Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 5 of 5

Full-Text Articles in Engineering

Mems Cantilever Sensor For Thz Photoacoustic Chemical Sensing And Spectroscopy, Nathan E. Glauvitz Dec 2013

Mems Cantilever Sensor For Thz Photoacoustic Chemical Sensing And Spectroscopy, Nathan E. Glauvitz

Theses and Dissertations

Sensitive Microelectromechanical System (MEMS) cantilever designs were modeled, fabricated, and tested to measure the photoacoustic (PA) response of gasses to terahertz (THz) radiation. Surface and bulk micromachining technologies were employed to create the extremely sensitive devices that could detect very small changes in pressure. Fabricated devices were then tested in a custom made THz PA vacuum test chamber where the cantilever deflections caused by the photoacoustic effect were measured with a laser interferometer and iris beam clipped methods. The sensitive cantilever designs achieved a normalized noise equivalent absorption coefficient of 2.83x10-10 cm-1 W Hz-1/2 using a 25 …


A Clamped Dual-Ridged Waveguide Measurement System For The Broadband, Nondestructive Characterization Of Sheet Materials, Milo W. Hyde Iv, Michael J. Havrilla Oct 2013

A Clamped Dual-Ridged Waveguide Measurement System For The Broadband, Nondestructive Characterization Of Sheet Materials, Milo W. Hyde Iv, Michael J. Havrilla

Faculty Publications

A novel two-port probe which uses dual-ridged waveguides for the nondestructive, broadband characterization of sheet materials is presented. The new probe is shown to possess approximately 2 to 3 times the bandwidth of traditional coaxial and rectangular/circular waveguide probe systems while maintaining the structural robustness characteristic of rectangular/circular waveguide probe systems. The theoretical development of the probe is presented, namely, by applying Love’s equivalence theorem and enforcing the continuity of transverse fields at the dual-ridged waveguide apertures, a system of coupled magnetic field integral equations is derived. The system of coupled magnetic field integral equations is solved using the method …


Characterization Of Metal-Insulator-Transition (Mit) Phase Change Materials (Pcm) For Reconfigurable Components, Circuits, And Systems, Brent L. Danner Mar 2013

Characterization Of Metal-Insulator-Transition (Mit) Phase Change Materials (Pcm) For Reconfigurable Components, Circuits, And Systems, Brent L. Danner

Theses and Dissertations

Many microelectromechanical systems (MEMS) use metal contact micro-switches as part of their reconfigurable device design. These devices utilize a mechanical component that can wear down and fail over time. Metal insulator transition (MIT) materials, also known as phase change materials (PCMs), exhibit a reversible transition that can be used to replace the mechanical component in reconfigurable devices. In the presence of a thermal or electric field stimuli, the PCMs will transition back and forth between a crystalline and amorphous state. During this transformation, the resistivity, reflectivity, and Young's modulus of the material drastically change. This research effort focuses on characterizing …


Digitally Programmable Rf Mems Filters With Mechanically Coupled Resonators, Hengky Chandrahalim, Sunil Ashok Bhave Mar 2013

Digitally Programmable Rf Mems Filters With Mechanically Coupled Resonators, Hengky Chandrahalim, Sunil Ashok Bhave

AFIT Patents

A digitally-tunable RF MEMS filter includes a substrate and a plurality of mechanically coupled resonators, wherein a first and a last resonator of the plurality of mechanically coupled resonators are configured to be electrostatically transduced. One or more of the plurality of mechanically coupled resonators are configured to be biased relative to the substrate such that the one or more biased resonators may be brought substantially in contact with the substrate. In a method of digitally tuning an RF MEMS filter having a mechanically coupled resonator array, a DC bias voltage is applied to at least a first resonator and …


Mosaic Imager Using Wave Front Control, Mark T. Gruneisen, Matthew B. Garvin, Raymond C. Dymale, James R. Rotge Mar 2013

Mosaic Imager Using Wave Front Control, Mark T. Gruneisen, Matthew B. Garvin, Raymond C. Dymale, James R. Rotge

AFIT Patents

A wave front control system ("WFCS") organizes the object scene into a mosaic comprised of a grid of segments and transmits each segment in a temporal sequence. The WFCS steers the light fronts emanating from each segment, one segment at a time, through a series of optical components that transmit the light fronts respectively emanating from each segment onto a digital imaging sensor. An optical recording device records each sensed segment, and the object scene is composed by assembling the recorded segments. This abstract is provided to comply with the rules requiring an abstract, and is intended to allow a …