Engineering Commons^™

Wing Deflection Analysis Of 3d Printed Wind Tunnel Models, Matthew G. Paul

Master's Theses

This work investigates the feasibility of producing small scale, low aerodynamic loading wind tunnel models, using FDM 3D printing methods, that are both structurally and aerodynamically representative in the wind tunnel. To verify the applicability of this approach, a 2.07% scale model of the NASA CRM was produced, whose wings were manufacturing using a Finite Deposition Modeling 3D printer. Experimental data was compared to numerical simulations to determine percent difference in wake distribution and wingtip deflection for multiple configurations.

Numerical simulation data taken in the form of CFD and FEA was used to validate data taken in the wind tunnel …

Interactions Of A Counter-Rotating Vortex Pair At Multiple Offsets, Kyle Forster, Tracie J. Barber, Sammy Diasinos, Graham Doig

Aerospace Engineering

The interactions between two streamwise vortices were investigated by wind tunnel testing of two NACA0012 vanes at various lateral offsets. One vane was spaced 10 chord lengths (C) downstream of the other, with both at an angle of incidence of 8 degrees and a Reynolds number of 7 x 10⁴. The evolution of the vortex pair was observed until 6.5C behind the downstream vane using Particle Image Velocimetry (PIV). It was found that proximity of the upstream vortex to the downstream vane had a significant effect on the rotational rate of the subsequent vortex pair, with far offset …