Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Engineering
12 Volt Wall Outlet For The Dc House Project, Dylan Van Lant, Chenxi Zhang
12 Volt Wall Outlet For The Dc House Project, Dylan Van Lant, Chenxi Zhang
Electrical Engineering
The purpose of this project is to build a DC-DC converter for the wall outlet of the DC House. This report focuses on the development of the DC -DC converter, and explains the design process as well as summarize the final results. The proposed system using the Buck or Step Down topology takes input voltage of 48V and output 12V at 100W. Results show the ability of the converter to fulfill such tasks while maintaining efficiency about 90% at all load.
Dc House Model Design And Construction, Mark Cabaj
Dc House Model Design And Construction, Mark Cabaj
Electrical Engineering
Approximately 1.6 billion people currently live without electricity. The only sensible solution to their energy problems is the use of renewable energy in an off-grid, autonomous home which is powered directly by direct current, rather than alternating current coming from a power line, which probably cannot be found nearby. The purpose of this project is to construct a prototype of the DC House. More specifically, this project focuses on the development and construction of the power distribution system of the DC House. The system will be put in place starting from the source side model down to the load side …
Cell Phone Charger For The Dc House Project, Andrew Hefner, Antonio Magdaleno
Cell Phone Charger For The Dc House Project, Andrew Hefner, Antonio Magdaleno
Electrical Engineering
The goal of this project is to create a multiple output cell phone charger for the DC House project. The cell phone charger is essentially a DC-DC converter. The converter takes an input of 48 volts from the outlet in the DC House and decreases the voltage level to 5 volts; the input voltage level of all cellular devices. By designing an isolated flyback converter with initial specification in LTSpice simulation software, a converter was created. By monitoring the input and output voltage and current using the multi-meters and electronic load, we determined the charger to be 71% efficient when …
Retrofitting A Car Alternator For Low-Speed Power Generation, Yuri Carrillo
Retrofitting A Car Alternator For Low-Speed Power Generation, Yuri Carrillo
Electrical Engineering
This report presents the analysis and methods taken to appropriately modify a car alternator to operate as a low speed generator for wind or hydro power generation. A Toyota car alternator taken from a junkyard is characterized via an Open-Circuit test to evaluate its operating specifications. The car alternator is also measured to determine its physical dimensions. The acquired values are used with the generated voltage equation to determine the machine’s unknown rotor values— the product of the rotor winding factor and the number of rotor windings (kfNf). Using the generated voltage equation with the determined machine parameters, the number …