Engineering Commons^™

Multi-Dimensional Qos And Collaborative Mac Layer Design For Dense, Diverse, And Dynamic Iot Network, Jiyang Bai

Electronic Thesis and Dissertation Repository

With the ubiquitous proliferation of Internet of Thing (IoT) devices, Access Points (APs) of future Wireless Fidelity (Wi-Fi) networks are expected to support dense Stations (STAs) with diverse Quality-of-Service (QoS) requirements under dynamic channel conditions. On account of high access collision and optimization problem complexity, the performance degradation brings new challenges to the existing Media Access Control (MAC) layer design in Wi-Fi. This thesis proposes novel technologies to enable low-latency high-performance MAC layer designs, which support dense access of STAs with real-time solutions of resource allocation and link adaptation problems. Both grouping and collaborative architectures are utilized based on game …

Vertical Free-Swinging Photovoltaic Racking Energy Modeling: A Novel Approach To Agrivoltaics, Koami Soulemane Hayibo, Joshua M. Pearce

Electrical and Computer Engineering Publications

To enable lower-cost building materials, a free-swinging bifacial vertical solar photovoltaic (PV) rack has been proposed, which complies with Canadian building codes and is the lowest capital-cost agrivoltaics rack. The wind force applied to the free-swinging PV, however, causes it to have varying tilt angles depending on the wind speed and direction. No energy performance model accurately describes such a system. To provide a simulation model for the free-swinging PV, where wind speed and direction govern the array tilt angle, this study builds upon the open-source System Advisor Model (SAM) using Python. After the SAM python model is validated, a …

A Novel Method For Determining The Inherent Capabilities Of Computer And Robotic-Assisted Total Knee Arthroplasty Devices, Delaney R.G. Stevens

Electronic Thesis and Dissertation Repository

This thesis presents a method for evaluating and comparing assistive total knee arthroplasty (TKA) devices while controlling surgeon landmarking variability. To achieve consistent landmark selection by surgeons during TKA procedures, the method uses identical 3D-printed knees with indented landmarks. This method was used to compare a robotic and computer-assisted TKA device on three metrics: measurement accuracy, alignment accuracy, and cut-surface uniformity. Although both devices had considerable sagittal plane measurement errors, the robotic device had better measurement and alignment accuracy than the computer-assisted device. Furthermore, the robotic device's measuring error compensated for cutting errors, but the computer-assisted device's compounded them. However, …

Evaluating Eeg–Emg Fusion-Based Classification As A Method For Improving Control Of Wearable Robotic Devices For Upper-Limb Rehabilitation, Jacob G. Tryon

Electronic Thesis and Dissertation Repository

Musculoskeletal disorders are the biggest cause of disability worldwide, and wearable mechatronic rehabilitation devices have been proposed for treatment. However, before widespread adoption, improvements in user control and system adaptability are required. User intention should be detected intuitively, and user-induced changes in system dynamics should be unobtrusively identified and corrected. Developments often focus on model-dependent nonlinear control theory, which is challenging to implement for wearable devices.

One alternative is to incorporate bioelectrical signal-based machine learning into the system, allowing for simpler controller designs to be augmented by supplemental brain (electroencephalography/EEG) and muscle (electromyography/EMG) information. To extract user intention better, sensor …

Nonlinear Adaptive Control Of Drilling Processes, Maksim Faronov

Electronic Thesis and Dissertation Repository

This work deals with the modeling and control of automated drilling operations. Advances in drilling automation are of substantial importance because improvements in drilling control algorithms will result in more efficient drilling, which is beneficial from both economic and environmental points of view. While the primary application of the results is extraction of natural resources, potentially there exists a wide range of applications, including offshore exploration, archaeological research, and automated extraterrestrial mining, where implementation of new methods and control algorithms for drilling processes can bring substantial benefits.

