Engineering Commons^™

Benefits Of Pre-Construction Analysis: Cet Senior Capstone Expands Understanding Of An Urban Refuge At Gallopnyc Sunrise Stables, Aalaa Mohammed

Publications and Research

For any construction project, there exists a phase of planning known as “pre-construction.” This initial phase of the project provides a definition of the project, identification of potential issues, planning and scheduling, scope, cost estimation, and analysis of needs for the job. My research analyzes a pre-construction case study conducted for Gallop NYC’s Stable in Howard Beach, Queens. The findings suggest that the practice of construction planning is effective in order to avoid delays in construction itself and ensure successful project completion. Supporting literature examines some of the best practices for pre-construction analysis. These include but are not limited to: …

Riveted Steel Railway Bridge Health Monitoring And Damage Detection, Ahmed Rageh

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

Visual inspection is often used to assess the condition of railway bridges at discrete points in time, an approach that can be subjective and possibly unsafe. Alternatively, certain bridges have their condition assessed via the installation of a large number of sensors. These sensors can be costly to place, power and maintain. Therefore, reducing their numbers and maximizing the extracted information is of utmost importance. In addition, evaluating bridge condition from measured response can be quite challenging due to loading and environmental variations, especially when a limited number of sensors are used.

The focus of this research is to develop …

Evaluation Of Current Repair Criteria For Longitudinal Barrier With Crash Damage, Doug Gabauer, Hampton C. Gabler

Faculty Journal Articles

To protect motorists and avoid tort liability, highway agencies expend considerable resources to repair damaged longitudinal barriers, such as w-beam guardrails. With limited funding available, though, highway agencies are unable to maintain all field-installed systems in the ideal as-built condition. Instead, these agencies focus on repairing only damage that has a detrimental effect on the safety performance of the barrier. The distinction between minor damage and more severe performance-altering damage, however, is not always clear. This paper presents a critical review of current United States (US) and Canadian criteria on whether to repair damaged longitudinal barrier. Barrier repair policies were …

Estimation Of Earthquake Loss Due To Bridge Damage In The St. Louis Metropolitan Area: Part I - Direct Losses, Ronaldo Luna, David J. Hoffman, William T. Lawrence

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

The risk associated with earthquake hazards on highway systems is dependent on the complexity of a network and its redundancy in providing traffic flow. Earthquake loss estimation studies can provide decision makers with an appreciation of the importance of having a highway network resistant to earthquakes and information to make the network resistant to these events. The direct economic loss was estimated for a major metropolitan area, St. Louis, for a series of earthquake scenarios. The primary component of the study was damage to bridges within the highway system. The study zone covers the St. Louis metropolitan area and its …

Estimation Of Earthquake Loss Due To Bridge Damage In The St. Louis Metropolitan Area. Ii: Indirect Losses, David Lee Enke, Chakkaphan Tirasirichai, Ronaldo Luna

Engineering Management and Systems Engineering Faculty Research & Creative Works

An approach to estimate the indirect economic loss due to damaged bridges within the highway system from an earthquake event is presented. The indirect cost considered refers to the increased highway transportation cost only. The study zone covers the St. Louis metropolitan area and its surrounding suburban regions. An earthquake scenario centered in St. Louis, with a magnitude 7.0 is used. The direct earthquake loss was primarily damage to bridges, which causes an increase in travel time and distance within the transportation network. This information is then used as input for the indirect loss model. The indirect loss is examined …

Synthesis Study: Heat Treatment And Its Effects On Rehabilitating Steel Bridges In Indiana, Matthew Lackowski, Amit Varma

JTRP Technical Reports

The literature review of prior heat straightening research indicated that significant research has been conducted on the development of: (i) heat straightening repair techniques and their field implementation, (ii) guidelines and recommendations for heat straightening repair, (iii) empirical procedures for estimating plastic rotations achieved during heat straightening, (iv) empirical procedures for predicting residual stresses caused by heat straightening, and (v) the effects of heat straightening on the structural properties of repaired bridges. Currently, there is a need for additional research on: (a) the fatigue performance of heat straightened beams, (ii) the effects of single and multiple heat straightening on the …

Earthquake Hazard Input For Loss Estimation Study: St. Louis Highway System, Ronaldo Luna, David J. Hoffman, William T. Lawrence

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

The long recurrence period and high consequence earthquakes events in the New Madrid Seismic Zone have caused some federal agencies (e.g., NEHRP, FHWA) to look at the more densely populated areas where higher seismic risk is present. This paper presents the data collection, interpretation, and analysis of the geotechnical information required for an earthquake loss estimation study in St. Louis metro area. The loss estimation study was limited to the highway transportation system, where only the major highways were considered. The project information was processed using a GIS, and the subsequent loss analysis was executed using the HAZUS-MH program.

Damage Analysis Of Jointed Plain Concrete Pavements In Indiana, Part I: Finite Element Modeling And Damage Analysis, Part Ii: Indislab, A Software Tool For Jointed Plain Concrete Pavement Design, Elisa D. Sotelino, Alireza Asgari, Andrew C. Saksa, Guillermo Cedeno

JTRP Technical Reports

Current design procedures for concrete pavements do not account for several factors that can influence their service life. In this work, these factors are investigated and the findings are integrated into a procedure for better predicting longterm performance of concrete pavements. To achieve this, sophisticated finite element techniques are employed and parametric studies are performed. The findings are then integrated into a nonlinear procedure for damage accumulation. In the development of the comprehensive 3D Finite Element (FE) model several issues are studied including the geometry of the model, mesh refinement, element selection, interaction between pavement components, and loading simulation. The …