Engineering Commons^™

On The Modeling Of Bearing Voltage And Current In Pwm Converter-Fed Electric Machines Using Electromagnetic Finite Element Analysis, Peng Han, Yibin Zhang, Murat G. Kesgin, Greg Heins, Dean Patterson, Mark Thiele, Dan M. Ionel

Power and Energy Institute of Kentucky Faculty Publications

Bearing voltages and resulting currents in electric machines driven by PWM converters with fast switching and high dv/dt can cause premature bearing failures. With the transition from conventional Si devices to wide bandgap (WBG) devices and increase in switching frequency, bearing voltages and currents become more significant and need to be addressed from the early design stage. This paper proposes to use coupled field-circuit electromagnetic finite element analysis (FEA) to model bearing voltage and current in electric machines, which takes into account the influence of distributed winding conductors and frequency-dependent winding RL parameters. The three known bearing current types are …

Modeling Of Bearing Voltage In Electric Machines Based On Electromagnetic Fea And Measured Bearing Capacitance, Peng Han, Greg Heins, Dean Patterson, Mark Theile, Dan M. Ionel

Power and Energy Institute of Kentucky Faculty Publications

Bearing voltages and associated bearing currents in electric machines driven by pulsewidth modulation converters with high switching frequencies and high dv/dt can cause premature bearing failures. This article proposes a new modeling approach for the prediction of steady-state and transient bearing voltages based on two-dimensional (2-D) electromagnetic finite element analysis with coupled external circuits using measured bearing capacitance values. The distributed-element external circuit was employed mainly to take into account the influence of wire distribution and frequency dependency, which are typically neglected by traditional equivalent circuits. The developed model was then used to simulate bearing voltages for various scenarios and …

Special Power Electronics Converters And Machine Drives With Wide Band-Gap Devices, Yibin Zhang

Theses and Dissertations--Electrical and Computer Engineering

Power electronic converters play a key role in power generation, storage, and consumption. The major portion of power losses in the converters is dissipated in the semiconductor switching devices. In recent years, new power semiconductors based on wide band-gap (WBG) devices have been increasingly developed and employed in terms of promising merits including the lower on-state resistance, lower turn-on/off energy, higher capable switching frequency, higher temperature tolerance than conventional Si devices. However, WBG devices also brought new challenges including lower fault tolerance, higher system cost, gate driver challenges, and high dv/dt and resulting increased bearing current in electric machines.

This …