Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Reliability Of Sfrp-Strengthened Rc Bridge Columns Subjected To Blast Loads, Ahmad Alsendi, Christopher D. Eamon
Reliability Of Sfrp-Strengthened Rc Bridge Columns Subjected To Blast Loads, Ahmad Alsendi, Christopher D. Eamon
Civil and Environmental Engineering Faculty Research Publications
The reliability of reinforced concrete bridge columns strengthened with externally bonded, steel-fiber reinforced polymer fabric subjected to blast loads was investigated. Columns were modeled with a nonlinear finite element approach that considers material damage, fracture, and separation. Different concrete strengths, longitudinal reinforcement ratios, and gravity and blast load levels were considered, while uncertainties in material strength and stiffness parameters, as well as load characteristics, were incorporated in the probabilistic analysis. It was found that the use of SFRP can allow significant increases in blast load while maintaining the same level of column reliability.
Initial Assessment Of Liquefied Scrap Tire Concrete, Abdulkareem Kuaryouti, Christopher D. Eamon
Initial Assessment Of Liquefied Scrap Tire Concrete, Abdulkareem Kuaryouti, Christopher D. Eamon
Civil and Environmental Engineering Faculty Research Publications
A new approach to incorporate scrap tire material into concrete was investigated, where two reclaimed waste tire components, carbon black and fuel oil, were used to replace a portion of water. The effect of “liquid tire” content to water ratios from 5-40% on an otherwise typical concrete mix were assessed, where compressive and flexural strength, flexural toughness, modulus of elasticity, and several fresh concrete properties were determined. Results were compared to typically expected results of traditional shredded tire mixes with equivalent tire content. It was found that the liquid tire mixes experienced significantly less losses of compressive strength and workability …
Quantitative Resistance Assessment Of Sfrp-Strengthened Rc Bridge Columns Subjected To Blast Loads, Ahmad Alsendi, Christopher D. Eamon
Quantitative Resistance Assessment Of Sfrp-Strengthened Rc Bridge Columns Subjected To Blast Loads, Ahmad Alsendi, Christopher D. Eamon
Civil and Environmental Engineering Faculty Research Publications
The blast resistance of a typical reinforced concrete bridge pier column design was modeled with a nonlinear finite element approach that considers material damage, fracture, and separation. While varying concrete strength, amount of longitudinal reinforcing steel, and gravity load, the effect of applying an externally bonded steel fiber reinforced polymer (SFRP) wrapping was assessed. The presented approach uniquely quantifies column blast resistance in terms of charge weight. It was found that blast capacity was roughly linearly related to concrete strength and steel reinforcement ratio, the former of which is most influential. It was further found that a single layer of …
Reliability-Based Shear Rating Of Prestressed Concrete Bridge Girders Considering Capacity Adjustment Factor, Alaa I. Chehab, Christopher D. Eamon
Reliability-Based Shear Rating Of Prestressed Concrete Bridge Girders Considering Capacity Adjustment Factor, Alaa I. Chehab, Christopher D. Eamon
Civil and Environmental Engineering Faculty Research Publications
In this study, the reliability of prestressed concrete (PC) bridge girders in the shear rating process is quantified, where the use of a simple procedure to enhance the accuracy of shear capacity evaluation for rating is evaluated. It was found that the approximate methods used in code-based procedures to develop shear resistance used for reliability calibration of the AASHTO Bridge Design Specifications and the Manual for Bridge Evaluation result in larger discrepancies in reliability than previously assumed, as well as substantially conservative shear capacity evaluation in most cases. To examine the effects of using a more accurate shear rating process, …