The main contribution of the thesis is development of new methods and algorithms …

Enhancing The Performance Of Nmt Models Using The Data-Based Domain Adaptation Technique For Patent Translation, Maimoonah Ahmed

Electronic Thesis and Dissertation Repository

During today’s age of unparalleled connectivity, language and data have become powerful tools capable of enabling effective communication and cross-cultural collaborations. Neural machine translation (NMT) models are especially capable of leveraging linguistic knowledge and parallel corpora to increase global connectivity and act as a tool for the transmission of knowledge. In this thesis, we apply a data-based domain adaptation technique to fine-tune three pre-existing NMT transformer models with attention mechanisms for the task of patent translation from English to Japanese. Languages, especially in the context of patents, can be very nuanced. A clear understanding of the intended meaning requires comprehensive …

Using Machine Learning To Assist Auditory Processing Evaluation, Hasitha Wimalarathna, Sangamanatha Veeranna, Minh Vu Duong, Chris Allan Prof, Sumit K. Agrawal, Prudence Allen, Jagath Samarabandu, Hanif M. Ladak

Electrical and Computer Engineering Publications

Introduction: Approximately 0.2–5% of school-age children complain of listening difficulties in the absence of hearing loss. These children are often referred to an audiologist for an auditory processing disorder (APD) assessment. Adequate experience and training is necessary to arrive at an accurate diagnosis due to the heterogeneity of the disorder.

Objectives: The main goal of the study was to determine if machine learning (ML) can be used to analyze data from the APD clinical test battery to accurately categorize children with suspected APD into clinical sub-groups, similar to expert labels.

Methods: The study retrospectively collected data from 134 children referred …

Investigation Of Sensorimotor Integration And Control In Parkinson’S Disease Using Haptics-Enabled Robotics And Machine Learning, Yokhesh Krishnasamy Tamilselvam

Electronic Thesis and Dissertation Repository

Non-motor symptoms such as perceptual deficits and cognitive impairments, i.e., deficits in executive functions, presented at an early stage of Parkinson’s Disease (PD) substantially affect a PD patient’s quality of life and may contribute to motor impairments. Studies have emphasized the need to better understand these impairments and the abnormalities contributing to them as it provides a means to efficiently manage the disease. Further, due to the early onset of these deficits, the contributing abnormalities may be considered a potential biomarker for early diagnosis of PD. However, the impairments and the contributing abnormalities are not yet fully understood, leading to …

A Novel Two-Stage Ac-Dc Power Converter With Partial Power Processing, Mina Fakhri

Electronic Thesis and Dissertation Repository

A two-stage power converter with an AC-DC boost converter and a soft-switched DC-DC full-bridge converter is proposed in this thesis. The first stage has two interleaved modules that perform power factor correction; the second stage converts the output of the first stage to the desired output. An auxiliary circuit with a switch, a small transformer, and passive components is used to turn off the AC-DC converter switches with soft-switching; the auxiliary switch can also be turned on and off softly. The secondary of the auxiliary transformer is connected to the output of the overall converter so that some power can …

Exploration Of Force In Movement And Perception In Parkinson’S Disease, Caroline Stefanie Aitken

Electronic Thesis and Dissertation Repository

Parkinson’s Disease (PD) causes force control deficits in upper and lower limbs. About 50% of patients with advanced PD develop freezing of gait (FOG). There is limited research comparing force control in PD with and without FOG, especially in upper limbs. It has been suggested that motor control deficits in PD are related to deficits in kinesthesia, but there is conflicting evidence whether levodopa alleviates kinesthetic deficits. In this thesis, force control was explored using an upper-and-lower-limb haptics-enabled robot in a reaching task, and kinesthesia was investigated using a haptic device in a force discrimination task while participants were on …

Cluster-Based Station Reporting And Multi-Ap Coordination In Wi-Fi Networks, Zeyad Abdelmageid

Electronic Thesis and Dissertation Repository

Due to the few available Wi-Fi channels and the existence of other technologies, the channel selected by an access point (AP) to be assigned to the network is of extreme importance for network performance due to different interference conditions at different channels. While channel selection algorithms have been proposed, very few of them are user-centric, which could incur a large signaling overhead. As a result, in this thesis, a channel selection algorithm with a low-overhead station (STA) reporting mechanism is proposed, which utilizes the spatial correlation of interference by clustering close-by STAs in order to reduce the feedback overhead by …

