulus Prescaler For Extreme Environment Applications, Benjamin Matthew Mccue

Doctoral Dissertations

The generation of a precise, low-noise, reliable clock source is critical to developing mixed-signal and digital electronic systems. The applications of such a clock source are greatly expanded if the clock source can be configured to output different clock frequencies. The phase-locked loop (PLL) is a well-documented architecture for realizing this configurable clock source. Principle to the configurability of a PLL is a multi-modulus divider. The resolution of this divider (or prescaler) dictates the resolution of the configurable PLL output frequency. In integrated PLL designs, such a multi-modulus prescaler is usually sourced from a GHz-range voltage-controlled oscillator. Therefore, a fully-integrated …

A Magnetic Actuated Fully Insertable Robotic Camera System For Single Incision Laparoscopic Surgery, Xiaolong Liu

Doctoral Dissertations

Minimally Invasive Surgery (MIS) is a common surgical procedure which makes tiny incisions in the patients anatomy, inserting surgical instruments and using laparoscopic cameras to guide the procedure. Compared with traditional open surgery, MIS allows surgeons to perform complex surgeries with reduced trauma to the muscles and soft tissues, less intraoperative hemorrhaging and postoperative pain, and faster recovery time. Surgeons rely heavily on laparoscopic cameras for hand-eye coordination and control during a procedure. However, the use of a standard laparoscopic camera, achieved by pushing long sticks into a dedicated small opening, involves multiple incisions for the surgical instruments. Recently, single …

Isolated Wired And Wireless Battery Charger With Integrated Boost Converter For Phev And Ev Applications, Madhu Sudhan Chinthavali

Doctoral Dissertations

Vehicle charging and vehicle traction drive components can be integrated for multi-functional operations, as these functions are currently operating independently. While the vehicle is parked, the hardware that is available from the traction drive can be used for charging. The only exception to this would be the dynamic vehicle-charging concept on roadways. WPT can be viewed as a revolutionary step in PEV charging because it fits the paradigm of vehicle to infrastructure (V2I) wirelessly. WPT charging is convenient and flexible not only because it has no cables and connectors that are necessary, but due more to the fact that charging …