Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Chemical Engineering

PDF

Brigham Young University

Series

2012

Pyrolysis

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Coal Swelling Model For Pressurized High Particle Heating Rate Pyrolysis Applications, Randy C. Shurtz, Joseph W. Hogge, Kade C. Fowers, Gregory S. Sorensen, Thomas H. Fletcher Jan 2012

Coal Swelling Model For Pressurized High Particle Heating Rate Pyrolysis Applications, Randy C. Shurtz, Joseph W. Hogge, Kade C. Fowers, Gregory S. Sorensen, Thomas H. Fletcher

Faculty Publications

A model was previously developed to describe the decrease in swelling during coal pyrolysis at atmospheric pressure when maximum particle heating rates increase from 104 K/s to 105 K/s. That model included effects of coal type using chemical structure properties. This paper presents results of new experiments to study the effects of elevated pressure and high heating rates on coal pyrolysis. A pressurized flat-flame burner (PFFB) was designed and built to conduct these studies. The pyrolysis experiments reported in this paper were conducted at particle heating rates of ∼105 K/s and maximum gas temperatures of 1700 to 1900 …


Prediction Of Tar And Light Gas During Pyrolysis Of Black Liquor And Biomass, Thomas H. Fletcher, Harland R. Pond, Jarom Webster, Judson Wooters, Larry L. Baxter Jan 2012

Prediction Of Tar And Light Gas During Pyrolysis Of Black Liquor And Biomass, Thomas H. Fletcher, Harland R. Pond, Jarom Webster, Judson Wooters, Larry L. Baxter

Faculty Publications

A generalized model for describing the pyrolysis behavior of low-grade fuels is being developed for incorporation into larger combustion simulation models. Light gas and tar yields from black liquor or biomass pyrolysis can be predicted using the chemical percolation devolatilization (CPD) model originally developed for coal. The initial approach is to measure the average chemical structures in a black liquor sample using 13C NMR spectroscopy. These chemical structures are then used in pyrolysis model predictions. With few changes from the coal-derived kinetic parameters, the model describes the organic pyrolysis behavior of black liquor samples obtained in a nitrogen-purged furnace. It …