Engineering Commons^™

Integration Of Antennas And Solar Cells For Autonomous Communication Systems, Maria Jose Roo Ons

Doctoral

Solar energy is becoming an attractive alternative for powering autonomous communication systems. These devices often involve the use of separate photovoltaics and antennas, which demand a compromise in the utilization of the limited space available. This thesis deals with the design, analysis, fabrication and validation of different techniques for the integration of antennas and solar cells in a single multifunctional device. Four different photovoltaic technologies are considered within this work, namely, polycrystalline silicon (poly-Si), monocrystalline (mono-Si) emitter-wrap-through (EWT) rear contact solar cells, amorphous silicon (a-Si) thin film on glass substrate, and bifacial solar cells. The use of a poly-Si solar …

Investigation Of The Slow- And Fast-Light Effect On The Basis Of Stimulated Brillouin Scattering For Application In Optical Communication And Information Systems., Ronny Henker

Doctoral

In today's information age demand for ultra-fast information transfer with ultra-high bandwidths has reached extraordinary levels. Hence, the transmission in the future internet-backbone will be increasingly constrained in the network nodes. At the same time, the power consumption of the network systems will increase to unsustainable levels.

Nowadays, optical signal processing and switching can be implemented relatively easily. However, the realization of optical bu ers and short-term memories is still an unsolved challenge. The slow- and fast-light e ect has been investigated as one solution for the optical bu ering over the last few years. It means the slowing down …

Thermal Robotic Arm Controlled Spraying Via Robotic Arm And Vision System, Dermot Breen

Doctoral

The Tribology Surface Engineering industry is a worldwide multi billion euro industry with significant health and safety risks. The thermal spraying sector of this industry employs the technique of applying molten surface coating material to a substrate via a thermal spray process which is implemented either by manual spraying or pre-programmed robotic systems. The development of autonomous robotic systems for thermal spraying surface coating would significantly improve production and profitability over pre-programmed systems and improve health and safety over manual spraying. The aim of this research was to investigate and develop through software simulation, physical modelling and testing the development …