Identifying Sources Of Error In Computer Navigated Total Knee Arthroplasties Using A Metric On Se(3) And Sensitivity Analyses, Nicole E. Martensson

Electronic Thesis and Dissertation Repository

Throughout the procedure of a computer-navigated total knee arthroplasty (TKA), there are many opportunities for sources of error to be introduced. Identifying these errors can improve surgical outcomes. There is also a lack of accessible methods in available literature for clinicians to perform research in this area using engineering analysis techniques. This thesis aims to provide a greater understanding of the sources of error that can occur pre-bone cut. Possible sources of error include the bony landmark selections and the placement of the cut guide. Using artificial bone models and a 3D point capture system concurrently with a computer-navigation system, …

Anomaly Detection On Partial Point Clouds For The Purpose Of Identifying Damage On The Exterior Of Spacecrafts, Kaitlin T. Hutton

Electronic Thesis and Dissertation Repository

The Canadarm3 is going to operate autonomously aboard the Lunar Gateway space station for the purpose of inspections and repairs. To make the repairs, damage to the spacecraft needs to be detected accurately and automatically. This research investigates methods for training Machine Learning models on 3D point clouds to identify anomalous structural damage. The PointNet algorithm was used to train models on point clouds without affecting their structure. The optimal training data style was found by comparing how well the different styles of data performed at classifying the point cloud testing data. Two different methods of anomaly detection were tested …

Computer Vision-Based Hand Tracking And 3d Reconstruction As A Human-Computer Input Modality With Clinical Application, Tania Banerjee

Electronic Thesis and Dissertation Repository

The recent pandemic has impeded patients with hand injuries from connecting in person with their therapists. To address this challenge and improve hand telerehabilitation, we propose two computer vision-based technologies, photogrammetry and augmented reality as alternative and affordable solutions for visualization and remote monitoring of hand trauma without costly equipment. In this thesis, we extend the application of 3D rendering and virtual reality-based user interface to hand therapy. We compare the performance of four popular photogrammetry software in reconstructing a 3D model of a synthetic human hand from videos captured through a smartphone. The visual quality, reconstruction time and geometric …

Deep Learning For Detection Of Upper And Lower Body Movements, Kyle B. Lacroix

Electronic Thesis and Dissertation Repository

When humans repeat the same motion, the tendons, muscles, and nerves can be damaged, causing repetitive stress injuries (RSI). Symptoms usually begin slowly and become more intense and constant over time. If the motions that lead to RSI are recognized early, these injuries can be prevented. A preventative approach could be implemented in factories to warn workers about possible injuries. By detecting the movements that can cause RSI, the worker can be alerted to stop carrying out those movements. For this purpose, machine learning models can detect human motion with the human activity recognition (HAR) model. HAR models typically require …

Pt-Net: A Multi-Model Machine Learning Approach For Smarter Next-Generation Wearable Tremor Suppression Devices For Parkinson's Disease Tremor, Anas Ibrahim

Electronic Thesis and Dissertation Repository

According to the World Health Organization (WHO), Parkinson's Disease (PD) is the second most common neurodegenerative condition that can cause tremors and other motor and non motor related symptoms. Medication and deep brain stimulation (DBS) are often used to treat tremor; however, medication is not always effective and has adverse effects, and DBS is invasive and carries a significant risk of complications. Wearable tremor suppression devices (WTSDs) have been proposed as a possible alternative, but their effectiveness is limited by the tremor models they use, which introduce a phase delay that decreases the performance of the devices. Additionally, the availability …

Scheduling Electric Vehicle Charging For Grid Load Balancing, Zhixin Han, Katarina Grolinger, Miriam Capretz, Syed Mir

Electrical and Computer Engineering Publications

In recent years, electric vehicles (EVs) have been widely adopted because of their environmental benefits. However, the increasing volume of EVs poses capacity issues for grid operators as simultaneously charging many EVs may result in grid instabilities. Scheduling EV charging for grid load balancing has a potential to prevent load peaks caused by simultaneous EV charging and contribute to balance of supply and demand. This paper proposes a user-preference-based scheduling approach to minimize costs for the user while balancing grid loads. The EV owners benefit by charging when the electricity cost is lower, but still within the user-defined preferred charging …