Engineering Commons^™

Assessment And Evaluation Of The Dynamic Behavior Of Muscles With Special Reference To Subjects With Diabetes Mellitus, Jorge Garza-Ulloa

Open Access Theses & Dissertations

Diabetes mellitus (simply diabetes) is a group of metabolic diseases in which a person has high blood sugar, either because the body does not produce enough insulin, or because cells do not respond to the insulin that is produced. Each year, the costs of diabetes rise. Diabetes and its complications cost our national economy. Two new methods are proposed to measure the diabetes implications in the muscles of lower body: Muscle energy expenditure analysis based on the detection of muscle transition-to-fatigue, and Natural Fuzzy logic method for differential analysis in muscle/joint. Then the results are compared with the traditional method …

Structural, Optical And Electrical Properties Of Yttrium-Doped Hafnium Oxide Nanocrystalline Thin Films, Abhilash Kongu

Open Access Theses & Dissertations

Hafnium oxide (HfO2) has emerged as the most promising high-k dielectric for Metal-Oxide-Semiconductor (MOS) devices and has been highlighted as the most suitable dielectric materials to replace silicon oxide because of its comprehensive performance. In the present research, yttrium-doped HfO2 (YDH) thin films were fabricated using RF magnetron sputter deposition onto Si (100) and quartz with a variable thickness. Cross-sectional scanning electron microscopy coupled with Filmetrics revealed that film thickness values range from 700 A° to 7500 A°. Electrical properties such as AC Resistivity and current-voltage (I-V) characteristics of YDH films were studied. YDH films that were relatively thin (<1500 A°) crystallized in monoclinic phase while thicker films crystallized in cubic phase. The band gap (Eg) of the films was calculated from the optical measurements. The band gap was found to be ∼5.60 eV for monoclinic while it is ∼6.05 eV for cubic phase of YDH films. Frequency dependence of the electrical resistivity (ρac) and the total conductivity of the films were measured. Resistivity decreased (by three orders of magnitude) with increasing frequency from 100 Hz to 1 MHz, attributed due to the hopping mechanism in YDH films. Whereas, while ρac∼1Ω-m at low frequencies (100 Hz), it decreased to ∼ 104 Ω-cm at higher frequencies (1 MHz). Aluminum (Al) metal electrodes were deposited to fabricate a thin film capacitor with YDH layer as dielectric film thereby employing Al-YDH-Si capacitor structure. The results indicate that the capacitance of the films decrease with increasing film thickness. A detailed analysis of the electrical characteristics of YDH films is presented.

3d Printed Impedance Elements By Micro-Dispensing, Ubaldo Robles Dominguez

Open Access Theses & Dissertations

Micro-dispensing allows electric circuits to be "3D printed," which can be used to give 3D printed systems electronic and electromagnetic functionality. The focus of this thesis is using micro-dispensing to fabricate capacitors and inductors. 3D printed impedance elements are capable of being more easily embedded, can be used to create structural electronics, and will have extensive applications in antennas, metamaterials, frequency selective surfaces, and more. This is the first known effort to print and measure impedance elements by micro-dispensing which holds great potential for manufacturing multi-material devices.

Reduction Of Onu Buffering For Pon/Vdsl Hybrid Access Networks, Elliott Ivan Gurrola

Open Access Theses & Dissertations

Today's growing internet traffic requires service providers to offer customers faster transmission rates. To keep up with such high transmission rates, service providers need to deploy fiber optical networks. However, due to the high cost involved in deploying the fiber media, this may not prove to be a feasible solution. Instead, service providers can deploy fiber media up to a distribution point, such as a customer's block, and continue the last few hundred feet using the already deployed legacy copper wire media.

In our study we investigate downstream/upstream transmission coordination for passive optical network (PON) / Digital Subscriber Line (DSL) …

Reduced-Order Modeling Using Orthogonal And Bi-Orthogonal Wavelet Transforms, Miguel Hernandez Iv

Open Access Theses & Dissertations

It is well known that model reduction methods borrow techniques typically found in data compression, and current state-of-the-art techniques for data compression are based on the wavelet transform. Given these facts, it is surprising that model reduction using wavelets has not received much attention and has not been adequately addressed in the literature. This research seeks to determine if wavelets can be used for model reduction and if wavelet model reduction is a viable alternative to existing model reduction methods.

