Engineering Commons^™

Minimizing Sheet Resistance Of Organic Photovoltaic Cell Top Contact Electrode Layer: Silver Nanowire Concentration Vs. Conductive Polymer Doping Concentration, Caitlyn Cook

Materials Engineering

The top contact electrode layers of nine organic photovoltaic cells were prepared with two varying factors: three Silver nanowire (AgNW) densities deposited on a conductive polymer doped with three concentrations. Silver’s low sheet resistance of 20-Ω/sq is hypothesized to lower the sheet resistance of the anode layer and thus enhance the overall efficiency of the cell. Four-point probe measurements indicated that increasing AgNW density in the top contact electrode layer of an organic photovoltaic cell significantly reduces sheet resistance from 52.2k-Ω/sq to 18.0 Ω/sq. Although an increase in doping concentration of the conductive polymer reduced sheet resistance in low AgNW …

Control System Design, Analysis, And Simulation Of A Photovoltaic Inverter For Unbalanced Load Compensation In A Microgrid, Elizabeth K. Tomaszewski

Electronic Thesis and Dissertation Repository

This thesis presents a control scheme for a single-stage three-phase Photovoltaic (PV) converter with negative sequence load current compensation.

In this thesis a dual virtual impedance active damping technique for an LCL filter is proposed to address the issue of LCL filter resonance. Both inverter-side current and the capacitor current are used in the feedback loop. Using both signals provides higher DC rejection than using capacitor current alone. The proposed active damping scheme results in a faster transient response and higher damping ratio than can be obtained using inverter-side current alone. The feedback gains can be calculated to achieve a …

A Computational Study Of A Photovoltaic Compound Parabolic Concentrator, William M. Vance

Browse all Theses and Dissertations

Routines have been written and added to the Wright State developed solar system simulation program called Solar_PVHFC to model incident solar radiation for a compound parabolic concentrator (CPC) that uses solar panels (photovoltaic panels) to produce electrical energy. Solar_PVHFC is a program that models a solar energy system composed of solar panels to produce electricity from the sun, hydrogen storage tanks to chemically store the energy produced by the solar panels, and fuel cells to convert between electrical and chemical energy when required. Solar_PVHFC features several adjustable parameters to model a solar panel, hydrogen storage, and fuel cell system. Now …

Optimal Techno-Economic Sizing Of Wind/Solar/Battery Hybrid Microgrid System Using The Forever Power Method, Sami Hamed Alalwani

Masters Theses

"Advancement in power electronics, energy storage, control, and renewable energy sources has led to the use of integrated renewable energy sources in islanded microgrids (MG). Also, the uses of integrated renewable energy sources have become more technically applicable, more economically feasible, and more environmentally friendly than conventional sources. As a result, electrification of rural villages using renewable energy technologies has started to become widely adopted around the world. Since generating power from renewable energy sources is highly intermittent and difficult to predict, the use of proper energy storage technology is important to eliminate mismatches between the load demand and generation. …