Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 8 of 8

Full-Text Articles in Engineering

Open Source Low-Cost Power Monitoring System, Shane W. Oberloier, Joshua M. Pearce Mar 2019

Open Source Low-Cost Power Monitoring System, Shane W. Oberloier, Joshua M. Pearce

Joshua M. Pearce

This study presents an entirely open-source, low-cost power monitoring system capable of many types of measurements including both loads and supplies such as solar photovoltaic systems. In addition, the system can be fabricated using only open source software and hardware. The design revolves around the Digital Universal Energy Logger (DUEL) Node, which is responsible for reading and properly scaling the voltage and current of a particular load, and then serializing it via an on-board ATTiny85 chip. The configuration of the DUEL node allows for custom sensitivity ranges, and can handle up to 50 A and 300 V. Up to 127 …


Fabricating Ordered 2-D Nano-Structured Arrays Using Nanosphere Lithography, Chenlong Zhang, Sandra Cvetanovic, Joshua M. Pearce Mar 2018

Fabricating Ordered 2-D Nano-Structured Arrays Using Nanosphere Lithography, Chenlong Zhang, Sandra Cvetanovic, Joshua M. Pearce

Joshua M. Pearce

Recent advances in the use of plasmonic metamaterials to improve absorption of light in thin-film solar photovoltaic devices has created a demand for a scalable method of patterning large areas with metal nanostructures deposited in an ordered array. This article describes two methods of fabricating ordered 2D nanosphere colloidal films: spin coating and interface coating. The two methods are compared and parameter optimization discussed. The study reveals that:

• For smaller nanosphere sizes, spin coating is more favorable, while for larger nanospheres, the angled interface coating provides more coverage and uniformity.

• A surfactant-free approach for interface coating is developed …


General Design Procedures For Airport-Based Solar Photovoltaic Systems, Anurag Anurag, Jiemin Zhang, Jephias Gwamuri, Joshua M. Pearce Mar 2018

General Design Procedures For Airport-Based Solar Photovoltaic Systems, Anurag Anurag, Jiemin Zhang, Jephias Gwamuri, Joshua M. Pearce

Joshua M. Pearce

A source of large surface areas for solar photovoltaic (PV) farms that has been largely overlooked in the 13,000 United States of America (U.S.) airports. This paper hopes to enable PV deployments in most airports by providing an approach to overcome the three primary challenges identified by the Federal Aviation Administration (FAA): (1) reflectivity and glare; (2) radar interference; and (3) physical penetration of airspace. First, these challenges and precautions that must be adhered to for safe PV projects deployment at airports are reviewed and summarized. Since one of the core concerns for PV and airport symbiosis is solar panel …


Design Of Post-Consumer Modification Of Standard Solar Modules To Form Large-Area Building-Integrated Photovoltaic Roof Slates, Joshua M. Pearce, Jay Meldrum, Nolan Osborne Mar 2018

Design Of Post-Consumer Modification Of Standard Solar Modules To Form Large-Area Building-Integrated Photovoltaic Roof Slates, Joshua M. Pearce, Jay Meldrum, Nolan Osborne

Joshua M. Pearce

Building-integrated photovoltaic (BIPV) systems have improved aesthetics but generally cost far more than conventional PV systems because of small manufacturing scale. Thus, in the short and medium term, there is a need for a BIPV mounting system that utilizes conventional modules. Such a design is provided here with a novel modification of conventional photovoltaic (PV) modules to allow them to act as BIPV roofing slates. The open-source designs for the mechanical components necessary to provide the post-consumer conversion for a conventional PV module are provided, and prototypes are fabricated and installed on a mock roof system along with control modules …


A Comprehensive Optimized Model For On-Board Solar Photovoltaic System For Plug-In Electric Vehicles: Energy And Economic Impacts, Mahmoud M. Abdelhamid Apr 2016

A Comprehensive Optimized Model For On-Board Solar Photovoltaic System For Plug-In Electric Vehicles: Energy And Economic Impacts, Mahmoud M. Abdelhamid

Mahmoud M Abdelhamid

Environmental concerns along with high energy demand in transportation are leading to major development in sustainable transportation technologies, not the least of which is the utilization of clean energy sources. Solar energy as an auxiliary power source of on-board fuel has not been extensively investigated. This study focuses on the energy and economic aspects of optimizing and hybridizing, the conventional energy path of plug-in electric vehicles (EVs) using solar energy by means of on-board photovoltaic (PV) system as an auxiliary fuel source. This study is novel in that the authors (i) modeled the comprehensive on-board PV system for plug-in EV; …


Research And Development In Roof-Top Solar Potentiality Using Lidar Technology, Radhey Shyam Meena Jun 2015

Research And Development In Roof-Top Solar Potentiality Using Lidar Technology, Radhey Shyam Meena

Radhey Shyam Meena

Energy security and its application is the key for economic growth to any country and state. The conventional generation is also the source of greenhouse gas emission attributing to global warming and has has adverse impact on climate. Therefore, a global shift towards sustainable renewable energy generation is being witnessed. India is blessed with abundant solar energy and if harnessed efficiently, Solar energy is extremely beneficial as it is non polluting and its generation can be decentralized. The state of Rajasthan receives maximum solar radiation Intensity in India with very low average rainfall. It also has desert land available in …


Optimal Design Of A Pv/Fuel Cell Hybrid Power System For The City Of Brest In France, Dr. Adel A. Elbaset Apr 2014

Optimal Design Of A Pv/Fuel Cell Hybrid Power System For The City Of Brest In France, Dr. Adel A. Elbaset

Dr. Adel A. Elbaset

This paper deals with the optimal design of a stand-alone hybrid photovoltaic and fuel cell power system without battery storage to supply the electric load demand of the city of Brest, Western Brittany in France. The proposed optimal design study is focused on economical performance and is mainly based on the loss of the power supply probability concept. The hybrid power system optimal design is based a simulation model developed using HOMER. In this context, a practical load demand profile of Brest city is used with real weather data.


Design, Modeling And Control Strategy Of Pv/Fc Hybrid Power System, Dr. Adel A. Elbaset Jul 2011

Design, Modeling And Control Strategy Of Pv/Fc Hybrid Power System, Dr. Adel A. Elbaset

Dr. Adel A. Elbaset

This paper describes development of a general methodology of an autonomous PV/FC system composed of photovoltaic (PV), electrolyzer, hydrogen storage tank and fuel cell (FC). The aim of this paper is to determine optimum design, control strategy, economic and performance of a PV/FC hybrid power generation system without battery storage taking into account all losses in the system. The paper also presents a computer program based on Matlab software to determine optimum design, control strategy, economic and performance of an autonomous PV/FC hybrid power generation system. The computer program develops to size system components in order to match the load …