In this work we propose a novel method for model reduction using wavelets. Specifically, we introduce techniques for deriving wavelet …

Efficient, Scalable, Parallel, Matrix-Matrix Multiplication, Enrique Portillo

Open Access Theses & Dissertations

For the past decade, power/energy consumption has become a limiting factor for large-scale and embedded High Performance Computing (HPC) systems. This is especially true for systems that include accelerators, e.g., high-end computing devices, such as Graphics Processing Units (GPUs), with terascale computing capabilities and high power draws that greatly surpass that of multi-core CPUs. Accordingly, improving the node-level power/energy efficiency of an application can have a direct and positive impact on both classes of HPC systems.

The research reported in this thesis explores the use of software techniques to enhance the execution-time and power-consumption performance of applications executed on a …

Asynchronous Logic Design With Increased Fault Tolerance And Optimized For Subthreshold Operation, Ivan Santos

Open Access Theses & Dissertations

Synchronization has always been an essential feature in electronic circuits, in which functionality is achieved by an appropriate flow of data with respect to time. An ideal concept of logic design would require every operation to happen instantly; however, the application of this principle to electronics is governed by the laws of physics, which influence the time to execute a process. In fact, the speed at which a microprocessor can perform logic operations is determined by the time that charging and discharging capacitive loads requires, and the time that electric signals spend when traveling through the circuitry. Consequently, the variation …

Effect Of Hafnium-Incorporation On The Microstructure And Dielectric Properties Of Cobalt Ferrite Ceramics, Stephen Josiah Wells

Open Access Theses & Dissertations

The effect of hafnium ion (Hf⁴⁺) incorporation in cobalt ferrite (CFO) was studied. Samples of Hf substituted CFO ceramic (CoFe_2-xHf_xO₄), were synthesized in the laboratory with hafnium concentrations ranging from x=0.000 to x=0.200. X-ray diffraction scans show that the Hafnium CFO crystalizes in the inverse spinel phase. Inclusion of hafnium causes lattice expansion, increasing the lattice parameter from 8.374 í? for pure CoFe2O4 to 8.391 í? for the highest concentration of hafnium tested (x=0.020). The dielectric properties of CFO are greatly enhanced by inclusion of hafnium. The enhancement is due to the …

Integration Of Memristors With Mems For Dynamic Displacement Control, Sergio Fabian Almeida Loya

Open Access Theses & Dissertations

In recent years the demand for high-speed, lower power consumption and large-capacity non-volatile memories has increased. Promisingly the memristor can be used due to its special characteristic of having memory through resistance change. The memristor behavior is not limited to digital applications but it can be used in analog application as well including: memristors in chaotic circuits, amoeba's learning, neural synaptic emulation, reprogrammable and reconfigurable circuits, and for neuromorphic computers. On the other hand Micro Electro Mechanical Systems (MEMS) are small scale structures that can interact with the physical world due to their mechanical properties. These devices are widely used …

Anasic Design And Test Methodology For An Undergraduate Design And Fabrication Project, Arun Joseph Kurian

Open Access Theses & Dissertations

During the 1990's the main focus of chip design methodologies was on the timings and area constraints. Power consumption was considered significant only after a drastic increase of device densities from 130nm on as well as dramatic increases in sub threshold leakage. As technology advanced from 130nm to 90nm and below there was a significant increase in leakage current due to lower threshold voltage and the influence of the deep submicron effects. High power consumption causes different problems such as increasing the cost of the product, reducing the reliability, reducing the battery life among others. Therefore EDA tools were designed …

Analysis Of Vehicle Interactions On Interstate Highways: Discrete Choice And Linear System Approaches, Alicia Romo

Open Access Theses & Dissertations

The research in this dissertation developed statistical and linear system models to predict driving behavior according to driver attributes, vehicle characteristics, car-following dynamics and/or driving conditions. The scope of this research was limited to the interaction of two vehicles traveling in the same direction on interstate highways.

The statistical models proposed in this research investigated the contributions of the different vehicle types on the manner and likelihood of collision. Discrete choice models were used to estimate the probability of the types of collision (rear-end, angle and sideswipe) as functions of driver attributes, striking and struck vehicle types, pre-crash driving actions …