Engineering Commons^™

A Wide Bandgap Silicon Carbide (Sic) Gate Driver For High Temperature, High Voltage, And High Frequency Applications, Ranjan Raj Lamichhane

Graduate Theses and Dissertations

The potential of silicon carbide (SiC) for modern power electronics applications is revolutionary because of its superior material properties including substantially better breakdown voltage, power density, device leakage, thermal conductivity, and switching speed. Integration of gate driver circuitry on the same chip, or in the same package, as the power device would significantly reduce the parasitic inductance, require far less thermal management paraphernalia, reduce cost and size of the system, and result in more efficient and reliable electrical and thermal performance of the system.

The design of a gate driver circuit with good performance parameters in this completely new under-development …

High Voltage Direct Current Energy Transmission Using Modular Multilevel Converters, David Alejandro Guzman Pinzon

Graduate Theses and Dissertations

This thesis focus on high voltage direct current (HVdc) energy transmission using modular multilevel converter (MMC) based terminals. It provides a brief comparison between different HVdc technologies, focusing on voltage source converters (HVdc-VSC) with the MMC-based terminal emerging as the topology of choice for ratings less than 1 GW. The controllers for a two-terminal HVdc-link are analyzed and Matlab/Simulink^TM simulation models are presented. The simplified models and full Matlab/Simulink^TM based model are used to select the gains for the MMC controllers. Simulation results carried out on the full model validated the proposed methodologies. A new control technique that …

Electrical Design Considerations And Packaging Of Power Electronic Modules, Shijie Wang

Graduate Theses and Dissertations

A modern power electronic module can save significant energy usage in the power electronic systems by improving their switching efficiencies. One way to improve the efficiency of the power electronic module is to reduce its parasitic circuit elements. The purpose of this thesis is to investigate the mitigation of parasitic circuit elements in power electronic modules. General methods of mitigating parasitic inductances were analyzed by the Q3D Extractor and verified by the time-domain reflectometry (TDR) measurements. In most cases, the TDR measurement results closely matched those predicted by the Q3D Extractor. These methods were applied to design and analyze a …